The purpose of this literature review was to describe the paths of exposure and accumulation of organic Pollutants into the tissues of farm animals. Organic Pollutants can be spread in the environment by air and rainwater. Farm animals can be exposed to these Pollutants for example by eating soil or contaminated plants. Many of the Pollutants can then accumulate in the fat tissues of the body because of their lipophilic character. Brominated flame retardants and perfluorolated compounds are both Pollutants of current interest.

That air Pollutants of different kind has impact on our climate can hardly haveavoided anyone during the past years environment explosion in the media. But howis it actually with the reverse, i. e. the climate's impact on air Pollutants? The aimwith our degree thesis is to try to find out if different weather factors, statisticallyseen, promotes atmospheric Pollutants and particles in the air and vice versa.We got access to data on air Pollutants and weather factors that was registeredduring year 2007 at Femmanhusets air pollutant and weather station in Gothenburg.In order to do a statistical investigation of these data, and to be able to analyze if itoccurs relations of various kind, we used the statistics program SPSS.

Total organic carbon (TOC) and chemical oxygen demand (COD) are two methods used for measuring organic Pollutants in wastewater. Both methods are widely used but the COD method results in production of hazardous wastes, including mercury.The purpose of this study was to validate the method TOC that will replace COD and find a factor to convert TOC to COD. In this study 26 samples were analyzed from four sewage treatment plant in the municipality of Enköping.The results show that the COD method could be replaced by the TOC method.The factor for COD/TOC was between 3.1 - 3.3. Both methods will be used in parallel until 2013 when it will be forbidden to use the COD analysis..

The main purpose with the project has been to approximate the magnitude of the pollution transport from the actual road surfaces and to get an approximation of the possibility to collect the Pollutants to reduce the load to the water and improve the water quality.The quantity of pollution transport from the most trafficated roads areas in Örebro city has been calculated. Roads whith a traffic exceeding 10 000 vehicle/day. The study has been done with the calculation tool StormTac. Through analysis of traffic loads and road surface, which together with a different kinds of parameters gives an approximation of the pollutant transport.The calculation has included some metals and other substances in the stormwater and has also included the present of suspended solids. Included the overall study, some smaller areas has also been calculated for the possibility to remove Pollutants.The work also includes calculation for three different areas for stormwater treatment.

The river Göta Älv reaches between Vänern and Gothenburg and is the main raw water source for Gothenburg that supplies about 700 000 people with water. To protect and maintain a high water quality, continuously samples and water analyses are made throughout the river. In 1998 a protection area was founded between surte and Lärjeholm where the raw water intake is. This was made to increase the awareness of the importance to protect the water. However, there is a lot of contribution of untreated stormwater to Göta Älv within the protection area.Göteborg Water and Sewage Works commissioned this thesis where two areas, Tagene industrial area and Kärra residential area, with untreated stormwater outlets within the protection area are studied.

Sewer trenches usually contain material with a higher hydraulic conductivity then the adjacent soil. Thus they can serve as paths of preferential flow in a polluted area. Wastewater from factories can also leak from wastewater pipes and pollute the soil in the sewer trenches.The purpose of this project was to investigate pollutions in sewer trenches and in sewer pipes in the industrial area of Köpmanholmen, 20 km south of Örnsköldsvik in the north of Sweden. To make an estimation concerning the potential of transport of pollutions in sewer trenches, hydrological calculations were performed.Leakage to any greater extent did not seem to be a problem in the area. This is the case both for the concrete and the wooden pipes that have served as factory wastewater pipes.

Using leaching test is a way to get a picture of Pollutants retention and leaching in a risk assessment on contaminated land. There are several different types of standardised leaching tests today, where the natural leaching processes are speeded up to make it possible to predict the leaching of Pollutants. These leaching tests have been developed for waste and there are no specific guidelines on how to judge the results from the tests, when making a risk assessment on contaminated land. This work is an investigation on how to use leaching test in this type of risk assessments. The strengths and weaknesses of the different types of tests are discussed. Depending on what type of information you want from your leaching test, different types of tests are suitable.

Phytoremediation is a technique using the ability of plants to absorb Pollutants in their biomass from contaminated soils and remediate it. The plants are then harvested and the soil gets purified. This method is more environmental-friendly than the normally used methods for soil remediation. Glasriket in Småland is an area with large amount of Pollutants including arsenic, cadmium and lead. This area must be cleaned from these metals because of the high threat to the environment ant the health of people who live here.

Small pieces of plastic, termed ?micro plastic? in the oceans derive mainly from degradation of big plastics such as beach littering, but also from sources of direct emission from e.g. beauty scrubbers and synthetic sand-blasting. These micro plastics are ingested by marine animals ? mistaking them for plankton ? or via prey.

In the next few years the Pollutants loading at the Slottshagen wastewater treatment plant in Norrköping is going to increase due to the reason that one of the waste water treatment plant in the district will be shut down.A survey of how these different Pollutants are divided in the treatment process is therefore necessary for mapping out both the loading and treatment efficiency.This can be achieved by studying mass balances.Mass balances were carried out for the water treatment process for the mechanical/chemical,biological and the chemical stage.The mass balance studies show that the treatment efficiency was very good. However in order for the mass balances to be quite consistent and to ensure complete coverage of results and conclusions i.e. more reliable results, sludge samples should be collected and taken at different times per day and the influent rate should be investigated.In this work mass balance has been set up in order to illustrate and identify the factors that should be considered and taken care of for further estimation using mass balances in the future. Furthermore this survey results in a calculating model for the mass balances at thisplant.This calculating model is used as a tool to facilitate future calculations for mass balances for the water treatment process at Slottshagens wastewater treatment plant.Moreover it provides a basis for carrying out further estimation of the treatment process in the near future.In this project the importance of some operating parameters was also taken in consideration.This calculating model can be modified so that calculations of such operating parameters i.e. sludge loading and sludge age can be easily performed.Such information can be used further to evaluate different operation alternative in order to ensure an optimal use of the treatment process with in the plant..

Every year, pesticides are found in surface and ground waters in Sweden. Fungicides are in common usage and applied in high amounts against potato late blight. The present thesis examined the possible removal of four fungicides (metalaxyl, cyprodinil, propamocarb and mandipropamid) from water using the microalgae Chlorella vulgaris. Microorganisms are capable of decomposing a range of organic Pollutants and the main focus in previously published studies has been on bacteria and fungi. Microalgae are mostly studied due to their high capacity in biosorbing heavy metals.

Discharge of inadequately treated waste water containing nutrients such as phosphorus and nitrogen as well as organic matter and bacteria is associated with a risk of eutrophication and contamination. The Swedish government has decided upon several Environmental Quality Objectives aiming to reduce the emissions of nutrients to water bodies.In Sweden, there are between 675 000 to 1 000 000 on-site sewage systems. Recent studies have shown that the function of small sewage treatment plants is in many cases insufficient. To prevent this regular service and supervision by a professional is needed. The focus of this study are small sewage treatment plants which use a technique where mechanical, chemical and/or biological reduction of Pollutants is being used in the same facility to reduce nutrients in household wastewater.The aim of the study is to investigate how different municipalities ensure that small sewage treatment plants fulfill the requirements and reduce Pollutants as efficient as the manufacturers claim.

Modelling of Pollutants is commonly used in research and at departments working with environmental issues. The need to use large amounts of data when modelling creates the opportunity for more generalised models with lower data demands. Aggregating functions into coarser elements is a sort of generalisation of actual features in nature.A development of a method and a modelling tool called ?KadmiumKalkylatorn? has been performed to model cadmium pollution in rivers in Skåne, Sweden. The water runoff has been multiplied with cadmium standard concentrations based on membership in landuse classes.

This work consists of a survey and risk classification of eleven metal industries including foundries, finishers and engineering industries in two industrial areas in Mora. The study follows a method called MIFO (Method of Surveying Contaminated Sites) composed by the Swedish Environmental Protection Agency. In the method assessments of the degree of hazard posed by the Pollutants, the level of pollution, the conditions of dispersal, sensitivity and the degree to which the area is worthy to protect are made for each contaminated site (object). The assessment classify the objects into four risk classes in which risk class 1 denotes a very large risk, 2 large risk, 3 moderate risk and risk class 4 little risk. The work of surveying using MIFO is divided into two phases.

The construction of buildings and paved surfaces changes the natural water balance.Precipitation generates surface runoff and storm water instead of infiltrating into the soil.Storm water has come to be considered as a major source of pollution in lakes and streams inthe vicinity of urban areas. Reduction of Pollutants in storm water is a key action in order toprotect sensitive recipients and maintain high water quality. Storm water is traditionallytransported by storm sewers to the nearest recipient. In recent years the approach to stormwater management has changed; storm water should primarily be disposed of on site, throughlocal disposal of storm water, LOD. LOD is created by a combination of the function ofseveral smaller local facilities and the general sewer system.