Dagvatten från vägar innehåller ofta tungmetaller. De vanligaste metallerna i vägdagvatten är bly, koppar, kadmium, nickel och zink. Dessa föroreningar utgör en belastning i recipienter som tar emot dagvattnet. I denna rapport har bly, koppar och zink reducerats från vägdagvatten genom filtrering i kolonner med amorf, granulerad masugnsslagg och sand. Masugnsslagg, som är en biprodukt från framställningen av järn, är en alkalisk produkt med goda sorptionsegenskaper vilket gör den lämplig att använda som filtermaterial för vatten förorenade med metaller.

Husqvarna is a world leading producer of chainsaws with a well-established brand name. Husqvarna now has an interest in investigating the possibiltiy to expand their production of chains and guide bars to include cutting equipment for timber-harvesters.This project is a technical study which aims to answer questions about cutting equipment for timber-harvesters that have been decided in cooperation with Husqvarna. The questions have mainly been focused on forces, cutting speeds, service and maintenance -as well as general questions regarding the size of the Swedish market.Two methods have been applied to answer the questions. Interviews with retailers of harvesters, producers of harvester heads and harvester drivers.The main findings in this project show that there is a relatively small selection of harvester chains on the Swedish market. In contrast to the selection of harvester chains the selection of guide bars is quite large.

The purpose with this thesis was to examine the cold rolling mill located at Högskolan Dalarna and to stabilize the rolling process, to achieve steady state. Experiments with cold rolling of an aluminium strip have given results for rolling force, friction, reduction, strip tension and strain hardening. Results show that steady state has been found for the experiments with roll force and strain hardening, and not been found for the experiments with friction and reduction. Results show that increased strip tension gives lower roll forces. The roll force equation of Stone shows comparable results with reality for dry contact with reductions up to 30 %, but starts being incomparable with higher reductions.

The metal mining history goes thousands of years back. The downside of the mining industry is the large amount of tailings created during the mining operations. Drainage and leaching of heavy metals from these tailings may cause major environmental problems including acid mine drainage and leaching of heavy metals. This study examines a pond located near an old mining site, where part of the old mining facility has been recently (1990) restored. The objective was to assess eventual metal contamination from historical mining and the recently performed restoration using a sediment core as a natural archive of historical metal inputs to the pond.

The Swedish industrial society has left several areas with contaminated soil and water which today is of danger for the environment and human health. One of these areas with contaminated soil and water is the region where the former Glava glassworks operated during 1859 to 1939. The main object in this study has been to study the responsibility for the contaminations according to the Environmental Code. The method used is a qualitative content analysis of relevant literature to answer the following questions:What types of contaminations can be found in the area of Glava glasswork and what health issues can these cause?What kind of activity has been conducted in the area that have caused the contaminations in soil and water?According to law, what are the responsibilities for the contaminations in soil and water at Glava glassworks?The contamination in the region has been confirmed to originate from the glasswork due to the environmental engineering survey made in the area in 2009.

This report contains a degree project made by the mechanical engineering students Lennart Andersson and Daniel Jansson. The project has performed in assignment by SOMAS Valves AB in Säffle. SOMAS are leading in development on control and on/off valves. To maintain this position they always want to improve their products. One way in this development is valves that are more tightened.The purpose with our project was to investigate another seat design on a HiCo (High Cobalt Alloy) seat to a SKV 150 PN 25 valve and compare this to an original HiCo seat.By modifying the seat on a ball valve we want to achieve a valve that leaks lesser then a valve whit original seat.

The Swedish industrial society has left several areas with contaminated soil and water which today is of danger for the environment and human health. One of these areas with contaminated soil and water is the region where the former Glava glassworks operated during 1859 to 1939. The main object in this study has been to study the responsibility for the contaminations according to the Environmental Code. The method used is a qualitative content analysis of relevant literature to answer the following questions:What types of contaminations can be found in the area of Glava glasswork and what health issues can these cause?What kind of activity has been conducted in the area that have caused the contaminations in soil and water?According to law, what are the responsibilities for the contaminations in soil and water at Glava glassworks?The contamination in the region has been confirmed to originate from the glasswork due to the environmental engineering survey made in the area in 2009.

X-ray fluorescence (XRF) detection of heavy metals is a cost- and time-effective method for investigation of polluted areas. Compared to laboratory analysis, XRF analysis is limited by high detection limits and uncertainties in some situations. Preparation of samples is known to affect the results of measurements.The purpose of this thesis is to bring a deeper understanding of how different factors affect the results of XRF-analysis. A large number of measurements have been made with the instruments Niton XLt 700 and Niton Xli 700. Results from measurements of lead, zinc and copper have been analysed.This study has shown that a greater moisture content will give a lower measured concentration for the same sample.

AbstractThe research project Liberation, supported by the European Commission under the Environment and Sustainable Development Programme (Fifth RTD Framework Programme) aimed at developing a decision support system for ecological risk assessment of contaminated sites has proposed a tiered system including the triad method. This method integrates contaminant chemistry and bioavailability analyses with observed ecotoxicological effects in soil and groundwater. In this study the triad method was used to perform a risk characterization of a former surface treatment and metal industry, now used for the student union buildings of the Mälardalen University in Eskilstuna, Sweden. On the site, high concentrations of copper, zinc and nickel have been detected in the soil in a preliminary investigation of contaminant levels with XRF. For performing the risk assessment of the site according to the triad method, contaminant bioavailability, soil metal concentrations and soil toxicity were determined and an ecological assessment was carried out on four selected soil samples (one reference soil and three samples with low (B), medium (C) and high (D) contaminant levels). Contaminant bioavailability was measured through leaching (ISO TC 190/S7) and biouptake tests (DGT).

Ensåsengruvan is a mine situated within Ljusdals municipality in central Sweden. Themine was in use from 1984 to 1991 and has since been undergoing a remediation program. Mine tailings from sulfide rich ore is a potential environmental hazard due to its tendency to cause acid waters and heavy metal leakage. Lake Ensjön is situated one kilometer from the mine area. Due to the hydrological conditions it was not expected to receive inflowing water from the mining area.

The river Göta Älv reaches between Vänern and Gothenburg and is the main raw water source for Gothenburg that supplies about 700 000 people with water. To protect and maintain a high water quality, continuously samples and water analyses are made throughout the river. In 1998 a protection area was founded between surte and Lärjeholm where the raw water intake is. This was made to increase the awareness of the importance to protect the water. However, there is a lot of contribution of untreated stormwater to Göta Älv within the protection area.Göteborg Water and Sewage Works commissioned this thesis where two areas, Tagene industrial area and Kärra residential area, with untreated stormwater outlets within the protection area are studied.

This master thesis encompasses an inventory of the older industrial community of Gimo. Investigations of the contamination situation for each industrial area were done. A risk classification according to the Swedish Environmental Protection Agency?s ?Method of Surveying Contaminated Sites?, phase one, followed. The risk classification was done on areas of Iron Work, a rockwool industry and a landfill. Gimo have had iron manufacturing from 1615 until 1945. Gimo have had two blast-furnaces and two smithies periodically.

It is estimated that 22 000 contaminated areas exist in Sweden today. In order to classify the risk of contaminant migration from these areas and to prioritize which of these contaminated areas should first be treated, the Swedish Environmental Protection Agency (EPA) has designed a method, for the investigation of contaminated areas (MIFO). One of these contaminated areas is the landfill Gräsötippen outside Köping. The landfill has been used by both Yara AB and the Köping municipality between the years 1945 and 1975, and both industrial and household waste have been deposited there. The aim of this report is to survey which contaminants that can be found in the soil and water in the landfill Gräsötippen and to evaluate the migration of these contaminants.

Field balances based on supply and removal of trace elements from the topsoil have been calculatedfor farms specialized in crop, dairy and pig production in Sweden. Today's field balances have beencompared with the field balances of 1990 in order to examine if, and then how, the situation haschanged. Studied trace elements are arsenic (As), cadmium (Cd), chromium (Cr), copper (Cu),mercury (Hg), manganese (Mn), nickel (Ni), lead (Pb) and zinc (Zn).The balance calculations show that the stores of Cu and Zn are depleted with an average rate of -15% and -6 % over a 100-years period on crop farms when only commercial fertilizers are being used.The concentrations of Hg and Pb tend to increase in the topsoil on crop farms with more than 3 % forHg and with 2 % for Pb in 100 years. There is today balance between supply and removal of the traceelements As, Cd, Cr, Mn and Ni. In the south of Sweden, on crop farms with sugar beets in the croprotation, one can see a decrease in the concentration of Cd in the top soil by -6 % over a period of100 years.

This work consists of a survey and risk classification of eleven metal industries including foundries, finishers and engineering industries in two industrial areas in Mora. The study follows a method called MIFO (Method of Surveying Contaminated Sites) composed by the Swedish Environmental Protection Agency. In the method assessments of the degree of hazard posed by the pollutants, the level of pollution, the conditions of dispersal, sensitivity and the degree to which the area is worthy to protect are made for each contaminated site (object). The assessment classify the objects into four risk classes in which risk class 1 denotes a very large risk, 2 large risk, 3 moderate risk and risk class 4 little risk. The work of surveying using MIFO is divided into two phases.