Det här arbetet har som syfte att genom en jämförelse av olika analysmetoder för clickstream-data kunna fungera som en vägledning när en metod ska implementeras. Metoden som använts vid jämförelsen är litteraturstudie i och med att de analyseringsmetoder som ska undersökas redan är framtagna och kunskap om dem fås genom att studera litteratur i vilka de förekommer. Ett antal kriterier används sedan vid själva jämförelsen, anledningen till detta är att metoderna ska jämföras utifrån en gemensam grund.De metoder som uppfyllde kraven för de olika kriterierna bäst var page events fact model och subsession fact model. Subsession fact model kan dock upplevas som det bästa valet i alla lägen men samtidigt är den kanske lite överdriven om clickstream-datan bara ska användas till att se hur besökarna använder varje individuell sida för att användas i designsupport syfte. Det går alltså att påvisa att syftet styr vilken metod som är mest lämpad..

When the independent upper secondary schools were started in 1992, it meant a change in the competitive relationship for the local upper secondary schools. A reduced number of students during some years ahead, while the number of independent upper secondary schools increase will probably result in tougher competition between upper secondary schools.The purpose of this study is to review and compare financial and performance management between a public and an independent upper secondary school. The dissertation will focus on the now existing competitive relationship between the two types of upper secondary schools.The theory underlying the study is Porter's model - five competitive forces. The model is applied to the local upper secondary school and used to identify competitive factors affecting upper secondary schools. The study is using a qualitative approach with five interviews at two upper secondary schools, one independent and one public, located in the same town.The comparison of financial and operational management of upper secondary schools indicate that the differences are not as great as we first imagined, but that there still are some differences.

Denna rapport beskriver arbetet med utvecklingen av en ny modell för kaplanturbiner. Utvecklingen bygger på två kopplade differentialekvationer som under arbetets gång anpassats och implementerats i turbinmodellen.Modellen beskriver hur vattenflöde och turbinmoment påverkas av avvikelsen från den optimala kombineringskurvan för vinklarna på turbinens ledskena och löphjul, och är anpassad för ett referensaggregat med tillgängliga provdata. Även övriga enheter i vattenkraftaggregatet modelleras och sätts samman med frekvensregulator och elnät för att simulera aggregatets reglerstabilitet i önätsdrift.Verifieringen av turbinmodellen sker genom försök att återskapa de befintliga verkningsgradskurvorna med hjälp av modellen. Resultatet visar en god följning av de verkliga kurvformerna, dock med något lägre maximal verkningsgrad.Verifieringen av önätmodellen sker genom att prova stabiliteten i nätfrekvens och turbineffekt vid stegpålastningar. Resultatet ger en stabilare reglerstabilitet än i verkligheten, men uppfyller ändå förväntningarna på en fungerande modell.This report describes the development of a new kaplan turbine model.

The fast growing economy of India has experienced fundamental structural changes in recentyears. The share of the service sectors output has more than doubled since 1950 and is todayestimated to make up almost 60 percent of India?s total output. In terms of total employmentwe have not yet seen a similar transformation. The observed discrepancy between sectorialshares of employment and output in the service sector raises questions about sustainability.This report aims to investigate the capacity of the Indian service sector in terms ofemployment creation in order to answer the question whether the recent GDP growth withinthe service sector can be considered as ?jobless? or not.

The main ambition of this degree project is to illustrate the fundamental problems of today?s electric tariff regulation and the usage of the analyzing tool; The Network Tariff Model. There is a further discussion of potential problems and clear improvements of the 2012 years proposed network tariff regulation. Interviews have been conducted with specific network companies and Energimarknadsinspektionen. The proposed regulation of 2012 is discussed from the government?s proposition.This paper clearly shows that the authority´s work has been conducted in a very unprofessional manner during the period of The Network Tariff Model.

For many years, the construction industry in Sweden has not developed much of an integral approach for design across disciplines. The sector?s impact on society, economics and environment is huge. To make the interactions within the construction industry more efficient, a relatively new concept called BIM (Building Information Modeling) has been introduced. The idea with BIM is that the different actors of the construction industry will work through intelligent CAD software, with common file formats and more cooperation between different actors during the various steps of the building and construction process.The technical consultancy company WSP Sweden is working actively to implement BIM within the frame of its activities.

The study proceeds from a phenomenom called co-creation. If value can be created, it is logic to asume that it also can be destroyed. This phenomenom has earlier not been applied to long-term relationships such as business to business. In a business relationship it is important to identify factors, that leads to co-destruction, to be able to prevent them from appering. The purpose of this study is to identify which factors leads towards co-destruction.The study have used theories from Echeverri & Skålén (2011) which has designed a model explaning the outcome of co-creation and co-destruction.

Stockholm is growing with almost two fully loaded SL-buses a day. One of the consequences that derive from this is the increase of public transport travelers who put the regionally governed public transport up to the test in terms of its capacity. The Transport administration in Stockholm County initiated 2015 a project with the purpose of simplifying the calculation of bus stop capacities. A hypothesis (set up by the Transport administration) based on that a model for calculation of bus stop capacities could be calibrated for Stockholm conditions is being researched in this bachelor?s essay.The study is implemented by self-collected traffic data from bus stops located in the Stockholm city center.

When driving hard and cornering on a circuit good control of a car?s roll is desired, so the car reaches steady state quickly but yet in a controlled fashion. This control is mainly given by the combination of the cars springs, shock absorbers and anti-roll bars.The aim of this report is to investigate, analyze and measure a Porsche Boxster?s turn in behaviour and roll dynamics as well as with the aid of simulation results give suggestions for improvement of the previous mentioned combination.Two different simulations were made, one based on a simpler model that was based on an evolved version of the bicycle model in Matlab and one was more advanced model in the simulation software rFactor. Measurements of the real car was made using a GPS-based measurement system.

I have made a research about two different methods for introducing small children to Nursery School/Kindergarten. I choose to do this as I have found very little about this in the literature we have studied during my education to become a pre-school teacher.This period in the life of very small children and their parents is a big change in their daily life. The more traditional way to start pre-school is to do it very gradually during two weeks, the two-week method. This means that the parents visit the pre-school together with their child for a very short time, about one hour the first day. After one week they leave their child with the staff for about an hour and at the end of that week they try to leave it full time (6-8 hours).

Modelling of pollutants is commonly used in research and at departments working with environmental issues. The need to use large amounts of data when modelling creates the opportunity for more generalised models with lower data demands. Aggregating functions into coarser elements is a sort of generalisation of actual features in nature.A development of a method and a modelling tool called ?KadmiumKalkylatorn? has been performed to model cadmium pollution in rivers in Skåne, Sweden. The water runoff has been multiplied with cadmium standard concentrations based on membership in landuse classes.

This thesis has been a part of Forsmarks Kraftgrupp AB's evaluation of a turbulencemodel used in simulation of turbulent flow called PRNS (Partially Resolved NumericalSimulation). This model has promising properties and may be of use in savingcomputational resources. The purpose of this thesis was to analyze this model andcompare it with industrially applied models such as k-omega SST and LES (Large EddySimulations).PRNS works as a hybrid of the k-omega SST and DNS (Direct Numerical Simulation)where a constant, RCP (Resolution Control Parameter) with a value between 0 and 1are selected. This constant is then used in the calculations and determines thebehavior of the simulation. When RCP is set to zero the equation are the same as fora DNS simulation and when RCP is set to one the equations for k-omega SST issolved.

Denna rapport beskriver arbetet med utvecklingen av en ny modell för kaplanturbiner. Utvecklingen bygger på två kopplade differentialekvationer som under arbetets gång anpassats och implementerats i turbinmodellen.Modellen beskriver hur vattenflöde och turbinmoment påverkas av avvikelsen från den optimala kombineringskurvan för vinklarna på turbinens ledskena och löphjul, och är anpassad för ett referensaggregat med tillgängliga provdata. Även övriga enheter i vattenkraftaggregatet modelleras och sätts samman med frekvensregulator och elnät för att simulera aggregatets reglerstabilitet i önätsdrift.Verifieringen av turbinmodellen sker genom försök att återskapa de befintliga verkningsgradskurvorna med hjälp av modellen. Resultatet visar en god följning av de verkliga kurvformerna, dock med något lägre maximal verkningsgrad.Verifieringen av önätmodellen sker genom att prova stabiliteten i nätfrekvens och turbineffekt vid stegpålastningar. Resultatet ger en stabilare reglerstabilitet än i verkligheten, men uppfyller ändå förväntningarna på en fungerande modell.This report describes the development of a new kaplan turbine model.

Geothermal energy can be extracted from an aquifer, where the groundwater is used as heatexchange medium while heat and cold are stored in the surrounding material in the aquiferand to some extent in the groundwater. Application of aquifer storage for the use ofgeothermal energy is mainly used in large scale facilities and is limited to sites with suitableaquifers in the form of ridges, sandstone and limestone aquifers.Löwenströmska hospital in the municipality of Upplands Väsby, north of Stockholm, islocated nearby the northern part of the Stockholm esker. This means that it can be profitableand environmentally beneficial for the hospital to examine the possibilities of aquifer storagein the esker material next to its property.The purpose of this master thesis has been to investigate if geothermal energy storage with aseasonal storage of heat and cold can be applied within Löwenströmska hospital?s propertyarea using groundwater modeling. A hydraulic groundwater model was constructed inMODFLOW based on a simplified conceptual model of the groundwater system.

Lean production is the name given to Toyota?s Production System (TPS) by the west. The continuous improvements of their operations through Lean has made Toyota into the largest car manufacturer in the world. This, in turn, has led to several studies regarding both Toyota and their system as to find ways to apply Lean in other organizations. Even so, over 90 percent of all companies fail to implement Lean.