Sverige har en hög andel installerade bergvärmepumpar, som är en typ av vätska-vatten värmepump. Ett problem som finns för befintliga bergvärmesystem är att berget med tiden kyls ned då returslangen till borrhålet konstant levererar kyla till berget. Till följd av detta mister systemet en betydande del av sin verkningsgrad samtidigt som det i extrema fall kan leda till permanent isbildning i borrhålet.Ett sätt att motverka detta problem är att tillämpa termisk energilagring i bergvärmesystemets borrhål. Den internationella benämningen för denna teknik är ?Borehole Thermal Energy Storage, BTES?.Rapporten har behandlat en friliggande enplansvilla med ett befintligt bergvärmesystem som tillämpar termisk energilagring i bergvärmesystemets borrhål med solvärme.

Design of a house requires knowledge of both technology and economics. Heating and ventilation shall be designed, costs are calculated and estimated and requirements must be fulfilled. Which heating system is to be elected is also a difficult choice, especially with rising energy prices as a factor.The choice of energy system is not always given, because it depends on several factors. Below is a comparison between district heating, geothermal heat pump and electric boiler from an economic standpoint. In a previous report appears district heating and geothermal heat pump as the best options.

The student project Elba at KTH started in 2011 and is a project where a battery driven prototype car is developed. The vehicle competes in Eco Shell Marathon in Rotterdam, Holland. In this competition the vehicle that travels a certain distance including several starts and stops with the lowest energy consumption wins. To minimize the consumption is therefore very important, which requires knowledge of the vehicles energy losses.A vehicle's energy losses depends on several factors and can be divided into the powertrain efficiency and the driving resistance. The driving resistance can then be divided in to rolling and air resistance, if smaller losses like vibrations are ignored.

Cooling down the indoor air can be done in several ways. One way is desiccantcooling which will be used at the Stockholm Arena. This method is used in airhandling units that use temperature changes and moisture fluctuations in the air. Oneof the steps is to add heat during the cooling process in order to reduce the relativehumidity of the exhaust air. The air passes thru an adsorptions rotor which thenabsorbs moisture from the supply air.

This study examines the use of building modeling and energy simulations in the design process  of  a  building.  The  take-off  point  is  the  notion  of  energy  simulations  being needed early and throughout the building design process, and that the lack of energy simulations may be explained by the fact that they are time consuming and therefore often too expensive. A greater interoperability between software tools used by relevant disciplines,  such  as  the  architect  and  the  energy  specialist,  would  create  smoother workflows, which would reduce this cost and open up for more frequent and iterative energy  simulation  processes.  The  study  is  an  assessment  of  the  modeling  tool  Revit and  the  simulation  tool  Virtual  Environment  and  whether  they  can  create  smoother workflows, and make leeway for a more frequent use of energy simulations throughout the  design  process.  It  also  investigates  the  limitations  of  what  can  be  examined  by simulations in Virtual Environment. This will hopefully help clarify the future role of energy  simulations  in  design  processes.  The  method  is  a  trial  by  error  approach  of testing the two software tools by building and simulating a model. The results of these tests  show  that  the  workflow  is  not  optimal  (and  therefore  time  consuming)  for frequent  and  iterative simulations  throughout the  design  process,  but  it  also  reveals some  great  possibilities  of  what  can  be  performed  with  these  two  powerful  tools  at hand.  Further  development  with  regards  on  platform  independency  of  the  building information  model,  including  seamless  exporting  and  importing,  seems  necessary  to strengthen the future role of energy simulations..

Fossil fuels are affecting our climate negatively and there is a limited amount of them in the world, which leads to the importance of finding alternative fuels. One alternative is biogas, which is produced though a digestion process of different organic materials in a biogasreactor. Organic substrate that comes from farms has the biggest potential to increase the production of biogas in Sweden. Primarily crops from farms, but also waste products like manure are of great importance.Today there is a calculated theoretical potential for biogasproduction of 14TWh per year, which is around ten times larger than Sweden?s production today.

This thesis is intended to review and create a greater understanding for the history and originsof printed scraps from late eighteenth century to the beginning of the twentieth century.A questionnaire survey was sent out to several Swedish museums, containing questionsconcerning their collections, possible exhibits, special difficulties and types of damagesconcerning scraps and their current storage. A visit to the Gothenburg city museum storagewas made to take a closer look at their scrap collection and how they were stored. Thisresearch resulted in an understanding regarding the current situation of printed scraps, whichunfortunately appears to be quite poor and inattentive. These results are presented in the firstchapter.The second chapter describes the history of printed scraps, followed by a chapter presentingrelevant printing techniques and technology. This is followed by various chapters dealing withhow the printed scrap has been used through the ages, history and development of motifs andthe album's significance.

This thesis investigated the possibilities to resume cultivation of an old manor house built of timber and what this would mean from an energy and moisture perspective. The building in this case study is named Sofiedals mansion and was built in 1858 in Valbo 11 kilometers west of Gävle.The structure of the house was documented and used as a starting-point for carrying out calculations focused on energy and moisture aspects. With the help of a number of computer programs and a conducted air tightness test, the buildings energy consumption were calculated and compared with the current building regulations.In addition, the building was analyzed considering energy retrofitting and what it meant for moisture problems. The energy retrofitting consisted of additional insulation, decreasing the buildings permeability through air sealing; window and door replacements. When a building is equipped with natural ventilation it is difficult to know its precise performance and how an energy retrofitting affects it.

Problems with the current energy system, which partially relies on non-renewable fuels, are increasingly recognized. Emissions of greenhouse gases from fossil fuels may speed up global warming, which in turn leads to a number of negative consequences. Nuclear energy is risky and relies on consumption of a scarce resource. This leads to a demand of renewable energy that is also economically feasible. One possible renewable source of energy is solar energy.

This degree project has been carried out by Niclas Andersson and Sebastian Zwahlen, students of the Innovation and Design Engineering Program at the Faculty of Technology and Science at Karlstad University. The project was carried out during the spring 2010 and includes 22, 5 ETCS credits.Initially the group had contact with the company Mavis möbler AB. Mavis gave the group the task of developing a new bedroom product. To assess the needs and problems of bedroom behaviors, an extensive questionnaire and several interviews were made. This became the starting point for further work.According to the results uncovered during the market research a vast problem was found with temporary clothing storage.

This thesis has been carried out on behalf of IV Produkt AB and intends to set an average ratio of thermal energy losses in apartment buildings that were built during the 1960-1990. This shall be derived by analyzing the total district energy consumption that has been divided into three parts: heat energy losses (the actual heating requirements), the heating of domestic hot water and heating energy consumption for the controlled ventilation.Three different residential areas that were built during the years 1962-1966 and one that was built in 1993 has been analyzed. All residential areas are located in Växjö urban and contains between four and six apartment buildings.The analyzed objects have a mechanical exhaust ventilation systems and district heating as the heating method. No own laboratory work or experiments have been done in this thesis, the calculations have been done on the basis of parameters from VEAB, interviews with property managers, and literature studies. By calculations, we have got a result that is reported in Chapter 6.

This report is of technical character and treats how to plan a small building in Borlänge, Sweden.The technical components that have been treated in the report are the construction, foundation,installations and thermic abilities of the house. In addition to planning this house the report alsocontains a part that deepens in net zero energy buildings. The purpose of the report is toinvestigate if the house in Borlänge can be constructed to meet net zero energy buildingdemands.Energy efficient houses such as passive- and net zero energy houses are showing more frequenton the market in Sweden. Ongoing climate changes and growing consciousness about theenvironment in society have contributed to that the environment is a well discussed topic. Toconsume small amounts of energy and at the same time produce local energy is thereforesomething that lies in the future and future houses.

Self-driving cars are soon to become a reality to the commercial market. A self-driving car does not have a human operator, which enables some interesting characteristics. The main benefits are considered to be:The number of accidents and traffic jams should be reduced.Enhanced comfort.Energy usage could be decreased while capacity could be increased.This study concerns the causes for improved energy efficiency. The reason for improved energy efficiency is mainly because of the variation in terms of acceleration, braking and distance holding are reduced. The vehicles are more intelligent and can work together as a unity.

Hungary?s share of renewable energy in 2010 was 7.9 %, and their renewable energy goal for 2020 is 14.65 %. Geothermal energy is one option that could help to achieve the goal, since Hungary has favorable bedrock, the temperature gradient is above average and thepermeability is high. Today Hungary is importing just over half of its primary energy supply. Because of political conflicts between nations Hungary wants to expand its own production of energy.

This report is the result of a degree project in building engineering, at an advanced level. The project evaluated a building from a technical and historical point of view, and focused on its energy consumption, particularly the energy used for heating. The building in question was a small apartment building in Strömsholm, Sweden. It was made in 1902, from vertical logs, a not so common form of the traditional log house. The goal of the project was to evaluate if the energy consumption could be reduced in accordance with building preservation regulations, that is without damaging any of the building?s cultural or historical values.The building was surveyed with the help of archive and literature studies, interviews and inspections.