Sewer Trenches usually contain material with a higher hydraulic conductivity then the adjacent soil. Thus they can serve as paths of preferential flow in a polluted area. Wastewater from factories can also leak from wastewater pipes and pollute the soil in the sewer Trenches.The purpose of this project was to investigate pollutions in sewer Trenches and in sewer pipes in the industrial area of Köpmanholmen, 20 km south of Örnsköldsvik in the north of Sweden. To make an estimation concerning the potential of transport of pollutions in sewer Trenches, hydrological calculations were performed.Leakage to any greater extent did not seem to be a problem in the area. This is the case both for the concrete and the wooden pipes that have served as factory wastewater pipes.

This is a diploma thesis executed as a part of the examination of the educationalprogram Building engineer ? Construction management at Halmstad University. The aim of the thesis is to compare and evaluate conventional open-cut pipe-laying withhorizontal directional drilling. The thesis includes a comparison of the economic,environmental and time-based aspects of both methods and discusses which factorsthat determine the optimal choice of method.The study is mainly based on previous studies regarding the subject and oninterviews with professionals from the industry.A fictional project with five realistic cases of pipe-laying scenarios was compiled,sent to different companies for calculation, evaluated and compared. Our conclusionregarding when it?s suitable to use which method is entirely dependent on thespecific project.

Slopes in fine till soils are exposed to surface erosion due to rainfall, snowmelt and upland water sources. Large areas of road slopes are therefore covered for surface erosion protection. Preventive methods like ditches and Trenches are also being used. Silt tills are particularly troublesome since the water can bring the soil into suspension and cause mudslides. Different methods for erosion protection have been studied in this work, with the emphasis placed on rockfill covering. The need for and the dimensioning of this type of covering has been examined in literature and field studies.

A growing issue in the construction industry is how production can become moreefficient by using logistical solutions. Companies can minimize the cost of a project byreducing the time to perform the work.The purpose of this report was to examine the logistics related to pipe Trenches forSIAAB. The report's focus has been on solving problems and planning that wouldfacilitate the work of the project Vaksala-Lunda Etapp 3.The case study consists of interviews with SIAAB's employees and an observationwhere the progress of a traditional pipe trench has been documented using checklists.Questions to the report?s case study come from the theoretical part, which is basedon literature on construction management and logistics in general. The observationlasted five weeks and the biggest time-consuming events that affected the pipe trenchduring this time, has received most attention.

Lower energy use in buildings is a result of increasingly stringent energy requirements across Europe. When conventional district heating technology is used in areas with low energy consumption heatlosses do not fall even though the amount of energy delivered is reduced. This reduces income for thedistrict heating company. To maintain their economic viability the district heating companies? majorchallenge is to implement new solutions that minimize heat loss.