The decomposition of organic carbon in drained peat soils is a major source of carbon di-oxide in Sweden. A big part of these drained peat soils are used in agriculture and it is a big challenge to slow down their decomposition. It has earlier been thought that less tilling and higher water table levels would decrease the activity of soil microbes and thereby the decomposition, but recent experiments has showed that this has little or no effect. In this bachelor thesis a field experiment was made on drained peat soil with ley, outside Björklinge, Uppsala municipality, Sweden. The experiment was carried out in May 2011. The objective was to develop a method to examine how the net exchange of carbon diox-ide from plant covered peat soil is affected by temperature and photosynthetically active radiation (PAR).

Using the Introductory Carbon Balance Model, ICBM, five different crop rotations with rye 1. Rye-Ley-Ley-Rye-Beans-Rye 2. Rye-Rye-Rapeseed-Rapeseed 3. Rye-Ley-Ley-Rye-Potatoes-Rye 4. Rye-Rye-Potatoes-Wheat 5. Rye-Rye-Potatoes-Beans-Wheat-Rye-Potatoes-Rapeseed were tested theoretically in four different cultivation scenarios ? Straw left on the field, biogas digestate added as fertilizer. Labelled ?+straw+BD?. ? Straw left on the field, only synthetic fertilizer. Labelled ?+straw-BD?. ? Straw harvested, biogas digestate added as fertilizer.

Abstract This degree project examines how much carbon dioxide that emits during the construction phase of a road project. This is to make it possible to compare how the amount of carbon dioxide differentiates between traditional road construction and Swepave construction, which is PEAB?s alternative way to design roads. To make the comparison a calculation tool has been produced. To compare the amount of carbon dioxide emissions a reference project was needed.

The quantity of methane emissions from sheep depend on several factors, for example, the composition of the diet, feed quality, the age of the animals, time of the day and maybe also breed and sex. A comprising literature review was made about which factors that affect the size of emissions. In addition, a questionnaire was sent to two farms, one with a more intensive production system and another with a more extensive system. Inventories of the two farms were made; the rest of the data needed to conduct the study was taken from literature and other sources. Meat produced at the more intensive farm caused emissions of 0.4 kg of methane per kg of bone free meat and the more extensive farm caused emissions of 0.9 kg methane per kg of bone free meat.

Background and problem: In the last few years the threat against the environment and especially the emissions of carbon dioxide has become increasingly debated. The government have set up a goal to lower the emissions of carbon dioxide with 40 percent until 2020 compared to the level in 1990. The emissions in the transportation sector have, in contrast to the total emissions, increased since 1990 and will continue to increase unless powerful control measures are implemented. The lorry centres have to use strategies to answer to these external threats which lead us to the two questions of this thesis: - What methods do the lorry centres use actively and which do they consider as the most important methods for fuel saving? - Are there any differences which methods small, medium and large centres considers as important? Purpose: The main purpose of this thesis is to examine which methods lorry centres use actively and which they consider as important for fuel saving.

Due to global climate change and the rising levels of greenhouse gases (GHG) in the atmosphere, the interest for seeking solutions for mitigation has increased. While much attention has been directed towards technical solutions such as carbon capture and storage (CCS), biogenic carbon sinks has also garnered significant attention. Previous studies have shown that coastal ecosystems such as seagrass meadows and mangroves have a much greater capacity for storing carbon (C) compared to terrestrial ecosystems. That raises the question if other coastal ecosystems, such as coastal wetland forests, that previously haven?t been considered as blue carbon habitats also contribute to coastal carbon sink capacity.

In a column experiment the effect of three different biochars on nitrous gas emissions, nitrogenretention and water filled pore space (WFPS) were studied in a Swedish sandy soil, classified as aCryopsamment. Ammonium retention was positively correlated, while KCl-extractable ammoniumwas negatively correlated, with the specific area of the biochars. The question was raised whether thenegative correlation between extractable ammonium and biochar specific area reflects the amount ofammonium present in the soil or its extractability from the biochar, and whether methods forextracting soil mineral nitrogen, like KCl-extractions, have to be modified for application on biocharamended soils. There was a tendency of increased nitrate retention and KCl-extractable nitrate withbiochar and KCl-extractable nitrate was positively correlated with the specific area of the biochar. pHwas higher for all biochars compared with control, although the differences were not significant, andWFPS was lowered by biochar addition, significantly in one case.

This study includes a life cycle assessment, LCA, on an ecological produced cotton shirt for the company Reflective Circle, which designs ethical and ecological clothes.Initially were cotton farming and textile production studied to gather basic knowledge about the processes. Since this shirt is being ecological produced in the whole production chain, we studied what an ecological production means, but also how a conventional production works. When this was done we could start to discuss the differences and similarities between the production of the shirt and general conventional production.When the LCA was first initiated, the main focus was on the green house gas emissions from the manure at the cultivation. Thereafter the process steps such as picking, ginning, carding, spinning, weaving and sewing were being studied. The picking is done by hand, but the rest of the processes are handed by machines which consumes energy.

Green public procurement (GPP) can be used as an instrument to reduce carbon dioxide emissions, and consideration of environmental aspects within public procurement is becoming more common in Sweden and internationally. Two product groups that have been pointed out as especially important are transports and electricity, where the opportunities for public purchasers to reduce emissions are relatively large. This paper studies GPP which aims at reducing emissions, primarily of carbon dioxide, through environmental requirements within these two product groups. A theoretical analysis of cost-effectiveness, transaction costs and effects on technological development is performed, followed by a closer study of how these aspects appear in practice within GPP. The results indicate that a cost-effective allocation of reductions between the two product groups is most likely to be attained if the main part of emission reduction is achieved through environmental requirements on electricity. The cost for emission reduction within transports is relatively high, especially for heavy transports. For transportation services, more generally focused requirements on emission reductions could probably give greater environmental gains, but the existence of transaction costs steer the environmental requirements towards more technology specific types.

Glulam is a product that was engineered to make use of timber in a more efficient way. Bychoosing timber of similar quality and discarding natural defects during production, thedevelopment of a stronger cross-section is achieved.Carbon fiber is a relatively new material with a high tension capacity. This feature is used toexamine how the bending capacity of the beams improve by adhering carbon fiber laminateson the lower edge of the beamsThe strength of the material is tested with three experiments: carbon fiber on the bottom of thebeam (a), carbon fiber attached to the lower sides of the beam (b) and carbon fiber in thebeam, covered with a layer of wood (c)The results show that the first case, where the carbon fiber is attached to the bottom of thebeam, gave the best result with an increase in capacity of 59 % compared to the nonreinforcedcontrol. The other two cases also show an improvement in capacity, beam-type 3had a capacity increase of 47% and beam-type 4 increased with 25 %Tests were also made with glulam beams reinforced with fiberglass, but these tests were notanalyzed in depth because the purpose was to compare the capacity to carbon fiber. Thisbeam improved its capacity by 40.3%.The tests show that carbon fiber as a reinforcement material for glulam is a good choice whenthere is a requirement for stronger cross-sections in both new production and renovation ofold buildings.

To curb greenhouse gases and mitigate climate change is one of the biggest challenges human society face today. Carbon dioxide (CO2) has accumulated rapidly in the atmosphere as a consequence of burning of fossil fuels and deforestation. The aim of this study is to explore two methods to store carbon dioxide in geological formations and biological sinks. The aim is also to discuss the two mitigation options from a sustainable perspective and whether it can lead to a better environment and benefits for local and global societies. The research questions are: Which method to store carbon dioxide, geological or biological, is the most effective? Which method to store carbon dioxide, geological or biological, has the greatest potential to promote sustainable development for local communities?The method used is a comparative case study and presents four case studies that explore the potential for CO2 storage offshore in Norway and Brazil; and in tropical forests in Mexico and Brazil.

An increased awareness about the global warming has created a demand for more information on how the climate is affected by different activities.This master thesis was initiated by Tricorona, a Swedish company that offers its customers analysis and calculation of their climate impact. Tricorona also supplies climate neutralisation with CERs, in accordance with the Kyoto protocol and controlled by the UN. This work demands updated emission factors for greenhouse gases. An emission factor gives information about the greenhouse gasintensity of a service or a product [kg CO2-eq./ functional unit].The purpose of this thesis is to examine how electricity, district heating, hotels, taxis, food and materials affect the climate and how emission factors for these areas can be calculated.This was done by reviewing and comparing different studies and by interviewing experts. The information was evaluated and recommendations on calculations and emission factors were made.The consumption of energy is the main source of greenhouse gas emissions for district heating, electricity, hotels, taxis and materials.

An increased awareness about the global warming has created a demand for more information on how the climate is affected by different activities.This master thesis was initiated by Tricorona, a Swedish company that offers its customers analysis and calculation of their climate impact. Tricorona also supplies climate neutralisation with CERs, in accordance with the Kyoto protocol and controlled by the UN. This work demands updated emission factors for greenhouse gases. An emission factor gives information about the greenhouse gasintensity of a service or a product [kg CO2-eq./ functional unit].The purpose of this thesis is to examine how electricity, district heating, hotels, taxis, food and materials affect the climate and how emission factors for these areas can be calculated.This was done by reviewing and comparing different studies and by interviewing experts. The information was evaluated and recommendations on calculations and emission factors were made.The consumption of energy is the main source of greenhouse gas emissions for district heating, electricity, hotels, taxis and materials.

This paper deals with the opportunities for the technique of condensation, for wood fired household heaters, on the Swedish market. In this project the condenser is preceded by a scrubber and both energy exchange and separation of unburnt particles have been studied. The facility studied is connected to a wood stove at 30 kW. The tests would show that the effect from the stove never reached above 16 kW. This might be a result of the low temperature of the water going into the stove, from the condenser. In addition to this the wood was not of highest quality and the stove could have needed some maintenance before the tests.

Emission of nitrogen oxides as well as carbon monoxides is an inevitable result of combustion. A Swedish law "Law of environmental fee for emissions of nitrogen oxides as a result of energy production" (lagen om miljöavgift på utsläpp av kväveoxider vid energiproduktion (SFS 1990:613)) controls the emission of NOx from energy production by a system of fees. The system has resulted in a strong approach toward less emissions of NOx among the energy production plants. High emission levels, today exceeding 52 mg/MJsupplied fuel, leads to costs for energy production companies. This paper examines possibilities to reduce the emissions of NOx by optimization of the SNCR-technique in a biofuel fired heat and power plant.