With a growing population on earth the amount of end-of-life vehicles (ELVs) and other scrap steel increases. The European Directive 2000/53/CE? requires a minimum of 95 % reuse and recovery and 85 % re-use and recycling no later than 1 January 2015, for end-of life vehicles. This imposes a need for more efficient recycling and recovery. Despite this shredder residue (SR) is commonly land filled.This report investigated the magnetic fines residue generated at Stena Metall shredder facility in Halmstad, Sweden.

To meet the needs and demands of the costumer, accurate information about how much is available in stock is necessary. When the information in the system does not match the physical inventory, inventory inaccuracy occurs. Inventory inaccuracy is common among companies and may contribute to increased labor cost, excess inventory, production disruptions, waste of time, late deliveries, poor service and lost customers.The purpose of this study is to identify contributing factors to inventory inaccuracy for business with outdoor storage. The study also aims to investigate how efficiency factors can reduce the inventory inaccuracy for business with outdoor storage.A case study was conducted to answer the purpose. A company in the steel industry was chosen to examine inventory inaccuracy on business with outdoor storage.

Lattelement AB in Ornskoldsvik is one of the leading companies in Sweden in composite elements in walls, floors and roofs in particular. The company supplies elements to buildings located with a wide geographical variation, which means that the products are subjected to very different climate with regard to snow, wind and humidity. This places high demands and requires the elements to withstand large variable loads.The elements are made of lightweight beams with flanges of structural timber and beam webs made of OSB. These are bound together by nogging pieces with the same kind of structure. On top of the beams a nailed and glued plywood is added to absorb compressive forces and on the underside of the element a sheet of steel is added for tensile absorption.These elements are then attached to the building framework in different ways depending on the particular element height, loads and the structual supporting material of the frame work.

In this thesis a concept for floor hatches for foam pits has been developed. Since there is an existing solution that is powered by hydraulics and is expensive, the goal was to develop a cheaper solution, as simple as possible.A number of different concepts were developed and evaluated. A concept with five sections that are pulled to the side and stacked on each other was chosen as it was thought to have the lowest risk of crush injuries and to be easiest to manage and control. In the opening behind the foam mattress a lifting table is placed to regulate the height of the stacked sections.To be allowed to be installed in the floor of sports halls the sections must be dimensioned according to the construction standards for these types of buildings. Different dimensions of beams in steel and wood materials were evaluated and of those, who lived up to the requirements of the standard, a concept was chosen.

I detta examensarbete utförs en jämförelse av HSQ-balkar och VKR- pelare i hållfasthetsklass S355 respektive S460. I arbetet dimensioneras profiler anpassade efter studerade fiktiva konstruktioner och ställs emot varandra. Syftet är att optimera profilerna och effektivisera stålanvändningen. Förhoppningen är att en applicering av höghållfast stål i vanliga konstruktioner medför en reducerad stålmängd. Är minskningen tillräckligt stor bidrar denna i sin tur till en mindre miljöpåverkan samt kostnadseffektiva dimensioneringslösningar.Två olika byggnadsstommar utförda i stål med sträckgränsen 355 respektive 460 MPa undersöks.

In this thesis, the Train Power System Simulator (TPSS) has been compared and verified with the commercial simulator TracFeed® Simulation (TracFeed). The basis for the comparison was a given part of the Swedish railway system, with steel transportation trains. Primarily, emphasis was placed on running time and energy consumption in simulation results. Two transformer systems were analyzed, booster and auto transformers. The high voltage transmission line, parallel to the railroad track, was disconnected in some simulations.

Skillingaryds stålrörsindustri AB handles different kinds of steel pipes and got theirmarket mainly in the furniture industry and in department stores. At the momentthe company find themselves in a strong up going course. In a few years thecompany?s turnover has increased with over 10 million SEK. This has led to ademand for structure changes and reorganizing through the company.

District heating covers most of the residential areas and industries in the twoneighbouring Swedish municipalities Nyköping and Oxelösund. In Nyköping,Vattenfall AB Värme produces heat in a bio-fuelled CHP plant. In Oxelösund,waste heat and use of waste gases from the steel production at SSABOxelösund is the basis in the district heating system.This report examines the environmental consequences of a connection betweenthe two district heating systems. A broad system approach is used and the focusis on environmental effects in the system.A system analysis has been performed on the result of simulations of differentheat and electricity production alternatives. The alternatives simulated wereone where Vattenfall Nyköping covers the base load in the joint district heatingsystem and two where the power plant at SSAB Oxelösund supplies the heatbase load.The conclusion in this report is that the consequences of connecting the twodistrict heating systems can be both positive and negative, depending onsystem boundaries and on the environmental focus.

Glulam is a product that was engineered to make use of timber in a more efficient way. Bychoosing timber of similar quality and discarding natural defects during production, thedevelopment of a stronger cross-section is achieved.Carbon fiber is a relatively new material with a high tension capacity. This feature is used toexamine how the bending capacity of the beams improve by adhering carbon fiber laminateson the lower edge of the beamsThe strength of the material is tested with three experiments: carbon fiber on the bottom of thebeam (a), carbon fiber attached to the lower sides of the beam (b) and carbon fiber in thebeam, covered with a layer of wood (c)The results show that the first case, where the carbon fiber is attached to the bottom of thebeam, gave the best result with an increase in capacity of 59 % compared to the nonreinforcedcontrol. The other two cases also show an improvement in capacity, beam-type 3had a capacity increase of 47% and beam-type 4 increased with 25 %Tests were also made with glulam beams reinforced with fiberglass, but these tests were notanalyzed in depth because the purpose was to compare the capacity to carbon fiber. Thisbeam improved its capacity by 40.3%.The tests show that carbon fiber as a reinforcement material for glulam is a good choice whenthere is a requirement for stronger cross-sections in both new production and renovation ofold buildings.

This paper investigates the science fiction novels of Swedish crime writer Per Wahlöö, most famous for his collaboration with his writing partner Maj Sjöwall on the ten Martin Beck mysteries. During two important years, 1964 and 1968, Wahlöö wrote the novels Murder On the 31st Floor and The Steel Spring, set in a near future land ruled by a social fascist power structure where political opposition is eradicated. The pretexted notion of this paper is that these novels consists of extensive quantities of criticism against the Swedish welfare state and the monopoly-capitalistic Swedish press during the sixties. Through the lens of science fiction theory and the notion of the novels as historical sources this paper concludes that PerWahlöö´s science fiction becomes a bridge between the classic Swedish detective novel and the new social critic crime fiction in the style of Sjöwall-Wahlöö and others. The novels are also representations of the historical process in the mid-sixties during the radical turn: the sci-fi novels as social criticism of the contemporary society ? an utopian flare.

With a growing population on earth the amount of end-of-life vehicles (ELVs) and other scrap steel increases. The European Directive 2000/53/CE? requires a minimum of 95 % reuse and recovery and 85 % re-use and recycling no later than 1 January 2015, for end-of life vehicles. This imposes a need for more efficient recycling and recovery. Despite this shredder residue (SR) is commonly land filled.This report investigated the magnetic fines residue generated at Stena Metall shredder facility in Halmstad, Sweden.

This paper investigates the science fiction novels of Swedish crime writer Per Wahlöö, most famous for his collaboration with his writing partner Maj Sjöwall on the ten Martin Beck mysteries. During two important years, 1964 and 1968, Wahlöö wrote the novels Murder On the 31st Floor and The Steel Spring, set in a near future land ruled by a social fascist power structure where political opposition is eradicated. The pretexted notion of this paper is that these novels consists of extensive quantities of criticism against the Swedish welfare state and the monopoly-capitalistic Swedish press during the sixties. Through the lens of science fiction theory and the notion of the novels as historical sources this paper concludes that PerWahlöö´s science fiction becomes a bridge between the classic Swedish detective novel and the new social critic crime fiction in the style of Sjöwall-Wahlöö and others. The novels are also representations of the historical process in the mid-sixties during the radical turn: the sci-fi novels as social criticism of the contemporary society ? an utopian flare.

Mitt syfte med denna studie av Häckelsängsringen är att ta reda på om den verkligen är från vikingatiden samt om den har haft en eds-, rit- eller kultfunktion? Finns det någon vikingatida kult i området som kan komma ifråga när det gäller denna ?mystiska ring?? Till min hjälp har jag tagit litteratur som talar om ringar och eder till exempel de Isländska eddorna. För att se om det finns en vikingatida kult i området har jag besökt Hamrånge socken, både själv och tillsammans med arkeologer. Jag har studerat länsmuseets faktarum och fornminnesregistret. I fornminnesregistret har jag hittat platser såsom en reliklund med mycket gamla lindar, en tänkbar offerkälla, en stenlagd cirkel som kan vara en tingsring samt att i närheten finns ett område som på gamla kartor kallas Lundåker, en tydlig odling av hassel.

This is the project of making a stage design for Batboy ? the musical, a cooporation with a network of musical artists. The aim of the project was to create a space on stage that strengthens and expands the experience of the story told, and find design solutions that give an extra dimension to the story. The prerequisites for my work were partly defined from the produc¬tion, as were my limitations. In the cast of ten artists some were to play more than one role, often one of the opposite sex.

The Goal with this Master of Science thesis is to expand the possible turbine efficiencymeasurements on an exhaust turbocharger. It was done as a part of the CICERO competencecentre. To feed the turbine with air a special flow rig has been used. Instead of loading theturbine by just restricting the compressor flow a docking system for an electrical dynamometer isdesigned to use the dynamometer as an additional loading source. By using an electricaldynamometer as loading device for the turbine, measurements are not depending on compressorperformance.A large part of the work consists in designing accessories for the dynamometer.