The sun is an endless energy source and the heat it produces can be used to heatup our homes. This technology is relatively old and was introduced in the late70-s. There are two kinds of solar collectors that are most frequently used todayand these are plain solar collectors and vacuum solar collectors. The plain solarcollectors are the once that are used the most but the vacuum solar collectorshave increased more as a percentage the last couple of years.The biggest question asked regarding an investment in solar heating is if theplant is economically profitable. This question has no direct answer because itis dependent on a couple of prerequisites.

StoraEnso decided in year 2002 to build a pulp mill in the province of Guangxi, southernChina, and also establish eucalyptus plantations to provide it with raw material. By 2010StoraEnso controls about 90 000 of planned 120 000 ha, out of 75 000 ha is already plantedwith Eucalyptus.By using better genetic material, improve the tending, selecting the sites more careful and byusing a proper fertilization regime StoraEnso hopes to increase the mean annual incrementfrom today?s 25 m3/ha, on bark, to 35 m3/ha. This study is one part in this work to increase themean annual increment in the plantation.This master thesis is the forth in a series, that has followed up a fertilization trial that startedin spring 2006 when the trial was laid out and treatments decided. The aim with the trial is toexamine the production potential of Eucalyptus urophylla in Guangxi, southern China.

In this thesis a possible cost effective runner change of some of the units in the hydroelectric power station Olidan is investigated. The possibility to drive a unit at the same efficiency point through a change of the turbine shaft speed and the rate of discharge is tested. Furthermore the theories behind model testing, determination of efficiency increase from model to prototype and efficiency measurements shall be discussed and analyzed with Olidan as a starting point.A predicted curve has been built on information from model tests and field measurements on the existing runners and runner data from the test of the new model. The predicted curve shows the difference in efficiency between an existing runner and a modern one. It is the difference in efficiency that is used in the calculations that are to show whether changing to a pair of new runners will be cost effective or not.

It is essential to reuse- and recycles residues to decrease the amount of deposit materials and reach sustainable energy use. Two ways to work towards this is to recycle wood ashes to the forest as nutrient compensation and extract biogas from combustion of biomass.The aim with this study was to decide whether wood ashes that been used for biogas upgrading with accelerated carbonation also can be used as a nutrient compensation in the woods according to recommendations from the Swedish Forest Agency (Skogsstyrelsen).The ashes that were used in this study came from Johan Andersson who works at JTI in Uppsala, who also treated the ashes with biogas. The ashes have, in both untreated and treated condition, been analyzed in this study according to contents of elements, leaching properties, hardening properties and contents of crystalline phases, to evaluate what impact carbonation with biogas has on the ashes.The accelerated carbonation led to hardening of the ash, and decreased amount of CaO- and increased amount of CaCO3. The CO2-uptake also entails a dilution of the elements, and the content of nutrients and trace elements decreases. However the results show an indication of an uptake of S from the biogas to the ash, since the dilution had a smaller impact on S than the rest of the elements.

Title: What drives the customer's choice of packaging and which factors influence the customer's packaging cost? ? in the automotive and manufacturing industriesAuthor: Lena AnderssonSupervisors: Annika Olsson, Division of Packaging Logistics, Lund Institute of TechnologyHelena Claesson, Volvo Logistics ABProblem: Which parameters are important for logistic people to think of when they are going to choose a package?Which cost factors are included in the packaging cost?What kind of added value can an emballage supplier provide their services with?Purpose: The purpose of the project was to study the parameters that drives the customer's choice of packaging and the factors that influence the total packaging cost. The study also consists of a valuation of what an emballage supplier can offer to add value to their services.Method: The study is based on interviews with people who are working at Volvo Logistics and Volvo Car Corporation. Volvo Logistics provide their customers with standard packaging material, which they own and administrate. Volvo Car Corporation is one of their customers.

This paper examines the reasons behind firms considering backsourcing. While firms experience problems with their outsourcing activities, backsourcing emerges as an alternative solution. Firms primarily take cost considerations into account when reconsidering their outsourcing practices, but this only scratches the surface. A deeper analysis is needed, since cost increases arise from issues such as quality defects and cooperation problems. Even though production costs are low, outsourcing always implies transaction costs.

This project was started within the Market-Design programme of Elforsk, with the aim of developing representative test systems of Swedish distribution networks. Using such test systems as a basis for reliability and customer interruption cost calculations makes it feasible to analyse the network tariff regulation of Swedish power  istribution companies. In particular, it enables studies of the incentives for companies to invest in system reliability. Until now, the available test systems are either not representative of Swedish conditions, or too small in scale and limited in function.Within this project we have created two test systems. In order to represent the diversity of actual Swedish distribution networks, we have created one test system for urban environments and another for rural environments.

This thesis, in the field of healthcare logistics, has been carried out at Hjärt- och Medicincentrum (HMC) at the University Hospital in Linköping during the fall and spring of 2012/2013. The thesis is done by two students at Linköping University at master?s level within the framework of Industrial Engineering and Management.As Sweden's county councils should not make a profit or loss, it is important that the councils are aware of how much care processes cost. Kardiologiska kliniken at HMC in Östergötland?s county council is one of the clinics that are profitable.

The economic analysis of building contracts is an unexplored field within Law and Economics. This paper makes an attempt to cast some light over the subject and encourage to more research within the field. The main purpose has been to describe why the actual price in a public construction project often turns out to be higher than the contract price and offer a way of handle that risk. In the paper a model is set up that shows an optimal contract given expectations on actual price and gaps in contracts. Cost increases for the buyer can mainly be explained by two situations.

The thesis was performed at the lighting company Zpecta AB. Zpecta needed to develop alternative attachment of their LED-luminaire Capella. Today Capella attaches in metal ceilings with four magnets. Zpecta got indications from their customers that there was a need for other attachments. The purpose is to determine the customer?s requirements and the interfaces that are considered for Capella.During the thesis, Capella was only on the market for testing and evaluation.The thesis was initiated to create a specification.

Different methods for shelterwood cutting have been used in differ-ent parts of Europe since the middle ages. The use of shelter wood cutting in Norway spruce (Picea abies (L.) Karst.) forests in Sweden met a revival in the early 1990s as an alternative for the dominating clear-cutting system when silvicultural costs increased dramatically for the latter. Shelterwood cutting systems involve some possible problems but also a lot of positive effects. Among the problems are increased risk of wind throw and damage of the remaining shelter trees caused by the cutting operation. Positive effects are for example a valuable growth in the remaining trees and increased biological di-versity. This study is based on a total of 79 trees from 4 different treatments in a spruce shelterwood, cut in 1994, in the middle of Sweden (62,4º N).

Denna rapport är resultatet av en analys som gjorts vid Vest-Woods fabrik i Forserum under våren 2007 i syfte att reducera interna transporter. Vest-Wood AB i Forserum tillverkar dörrar för den svenska marknaden men förser också en annan fabrik (SdrFelding i Danmark) i samma koncern med dörrstommar. Materialhantering för att förse Sdr Felding fabriken med dörrstommar medför i dagsläget mycket interna transporter i Forserumsfabriken. För att klara ojämn efterfrågan från Sdr Felding fabriken samt för att kunna jämna ut sin egen produktion har Forserumsfabriken valtatt lagerföra de tolv artiklar som beställs mest frekvent från Sdr Felding fabriken. Buffertlagret vid Forserumsfabriken där artiklarna lagerförs är placerat ca 200 m från produktionen vilket medför mycket intern transport för hantering av dessa.

This final project is an investigation about the responsibility in rooms where the walls and floors are exposed or partly exposed to irrigation of water, as a bathroom, laundry room and WC. The cost for all water damage is valued for 5 000 000 000 SEK each year. How is this possible with all information about the problem and good materials? Who is responsible? Incites had been made in the subject throw reading reports and participation in courses about how to make a room mention above. Discussions have been made with workers in the trade of making the walls waterproof.The conclusion in the rapport is about who´s responsible for the damages and will pay the cost of the renovation. The responsibility is discussed between the contractor and the insurance company.

This study looks into the possibility, and profitability, of expanding a pilot project that has been put into action at GGP Sweden AB in Tranås, a manufacturing company that produces front mowers. The pilot project is meant to give GGP Sweden AB a more precise control of the flow of goods from their suppliers, and its essence has proven to be quite similar to the Japanese Just-in-Time philosophy.The study has been divided into four separate areas; mapping, supplier selection, supplier evaluation and cost analysis. These areas represent a holistic perspective on the expansion of the pilot project and cover topics varying from methods of finding suitable JIT-suppliers, constructing Key Performance Indicators (KPI) to reviewing costs and assessing profitabilities.In this report, the reader will initially take part in the works of mapping GGP?s manufacturing unit, pilot project and supplier base, which results in a list containing the most suitable suppliers for a Just-in-Time based collaboration. Afterwards, the reader will be led into the area of supplier evaluation, where five KPI?s are created with the purpose of ensuring that GGP will be able to evaluate their suppliers and pilot project in an effective way.

This paper discusses the strategy and strategic change in the Swedish freight forwarding business and analysis factors that influence the forces of the business. Three companies of various sizes are chosen to be investigated as a case study, outline that cost leadership and differentiation are both important strategies for companies to compete in the market. However, companies outpacing competition do not only pursue either of the two strategies, the need the ability to add one (cost leadership) to the other (differentiation) in relationship to environmental change over time..