Det här arbetet har gått ut på att jämföra två algoritmer för bildbaserad rendering. Båda algoritmerna använder två bilder som spelats in med formatet MultiView plus depth för att rendera nya mellanliggande vyer av en tredimensionell scen. De tvådimensionella bilderna är kompletterade med djupvärden för varje bildpunkt. Renderingen kan då utföras genom perspektivriktiga transformationer där alla bildpunkters nya positioner projiceras individuellt. I samband med renderingen behöver bland annat mätfel i de ursprungliga bilderna samt skymda partier hanteras.

The Multispectral Canopy Reflectance Model (MCRM) by Kuusk (1995) has beenused to simulate the reflectance of a sugarbeet canopy. The simulated reflectancevalues show high absorptance in the VIS area, compared to field measurements, andhigh reflectance values in the NIR area. The errors may be due to overestimation ofclorophyll content in the sugarbeet leaves and scattered light during fieldmeasurements. The estimation of the clorophyll content where carried out using thePROSPECT-model by Jacquemoud & Baret (1990).During the vegetation period, the state of the canopy moves towards a closed canopy,with sparse vegetation in spring. The MCRM-model was used to perform a ?spring?simulation, which was compared to the original simulation.

This report describes an investigation of the indoor climate in two different workspaces. Since we a big part of our lives are staying indoors in artificial environments, and more particularly in our workplaces, we think it would be interesting to do this investigation. The technical solutions for air treatment systems began with simple natural systems without fans and where the thermal rise of the air applied. In modern time is technical air treating systems used to take care of the fresh air supply. This type of units can supply filtered air with the right temperature to the building. Well-functioning ventilation is essential to bring clean fresh air to the room and effectively remove impurities without sound- or draught problems. The indoor climate is relevant for the output capacity.

This study aims to investigate how consumers perceive variety in grocery stores and further how private brands have affected consumers? perceptions of variety in grocery stores.The study focuses on the perceptions and attitudes towards variety and the impact of private brands on perceived variety. Hence, a qualitative rather than quantitative study has been used. Photo elicitation has been used in both focus groups and in-depth interviews, which have been the empirical data collection of the study. Scientific articles and books have also been used in the process.

This essay is a comparative empirical study of ethnic integration mainly of the Russian-speaking minorities in the three Baltic states (Estonia, Latvia and Lithuania) in a post-communism setting. As Lithuania has a Polish minority that is as large as the Russian-speaking, they too shall be included in the study but not as thoroughly as the Russian-speaking minority. Thus the problem is: to what degree are the ethnic minorities integrated with the titular nations in Estonia, Latvia and Lithuania? In order to study ethnic integration I have set up a theoretical framework largely based on Weiner?s theory of integration. The theoretical framework focuses on three dimensions: Citizenship, Identity and Segregation.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

Stabilization of subgrade is an internationally common technique to improve the characteristics of a soft soil. Improving the stiffness and bearing capacity of the subgrade enables the pavement to be designed with reduced depths of subbase and basecourse aggregates. This makes the stabilization technique both economically and environmentally interesting. Both natural and stabilized soils have high inherent property variability that should be considered when the characteristic value is derived. By analyzing the spatial variability in stabilized and natural subgrades it is possible get the parameters needed for reliability?based modeling of soil properties.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

There have been, in some rare cases, difficulties with clamping of inserts with U-holesin their tool holder. According to the complaints, the inserts could not be properlyclamped or could fracture when clamped. A study has shown that variations inclamping behaviour are mainly depending by the position of the screw hole in the toolholder and the centering of the screw hole in the insert.The focus of this project has been the centering of screw hole in insert. It has beenshown that the screw holes are not always enough centered in the insert. Theproblem may occur after a certain step in the production, i.e.

Slutsatsen av studien, som baserar sig på 11 vetenskapliga artiklar, blir att AIMS ökar patientsäkerheten samt bidrar till att tillförlitligheten och kvalitetssäkringen av anestesiologisk dokumentation säkras. Denna slutsats baseras på de gemensamma faktorer som framkommit i resultatet av de artikelgranskningar som genomförts inom ramen för studien. De olika faktorerna är: ? tiden som den anestesiansvarige lägger ned på dokumentation ? brist på korrekt och tillförlitlig registrering av vitala parametrar i anestesijournalen ? utslätning av hemodynamiska värden för att uppnå en försköning av anestesijournalens utseende. ? artefakter ? hjälpmedel vid riskanalyser ? mera korrekt och objektiv rapportering av patientens hemodynamiska data ? utbildning..

The purpose of this study is to find datable interstadial sediments in the core area of the LateWeicheslian ice sheet extent. Based on geomorphological evidence, three coring sites wereidentified close to the Ultevis plateau in Norrbotten, northern Sweden. Sediment coring wascarried out in two pre-Late Weichselian stream channels and in a sediment basin. Stratigraphyfrom one of the sites, a 100 meter wide meltwater channel, was chosen for further analysis. Thestudied core was 5,93 m long and ended in a lower till unit.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.