This master thesis was conducted in order to investigate the effects of the browsing species Yeheb on animal tissues in Swedish landrace goats and to make a literature review in order to increase the knowledge of the importance of this plant for livestock production in Somalia. The evergreen Yeheb bush is a very important feeding source for grazing and browsing animals in Somalia during the dry period. Yeheb contains cordeauxiaquinone that stains the bones of the animals red/pink, which has been an increasing problem when exporting meat to foreign countries. In an experiment, two goats were fed dry and fresh leaves from the Yeheb bush for one and two months, respectively. The goats did not feed the intended amount of dry leaves, since the supply and palatability was not as high as estimated.

This paper describes the work done trying to diminish the noise present in the signal from an IR-detector. The project was aiming towards two different kinds of applications; heat protection and presence detection. The hypothesis was that the signal-noise ratio would decrease if a filter and a proper installation were used for the detector. Some experiments were executed to determine what kind of filter were the most suitable for each application and how these could be installed. After executing the experiments and evaluate the results we recommend to use a specific filter for each application.

On 1 January 2007 abolished Sweden as one of the last countries in EU the wealth tax. This wealth tax was in Sweden for almost 100 years. As the great debate in the context of tax reform in 1910 was not so much about the introduction of a wealth tax. The discussion was instead on the wealth tax would be proportional or progressive together with the income tax.When the government with and there finance minister, Carl Swartz, presented its government bill, 1910:88, 11 March 1910, the draft regulation on income and wealth tax was said, that now they had finally made a shift in the direct tax to the state. A change had been sought and it would have been great difficulties to be overcome and it would have been deeply entrenched ideas about this tax reform impossible.Despite all the protests from the wealthy in society, so continue this conservative government through reform with the strong support of many conservative politicians who had most to lose from this tax reform.

The Swedish building and property management sector are responsible for about 30 % of the total energy use. In order to take environmental consideration, different environmental assessment tools and standards are used. Miljo?byggnad, Svanen, FEBY12 and PHI are some of these. There has been increased interest to certify buildings and therefore it is of interest to evaluate the assessment of the energy field to see if relevant energy aspects are assessed.

Uvån Hagfors Teknologi AB (UHT) has developed a process ? GRANSHOT® ? for quicksolidification of metals in water baths. In the process liquid metal is splintered ? granulated ?into small drops. The drops are rapidly cooled in a water bath where all the heat energy from theliquid metal is transferred into the water.

At Forsmark nuclear power plant a new course called "education in everyday safety" has been started in an attempt to improve the safety culture. The goal is to spread the of expectations and approach the maintenance management has set, to all employees working at the plants. During the course, theory is mixed with practical tasks to reach a common view how work should be done to achieve safety for the plant and the people that work there.The practical tasks are done inside "maintenance simulators". They are built inside 20 ft containers which contains two dummy pipe systems. On the pipe systems some valves, a flow meter and a pump has been installed.

Rapporten handlar om framtagning av användarvänlig konstruktionslösning till en frekvensstyrd filterkärra och görs på uppdrag av Lars-Olof Larsson vid Filterteknik AB i Karlstad. Kursen är Examensarbete högskoleingenjörsexamen i maskinteknik, MSGC17 vid fakulteten för teknik- och naturvetenskap på Karlstads universitet under vårterminen 2014.I detta examensarbete tas en konstruktionslösning fram till en frekvensstyrd filterkärra som är en blivande produkt och ersättare till två tidigare filterkärror. Filterkärrans uppgift är att filtrera olika oljor från vatten och partiklar. En testkörningsprototyp fanns från början och huvudkomponenterna var utvalda. Genom produktutvecklingsprocessens metodik har ett antal prototyper tagits fram och utifrån det har den med bäst lösning valts och arbetats vidare med. Resultatet blev en kärra med samma ramstomme som tidigare liknade kärror.

Lattelement AB in Ornskoldsvik is one of the leading companies in Sweden in composite elements in walls, floors and roofs in particular. The company supplies elements to buildings located with a wide geographical variation, which means that the products are subjected to very different climate with regard to snow, wind and humidity. This places high demands and requires the elements to withstand large variable loads.The elements are made of lightweight beams with flanges of structural timber and beam webs made of OSB. These are bound together by nogging pieces with the same kind of structure. On top of the beams a nailed and glued plywood is added to absorb compressive forces and on the underside of the element a sheet of steel is added for tensile absorption.These elements are then attached to the building framework in different ways depending on the particular element height, loads and the structual supporting material of the frame work.

The thesis investigates if it is possible to replace several pumpimpellers with one controllable pumpimpeller, with a economical and a manufacturing analisys aspect. The studied pumpimpeller is mounted on a midrange wastewaterpump, N3127MT.In the thesis a contemplated manufacturing process is evaluated for a concept that are supposed to act as a controllable pumpimpeller. The pumpimpeller are studied in a manufacturing and flow matter and are presented in the thesis.The manufacturing cost is also estimated, and this has been compared to the storage cost and other costs that the existing pumpimpeller generates.The thesis also shows that the concept has minor losses in cutting quality aswell as the effiency comparing to the existing pumpimpeller.The concept also raises the manufacturing cost and this increasing cost makes the presented concept to expensive to carry through.An investigation of the costs that the existing pumpimpeller produces has also been done, and this shows that there is not that much expenses to earn regarding to for example the storage cost. The storage cost includes information from Flygt?s central storagecenter in Lindas, Sweden and Metz, France, and also an inventory about the pumpimpellers located at Flygt?s different distributors worldwide.The thesis shows that a controllable pumpimpeller will generally increase the cost for the pumpimpeller and the performance of the pumpimpeller will decrease..

This report is the result of a thesis conducted at the consulting firm Bjerking AB andis the final part of the Bachelor Programme in Construction Engineering at Universityof Uppsala. The work aims to investigate the costs and how the choice of ventilationsystem affects building projects during a long-term period. This report covers costssuch as investment, maintenance and energy but also how they affect residents andbuilders. Building regulations for energy consumption are expected to be tougher;therefore a comparison of two different heat recovery ventilation systems(HRV-system) was made. One system is based on a centrally placed unit that coversthe whole buildings ventilation through vertical shafts.

Syftet med arbetet är att få en förståelse för moss-sedumtakets bullerdämpande egenskaper. Jag kommer även att försöka förutsäga med hjälp av akustikteori vilken utav de två olika uppbyggnadssystemen av moss-sedumtak som ger den bästa bullerdämpande effekten.Mätningarna kommer att bestå i att registrera ljudtrycksnivån i rummet, vid varje oktavband i frekvensområdet 125-4000 Hz. Först utan moss-sedummattan och sedan med moss-sedum mattan. Storleken på differensen i ljudnivån ger en bild av i vilket frekvensområde som ljudabsorptionen är effektivast. För att ytterliggare öka förståelsen för hur moss-sedum absorberar ljud så kommer även absorptionsfaktorn att beräknas.

This study explores the effects of two different post-treatment methods on stain reduction in glazed creamware from the late 20th century. The objects stains have been characterized by type one and type two stains which is the result of prolonged contact with food residues, were subjected to the same initial stain reduction. The two post-treatment methods examined are soaking the objects in deionized water and surface rinsing with deionized water. The comparative analysis included photographs under normal and UV-light exposure to assess stain visibility, weight measurements before and after treatments to monitor the absorption and evaporation of liquids, and observations throughout the experiment. The results revealed that while type two stains showed significant alterations after treatments, specifically after soaking, type one stains remained unaffected by both methods.

Distillers? grain is a by-product of ethanol production. Corn, wheat and barley are the grains that are generally used in the distillery process. Distillers? grain is rich in protein and phosphorus.

Problem areaAlfa Laval is a world leading company in the heat transfers area and have the vision to continue to be that in the future as well. The company has a lot of press lines where the utilization is high and also has started to become old. Prognosis shows that there is an increased demand of heat exchanger in the future. This increased demand is not something that existing lines will manage. To build new lines cost a lot of money and take time so it is essential that new lines are correct from the start and not need to be rebuilt or a lot of time spent to trim it.GoalThe goal is to achieve 100% theoretical utilization of the press (the press shall press the amount of plates it is designed for).

Understensho?jden is Stockholm's largest eco-village which was built in the early 1990s with the vision of enabling ecological living for people. However the ecovillage is no longer considered as environmentally friendly because of its relatively high energy consumption, and non-updated energy system. The purpose of this study is therefore to investigate how Understensho?jden should reduce their energy consumption and upgrade its energy system by using Blower-Door, IR-camera and Design Builder.