The low bearing capacity of roads during the spring thaw and periods in the autumn leads every year to increases costs for Holmen Skog. To reduce costs and increase accessibility Holmen Skog decided to install and test a CTI-system. Central tire inflation (CTI) is a system that makes it possible to monitor and vary a vehicle?s tire inflation pressures from the cabin, while the vehicle is in motion. When tire pressures are reduced, the area of the contact surface between the tire and the road increases, thus reducing the ground pressure. The purpose of this study was to evaluate the CTI-equipped vehicle and analyze if the CTI technology is economical defensible during the thaw 2005.

Vehicle simulators are becoming more common in vehicle industries. Company earns lot of money on simulations instead of real tests. Real tests are necessary but not made so extensively as before.In this thesis the building of an vehice simulator will be described and a comparison between three different cruise controls. The three cruise controls are PI-regulator, a regulator who regulates after positions in the terrain and a MPC-regulator. The reason for choosing this three is to see the difference between simple regulation and more complex regulation with respect to fuel consumption, travel time and complexity.The vehicle simulator is made in Matlab/Simulink, Visual Studio and Open Scene Graph.

The capacity to extract information from vehicles has the potential to be very beneficial. Performing analysis on information about fuel usage, emission values and other driving properties of a vehicle can lead to great economic and environmental benefits.This report contains descriptions of two prominent systems for retrieving information of this nature from a vehicle, On-Board Diagnostics and FMS-Standard, and of an implementation of FMS-Standard.The conclusion drawn after this investigation is that these systems do indeed offer access to the benefits mentioned earlier, although to varying degrees and with differing prioritisation..

A study of communication content, frequency and problems was performed at the Swedish Air Force Air Combat Simulation Centre, FLSC. The purpose was to investigate the connection between team communication and performance variables, to study communication problems during air combat and to employ and develop the PILOT method of communication problem analysis. Ten fighter pilots and four fighter controllers engaged in simulated air combat beyond visual range in teams on two sides, Blue and Red, with four pilots and one fighter controller each. Eight such training runs lasting 15 to 25 minutes were analyzed with regard to the Blue team?s communication during launch situations, i.e.

Today's communication solution between the vehicle and trailer is one many see as anon-viable solution, then breakdowns on both the lights and cables are common. Now, anew innovation enters the market, a system that can transmit wireless control signalsbetween the vehicle and trailer.Parvus and Zap, the two solutions that the projekt group has come up with during thisthesis work carried out over the last year on Utvecklingsingenjörsprogrammet.Technologists Peter Jägevall and Christopher Åberg has developed this project on theirown. The group has developed various concepts and chosen to work on, two of them.The project has resulted in this report and a prototypeThe solution that the group has developed is a wireless communication between vehicleand trailer. The project team has developed new power-efficient LED lighting fixtures inorder to implement an internal power source in the trailer. The result of this has becomea maintenance-free and wireless product to trailers.

This Master of Science thesis project handles issues around managing data from the digital tachographsystem. European legislation states that companies must download the data of the digital tachograph systemand store it for at least one year for control purposes. The system stores data on the vehicle unit located inthe driving compartment and on smart cards personal for each driver.Acquiring data from the previous analogue tachograph was done instantaneously since the data wasphysically printed to a circular paper chart when driving. To acquire data from the digital system one mustperform a download from the vehicle unit and later transfer it to some form of backup solution for longterm storage. Data must also be downloaded from the driver smart cards.Download of data from the vehicle unit is the most time consuming task and may take up to 30minutes pervehicle.

Nya typer av krigföring, så som COIN-operationer (Counter insurgency), ställer nya krav på flygstridskrafterna. Utvecklingen av det bemannade stridsflyget har, om man jämför med UAV (Unmanned Aerial Vehicle), trots detta stått relativt stilla. Obemannat stridsflyg har samtidigt utvecklat förmågor som gör funktionen till en värdig konkurrent på det moderna slagfältet. Syftet med denna uppsats är att undersöka huruvida obemannat stridsflyg kan överta det bemannade stridsflygets plats inom ramen för COIN-operationer. Detta avser jag uppnå genom att undersöka hur väl de båda funktionerna svarar uppmot de krav som ställs på ett stridsflygplan i en operation med inslag av COIN.

The purpose of this master thesis is to construct a steering transmission, for a trackedvehicle, containing two hydraulic circuits which are connected. The steeringtransmission should be mechanical to avoid steer-by-wire.BAE Systems Hägglunds has in an earlier study examined a system with two hydraulicpumps and one hydraulic motor, but the safety of the system wasn?t sufficient.To achieve sufficient redundancy there must be two hydraulic motors, which arecontrolled separately. When the two systems are connected in one point, this point is acritical part of the system because it directly affects both circuits. If one of the hydrauliccircuits fails the other should be able to operate independently as a steeringtransmission.

The major part of the existing research on psychological effects on participating in war or residing in a war zone shows negative effects on the person?s mental health. However not all research, from an international perspective, shows the same results. Since we haven?t found any research regarding Swedish conditions and there has been a recent implementation of a decision from the Supreme Commander regarding commanded international service for all staff within the Swedish armed forces, the question has now become more relevant.

At the plant of Sandvik do Brasil in São Paulo there is a need for improving the transport of inserts between the plant building and the stock building. The idea is to install a system with an Automated Guided Vehicle (AGV) to take care of this transportation. The purpose of this report is to present which demands there are on the system and to find the best solution according to the demands.To conclude this work a study was made of the plant and the AGV technology was examined. Several providers of AGV solutions were contacted to get information about prices and detailed solutions.The conclusion was that the most suitable system for this application is a small unit load vehicle using inductive wire as guiding system..

Climate change is a phenomenon that know no boundaries. While focus on environment and climate change has become highly prioritized, nationalism has spread across Europe. Nationalism is by many considered to refuse action to combat climate change although some argue that nationalism could combat global climate change. Previous research on how nationalism is implemented in environment and climate politics has mainly focused on single parties. The thesis therefore aims to give a broad approach and compare how nationalism is used in environment and climate politics by analyzing 4 European parties with either ethnic or civic nationalism and different roles in their party system. With a qualitative content analysis on party programs and election manifestos the findings imply that parties use nationalism in the climate and environment discourse in a variety of ways.

The subject of this bachelors degree project is an interior layout for road ambulances.Landstinget Västernorrland (LVN) wanted a layout concept that would be used to com- municate their design intentions to the ambulance producers during their purchase process.Designing ambulance interiors is an extremely complex process since there so many fac- tors to take into consideration. It ?s not just about taking the equipment and place it where there is space left in the cabin. You have to start with the user in focus and the tasks that are to be performed in the ambulance environment.It ishard to find design solutions that will fit 100% of the ambulance personnel?s working routines for 100% of the tasks.

Good comfort for the driver of a construction machine is crucial. Gearshift comfort is an important part of the total comfort. Volvo Construction Equipment Components has a simulation environment of the powertrain, SimPow, which is implemented in Matlab/Simulink. SimPow is mostly used for simulation of control strategies and performance. In order to be able to study gearshifting comfort, Volvo has an interest in developing new models for SimPow.

Heavy duty vehicles often have problems with traction during the winter periods. For vehicles that can lift tag axles it is possible to increase the normal force on the driven axle by lifting one or more tag axles, this will then increase the propulsive force of friction. This however increases wear on both road and vehicle. A possibility to reduce the wear while achieving nearly equivalent traction compared to lifted tag axles is to allow the vehicle to regulate the normal force by lowering the pressure in the air suspension associated with the tag axles or by the lifting of these axles. The vehicle would then by itself be able to set just the right amount of normal force on the drive wheels to avoid unnecessarily high normal forces while maintaining sufficient traction.The purpose of the report is to find out which parameters affect heavy duty vehicles when driving on slippery slopes and how traction can be improved.

When farm animals are transported there are several factors that can affect their welfare. If the vehicle has an accident the welfare of the animals transported will probably be compromised. The aim of this study was to make a survey of accidents with animal transportation vehicles in Sweden. The survey included the number of accidents from January 2000 to May 2014, the cause of the accidents and how the animal welfare was affected by the accident. The authorities which were likely to have reports about accidents involving animal transports were contacted. There were no collected records about transportation accidents and the authorities referred to eachother for information.