Denna studie avser att ge information och vägledning vid val av angreppssätt vid ett integrationsprojekt. Med angreppssätt avses facelift och Convert som kan jämföras med Enterprise Application Integration (EAI) och Enterprise Resource Planning (ERP). Det är idag en avsaknad på material angående val av angreppssätt vilket kan försvåra för en organisation att veta hur de skall angripa ett integrationsprojekt. Att genomföra denna undersökning är steg mot att ge organisationer vägledning om hur de skall angripa ett integrationsprojekt och vad som är viktigt att tänka på. Denna studie tar hänsyn till att integrera antingen genom att integrera existerande system med hjälp av middleware (facelift) eller att byta ut de existerande systemen mot ett ERP-system (Convert).

The Swedish government has proposed that 20 % of the cultivated land in Sweden should be organic by the year 2010 (The Swedish Board of Agriculture, 2008). In addition to this the production of organic food like milk, meat and egg should increase considerably. To reach the government?s goal it is necessary that the Swedish farmers get motivated to Convert their production from conventional to organic. Milko is a dairy association that has chosen to focus on organic products, they want to be the leading organic dairy association, and therefore they have a large need for organic milk (Milko, 2008).

This thesis has been written at Linköping University for the company Instrument Control Sweden AB (ICS).ICS is a small company located in Linköping that develops software and hardware for Unmanned Aerial Vehicles, UAV. At present, ICS has a fully functional autopilot called EasyPilot but they want to reduce the autopilot?s size to make it more attractive.The purpose of this thesis was to investigate if it was possible to reduce the size of the autopilot and how, in that case, it would be done. It was also necessary to examine whether the old processors should be replaced by new ones and how hard it would be to Convert the old software to these new processors.To succeed with the goals many of the old components had to be changed for new, smaller ones. Some less necessary parts were also completely removed.

To understand the motives, and perhaps more importantly the barriers, for farmers to Convert from conventional to organic farming is of great interest for policy makers as well as for academics. In Sweden and in other EU countries, proposed targets of the area in organic farmland have failed to be reached in spite of different kinds of policy measures. Most studies agree that the average profitability seems to be comparable to or better in organic than in conventional farming. This would indicate that there must be other factors of importance which can explain the low particiapation rate. A higher perceived risk in organic farming with respect to yield and price is frequently brought up as a potential explanation within a qualitative framework.

Solar energy is the one most talked about among energy sources due to its huge potential amongst renewable energy technologies. A greater use of the solar energy may be the solution to today's climate threats. Normally there are two different types of solar technologies, solar cells and solar thermal collectors. Solar cells Convert solar energy in to electricity whilst solar thermal collectors Convert solar energy into heat, which can be used to heat hot water for households. This goal of this study has been to investigate the possibility of implementing solar energy into the energy system of Kista Galleria, one of Sweden's foremost venues.

This report summarize a simple and efficient way to Convert 2D into 3D designs. It explains the benefits of a 3D design compared with 2D, and how those benefits may be used.It will also give the reader a presentation of the company Clean Air Technologies, which for the most part constructs cleaning facilities for power plants. How to create 3D-libraries for some of those facilities will be introduced in this composition.The collaboration with Clean Air Technologies has resulted in several 3D animated movies and rendered images. This has increased the quality of the companies offer presentations, which has made it easier for the prospective customer to get an improved overall image of the power plant design..

This report addresses the growing need to adapt the medical healthcare to the new possibilities that can be accomplished by incorporating a web aspect to the personal treatment plans of patients. It describes what implementations that need to be considered in order to successfully Convert to a partially web-based treatment.The report also reflects the potential economical gain that can be made by keeping the communication between the patient and the doctor frequent. It also takes into account the personal gain to the patient by increased feedback and easier ways to communicate with their attending physician and thereby increasing the quality of their healthcare and service.The construction of a prototype of the system required is also included in the report as a description of construction and functionality of the prototype along with results and estimated outcome..

The aim of this project is to find a concept solution for a wireless transmitting system, installed to transmit data from a hydrophone of the ocean floor down by a wave power generator to the office on shore. The project is a literature review in which previous observations and tests are analyzed and put together to find a solution. The result was a comprehensive solution that includes an acoustic modem to transfer captured information from the bottom to the surface, wirelessly through the water. The information is then sent fron the surface on radio waves through the GSM network to the office on land. Between under and over water there are components to Convert information between acoustic waves and radio waves, but also various types of modulation, such as amplitude and frequency modulation is required..

The purpose of this thesis has been to determine experimentally how good a peltierelement is to Convert waste heat from wood burning. Three different peltier elementswere used in a comparison study. The comparison was mainly done to know howmuch power could be obtained from each element. Even, a circuit with a step-upfunction has been created to give a higher output voltage than the peltier elementitself. The result of the experiments was a low output power, the highest valuereached 2.18W.

This paper is about Soren Aabye Kierkegaards (1813-1855) philosophy regarding the relation between the aesthetic and the ethic stage. The result of the essay is a modification of the aesthetic problem. The suggestion is to Convert part of Kierkegaard?s metaphysical claims into an epistemic approach. An epistemic approach means to hold a position of well grounded stipulative beliefs.

Total organic carbon (TOC) and chemical oxygen demand (COD) are two methods used for measuring organic pollutants in wastewater. Both methods are widely used but the COD method results in production of hazardous wastes, including mercury.The purpose of this study was to validate the method TOC that will replace COD and find a factor to Convert TOC to COD. In this study 26 samples were analyzed from four sewage treatment plant in the municipality of Enköping.The results show that the COD method could be replaced by the TOC method.The factor for COD/TOC was between 3.1 - 3.3. Both methods will be used in parallel until 2013 when it will be forbidden to use the COD analysis..

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to Convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to Convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to Convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to Convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.