Användning av CAD-data vid NC-programmering
The degree project is performed at Metso Kamfab. The production is aimed on machines everything from handling of fiber to paper pulp. Metso Fiber and Kamfab are using Pro/Engineer for design and blueprint production. The processing department types the NC-programs in notepad on the basis of the blueprints, the CAD-dates that already is there are not used. The aim with the work is to study if Kamfab can use CAM-system for processing and production of programs for their NC-machines. The objective in this project is to make NC-programs that functions in three special machines.CAD/CAM forms the link between design and production. In a CAD/CAM-system the geometry is created in CAD and can be used directly in CAM for processing. In CAM CL-data is created and after that translated with a postprocessor to NC-code. The postprocessor is used also as a watch over function.Three machines were chosen as experiment items for introducing of CAD/CAM. These are a 7-axis mill, a combined mill/turn and a 3-axis mill. The 7-axis mill and the mill/turn were chosen because they are the most advanced machines. The 3-axis mill was chosen because there was available time in it. Products that were tested were trough, pillar, housing and a part for a toolchanger.When processing the trough ?Surface-Mill? was chosen and a lead-angle was set in the parameters. It was most drilling and a little face milling on both the pillar and the housing.In order to test programs a postprocessor was borrowed that translated CL-data to Heidenhain code. During the test run errors were detected in the programs. This depends on that the postprocessor not where customized for the machine. A postprocessor developed by ourselves was also tested, this one didn?t work because the machine's NC-system couldn?t read ISO standard code.A study visit was done at Structo in Kristinehamn where EdgeCAM is used for NC-processing. It works well and it allows quicker and safer programming.Pro/Engineer is powerful and has a lot of possible adjustments. This makes it complex and takes time to learn. To use Pro/Engineer´s CAM-part it is necessary to have basic knowledge about the CAD-part. Depending on this many companies uses for example EdgeCAM that almost is a pure CAM-system.The processing of the three components functioned well in Pro/Engineer, we could process the components after demands. The problem was to get working programs. An advantage with using CAM is that you can simulate toolpaths. Through this you can see if the tool collides and it also makes it possible to optimize toolpaths. Today, it is a lot of waiting time in the milling machine FPT34 because programs are not completed. This waiting time would be reduced or even eliminated with the aid of CAM.