This study deals with the technical and economic feasibility of replacing the nuclear power plant reactor Ringhals 3 with a biofuel power plant. A technical investigation has been executed to determine which of the systems and components that could be reused and which ones would need to be replaced. The investment costs of the reconstruction have also been estimated. The cost of the electricity production has been calculated as well as the emissions of the new biofuel power plant. Based on the established rate of return, the lowest average spot price of electricity that makes the investment profitable has been calculated.

När en kommersiell hamn byggs ut fordras omfattande muddringsarbete för att säkerställa ett brukligt djup för sjöfart. Då stora delar av muddermassorna ofta är förorenade av tungmetaller och miljögifter krävs särskilt omhändertagande av dessa. Traditionella omhändertagningsalternativ består av att deponera massorna på särskild avsedd plats på land eller tippa till havs, något som inte tillåts för förorenade sediment. En relativt ny metod är stabilisering/solidifiering (S/S) som innebär att muddermassorna behandlas med ett bindemedel för att sedan kunna användas som fyllnadsmaterial i exempelvis kajkonstruktioner. Dessa alternativ behöver noga vägas mot varandra med hänsyn till ekonomiska och miljömässiga aspekter.

BackgroundA cost that lately has been discussed related to audit is the higher cost for auditing of small stock company. The question is if this cost is higher than the total utility of statutory audit and should it in that case be statutory. SRF says that the condition for small stock companies development is an abolishment of statutory audit. FAR consider that auditing is important for development and continuation.PurposeThe purpose of this paper is to investigate whether there are any winners or losers among auditing firms and accounting firms in Sweden if the statutory audit for small stock companies abolish.MethodThe paper is both a qualitative and a quantitative study that is based on primary data made from an interview and a questionnaire investigation. ConclusionOur conclusion is that the big Winner is the accounting trade.

The purpose of the study is to investigate and elucidate how low-cost airlines can influence and develop tourism in a region. In order to bring about the purpose the author used two research questions. Have low-cost airlines contributed to regional development? How many additional visitors have low-cost airlines contributed to Stockholm? In order to answer these questions a survey was carried out at Arlanda airport and statistics were collected. The results of the study show that there has been a regional development.

TitleEnergy-efficiency ? of slab blocks built in the sixtiesAuthorsRichard Sandahl and Kim SöderbergEducationHalmstad University, Section for economy and technique Construction Engineering 180 ECTSSupervisorMargaretha Borgström, Universitylector construction physics, Halmstad UniversityContact person at HFABUlf Johansson Heating, sanitation and energy co-ordinatorReportExamination paper at the construction engineering program is performed in cooperation with HFAB (Halmstad real estate concern Inc.)AimThis examinations work is done in cooperation with HFAB and there project on the block around the street Maratonvägen. HFAB:s dwelling stock on this area are going through a bigger renovation and in relation to this they are looking on the possibilities to make this building more energy efficient. That is why this examination paper has as purpose to answer the question if it is possible to make slab blocks built in the sixties more energy efficient. This is done by calculate energy efficient measures on a chosen apartment block at Maratonvägen in Halmstad, in an energy and expense perspective.MethodThe examination paper is based on different methods, mainly calculation but also qualitative conversation studies, economic calculations and literature studies.

The technology used in the development of web-applications is evolving at such rate that it has become more and more important to keep web-applications modern. If an application is based on a technical platform that is not renewed, the platform may over time develop into an obstacle in further development of the application. There may be compatibility issues and some of the code may be unnecessary due to abstraction, and therefore more time consuming to work with. Sometimes the reason may be that an application has been built to run, and is running on an application server that is no longer being maintained. The system can be large and modernization can cost a lot.

These studies are done in behalf of Saab AB AVITRONICS in Järfälla in the form of a thesis atthe Royal Institute of Technology in Stockholm.The task was to examine the parameters that plays a role in the construction of modern radomesoperating in broadband applications.This was interesting for Saab to get an indication of which way they should go at the newdevelopment of radomes for the next generation of equipment for electronic warfare.After a thorough analysis of the influencing parameters, a optimization application was made toget a automated way to get a radome design by specifying data on the radome size, airloads,materials, etc.This is to minimise the time of the laborious work that radome development.inply.This was solved by letting ANSYS calculate the strength of the radome structure and MATLABcalculate electromagnetic data and cost models of different sizes and materials.All these parameters woven together with the optimization tool modeFrontier picks data from therespective program and perform an optimization algorithm and then iterate a step and sends thisdata to calculation programs for the new input data. In the end, we have received a convergedpoint with our optimal solution.For the presumptions and limitations for which applied for this thesis, the result was prettyintuitive. That is to say that the smaller radome - the less materal is needed and lowermanufacturing costs results in the cheapest solution possible. The reality is not so simple. Whereyou have to take more of the electrical details such as the effect on the transmitter as a majorfactor..

Background:Life-cycle costing (LCC) is an investment calculation that takes intoaccount operating costs throughout the investee lifecycle. LCC calculations are mainly usedto evaluate investments that have no revenue side. Attempts to apply the LCC calculations forbuilding-related investments have occurred since the 1980s. Despite the advantages ofusing LCC calculations, use has not passed through in full. The main obstacles have beenidentified as a lack of relevant input data, and insufficient experience of workingwith LCC calculations.

In this essay, we have compared a conventional house to a passive house. The housesshared the same local conditions; they have the same living area and the same layout. Thedifferences between the houses were the different construction solutions for the roof, theouter walls, the floor and the heating system. Both the houses qualify the standards fromBBR and the passive house also lives up to FEBY?s special conditions.The purpose with the essay was to examine if it really is profitable to build small hoses aspassive houses.

Background:Life-cycle costing (LCC) is an investment calculation that takes intoaccount operating costs throughout the investee lifecycle. LCC calculations are mainly usedto evaluate investments that have no revenue side. Attempts to apply the LCC calculations forbuilding-related investments have occurred since the 1980s. Despite the advantages ofusing LCC calculations, use has not passed through in full. The main obstacles have beenidentified as a lack of relevant input data, and insufficient experience of workingwith LCC calculations.

Background:Life-cycle costing (LCC) is an investment calculation that takes intoaccount operating costs throughout the investee lifecycle. LCC calculations are mainly usedto evaluate investments that have no revenue side. Attempts to apply the LCC calculations forbuilding-related investments have occurred since the 1980s. Despite the advantages ofusing LCC calculations, use has not passed through in full. The main obstacles have beenidentified as a lack of relevant input data, and insufficient experience of workingwith LCC calculations.

The main purpose of this bachelor thesis is to create a product in the form of a database that can be used for cost estimates of equipment within bio refineries. Through interviews and literature searches the key components and their costs were identified. The database was constructed in Microsoft Excel with different tabs for different categories of components; these tabs are further divided into three parts: one part with costs, one part with calculations and an information part. Most of the part with costs contains the expenses found in scientific papers during the literature study, the calculating part converts different capacities according to user preferences and the currency to euro (?) from 2010 and the information part consists of references and information about what is included in the cost.The database is a good tool for making cost estimates for bio refineries.

Throughout this thesis three main factors have been identified that can be out of significance for transfer pricing in multinational companies if the proposal for Home State Taxation is adopted. These factors are rules for calculation of the tax base, rules for dividing costs over periods and the tax rate. The formula for sharing profits will also become a factor that can have an impact on the European companies'incentives for transfer pricing interacting with above-mentioned factors. The effects of transfer pricing aiming at reducing the total amount of the taxation burden for a group of companies will be strongly reduced in the future if the proposal is adopted. Incentives for transfer pricing will loose importance, though not disappear altogether.

The Göta älv-bridge is a welded steelbridge which is located in Gothenburg,it connects the inner city of Gothenburgwith the island Hisingen. Cracks wasdiscovered in the steel in 1999-2000which started an investigation of thebridge to clearify the condition of thebridge. The conclusion was a monitoringsystem based on laser light sent throughan optical fiber.This report describes the bridge, thedamages, the monitoring system and thetraffic on the bridge.Stefan Pup, at Vectura Borlänge was mysupervisor during this work. In myinvestigation the costs of themonitoring system and the costs ofclosing the bridge is compared andevaluated. The biggest investigatingpart is the costs of closing the bridge.The results of my investigations is thatclosing the Göta älv-bridge would cost 1107 300 SEK / day.

AbstractIt is important to choose which spare parts to keep in stock. With the right spareparts in stock the costs for inventory and production loss will decrease. Cavalieri et al. (2008) highlights that the balance between inventory cost and production loss is underestimated.  It affects the company and must be considered before decision on purchase.The problem with spare engines is that they are all more or less critical for the production. That can be a reason for why no previous research targeting engines and classification of with engine should be kept in stock has been found.