According to recent statistics the construction industry is responsible for the largest waste discharges of both dangerous and non-dangerous waste, when disregarding the "non-dangerous" amount of granite waste produced by the mining industry and the waste produced by the pulp and paper industry. Preventive work within waste management is an ongoing practice so to be able to reduce negative environmental effects. One of the most common actions for the companies to take is to separate the different kinds of waste from one another at the construction site. Although by working with the problem in earlier stages of the process a large amount of the waste could already have been reduced.Companies in the construction business that are actively working to decrease environmental impact in their operations often use an EMS (Environmental Management System). By using environmental management as method the company can manage their environmental work so that actions can be taken where they are needed the most.

The world?s growing need for energy together with a desire to ward off the worst consequences of global climate change has resulted in a never seen desire to invest resources in renewable energy sources. Biogas production through anaerobic digestion is one of those growing energy sources. In Sweden there are over two hundred plants that uses this biological process to break down organic substances while producing carbon dioxide and the energy-rich gas methane.This master?s thesis has focused on development of the mixture of different organic substances that is treated at a specific plant, namely Mosserud biogas plant.

Outside of many Swedish households today, you will find a typical green wastecontainer. This container has not changed since its introduction, despitecomplaints about foul-smelling and its impractical system. Even if the system usedtoday, still is the most optimal choice, there is a lot of newly developedalternatives out there.Its purpose is to get a broader perspective on how a waste management systemcan be developed into a working, land efficiently and aesthetically pleasing systemof humans and the environment in a small residential area.The authors treat the residential area of Jära, Ekhagen, in Jönköping, which ismanaged by JM AB as a problem area in regards to waste management.The issues raised by the authors are the different waste management systems usedin the corresponding areas of the world, how to apply technical andenvironmental as well as the waste management facilities from financial aspects.In the process, the methods used were literature reviews, case studies and aninterview. The case study was done through a modeling of waste managementsystems in the area Jära and an interview was conducted with the company Envacworking with vacuum systems. Studies have been made by different systems n theareas around the world.The results show that using directives and guidance will reduce the environmentalimpact done without replacing the traditional system.

Biogas is a renewable fuel that can be extracted from anaerobic digestion of many differentsubstrates, for example biological household waste. An alternative handling of the waste is tomix it with other wastes and incinerate it in a combined heat and power (CHP) plant. Thisstudy uses life cycle assessment to investigate which type of waste handling that is betterfrom an environmental point of view, anaerobic digestion with biogas production orincineration. The results are based on a case study of a biogas production plant owned by thecompany Ragn-Sells in Vänersborg. The alternative is incineration at a CHP plant inGothenburg.

The management of water resources and waste water varies between the countries of the EU. For many years, a large part of the water in Europe has been contaminated by, among other things, insufficiently treated waste water and emissions from agriculture. The EU Water Framework Directive 2000/60/EC and the Urban Waste Water Directive 91/271/EEC are intended to harmonize fresh-water management and waste water management within the whole EU, aiming at safeguarding drinking water of good quality and a high quality of all water within the EU today and in the future. There are however some problems concerning the waste-water directive. One problem is the huge investment needed in Slovakia to fulfil the demands of the waste-water directive for waste-water management in larger communities (with more than 2000 inhabitants).

This report describes the work of developing a specification of requirements for Waste Heat Recovery Units. The main part of the paper describes how the work with the specification of requirements has been performed. One specific question to be answered is:What are the customer?s demands in case of properties for the Waste Heat Recovery Units and how is that information collected as an order documentation to suit the business area Oil & Gas?The report begins with a description of the assignment and continues with the aim and background. A theoretical part describes the different areas and methods that have been important during the process.

In Sweden, there are limits to how much leachable substances waste must contain in order to be deposited as hazardous waste. Fly ash from waste incineration often end up over the limit, mainly due to the chloride content. Fly ash is therefore often deposited abroad. The purpose of this study was to investigate the possibility to handle fly ash locally. To clarify how the law is applied, environmental reports and permit documents from ten waste sites with permission to deposit fly ash were studied.

All over the world the waste from human society is causing problems. In developing countries, large cities are polluted through huge amounts of wastes and people are forced to live very close to open deposits. Lima, capital of Peru, is no exception. The countryside in Peru has also a great challenge to face concerning the waste issue. Children and adults suffer from infectious diseases and contamination of the nature occurs as well. One solution to handle organic waste is to compost, which means a controlled decomposition of organic waste under aerobic conditions at certain temperatures.

Combustion of fossil fuels is today the dominating source of energy. During combustion,carbon dioxide is formed. The carbon dioxide accumulates in the atmosphere,which raises the global average temperature on earth through the so called greenhouseeffect. The only way to reduce the emissions of carbon dioxide from combustionin a coal fired power plant is through carbon capture and storage (CCS).Post-combustion capture is a technology to separate carbon dioxide from the uegas after the combustion for efficient transport and storage. The steady state operationof coal fired power plants with post combustion capture has already beenthoroughly investigated on a pilot scale, however much work remains to investigatethe plants dynamic operation.

The ?civilized? world is in need of fossil fuel in order to function. Hybricon AB is a company in Umeå that is developing a technology that hopefully can reduce parts of this need. They are currently testing their two electrical busses (with Hybrid backup) in city traffic on the roads of Umeå in cooperation with the county of Umeå.                               The busses are originally diesel-busses, but the diesel motor has been replaced with two electrical hub-motors with a power of 145 kW each that are powered by batteries.The batteries are charged at the end station after each route. In case the batteries should run low on capacity during driving, they can be recharged by the so called genset.

Högbytorp is Ragn-Sells? largest waste facility and it is located north of Stockholm. There is an old landfill still in use, but at the end of this year it will be closed. The waste deposited on the landfill can, through decomposition, give rise to a large amount of methane gas, which is an energy rich gas that can be used for heat and electricity production. To receive a relatively large amount of gas, the decomposition requires a high moisture content in the waste.

This master?s thesis was performed during the fall of 2006 at Cloetta Fazer AB in Ljungsbro. Cloetta Fazer is the market leader in Scandinavia of manufacturing confectionary and chocolates. The purpose of the project has been to identify causes that impact the quantity of waste in production as well as a cost/benefit analysis of the solutions that can reduce the problem of production waste.The work includes four production lines that are individually designed depending on what kind of product that are produced on the line. By using qualitative and quantitative methods such as focus groups, interviews and observations data has been collected.

The goal of this master thesis project was to develop computer models of some plausiblepretreatment techniques and to assess the potential benefits/costs of using pretreatment andanaerobic digestion for waste management of organic waste from a system perspective. Forthis purpose a computer program called ORWARE has been used. ORWARE (organic wasteresearch) is a program for making life cycle assessments of waste management. As the mainpart of the project work the ORWARE system has been provided with three new models ofpretreatment techniques. The additions consist of: One model of pretreatment with ultrasound,one model of thermal hydrolysis and one model of a screw press.

During the past 30 years the fuels for energy production in heating and power plants have changed. Fossil fuels have decreased in usage whereas bio fuels in Sweden have increased with 60% since the 1970's. Different fuels affects combustion and the release of various substances and particles into the flue gas. This is caused by the diverse components and chemical structures of fossil fuels and bio fuels. When the flue gas leave the combustion chamber and enters the path to the chimney particles in the gas are being transported out of the combustion chamber.

Emissions of insufficiently treated wastewater, mainly blackwater (i.e. wastewater from toilets), contributes to the eutrophication of lakes and seas. At the same time, blackwater is a fraction with a low content of heavy metals and, after sanitization, it can recirculate plant nutrients to arable land using the liquid composting treatment method. Liquid composting means that organic material is degraded under aerobic conditions. For sanitization, the blackwater needs to be treated together with energy-rich complementary material.