This is a feasibility study that examines various aspects of building a wind farm on Malmön in Norrköping. The feasibility study deals with interests of conflict, park design, electrical connections, production calculation, financial calculations and operating- and timetable.The report is divided into two distinct parts. First a theoretical part, which deals with conflicting interests, park design and electrical connections. Second a part with simulations dealing with production calculations, and financial calculations.Opposing interests are mapped so that problem areas can be found, and help put focus on the right places at a future environmental impact assessment (EIA). There are a number of areas where planners have to assess on an EIA, this thesis point on the most important areas.

The aim with this study was to collect fundamental information, and to plan, a windpower farm in Juddhult , Småland in southern Sweden. The goal is to collect the bestavailable projecting planning support. The pieces of this projecting planning supportthat will be presented is; Environmental Consequence Description (MKB), productioncalculations, comparisons between different plant types, economic calculations, evaluatethe economy and give some farm design suggestions. The imagined wind farm will belocated in forest environment and which may cause a number of new problems. Specialinterest that will be affected, where special consideration because of the forestenvironmental is requested is, hunting, wetlands, ancient monuments and windturbulence.

This master thesis is a study of the Swedish hydropower capacity to balance wind power. The Swedish government has decided that it should be possible to produce 30 TWh from wind power in the year 2020. The Swedish municipalities have to have plans for wind power plants with total yearly generation of 30 TWh. Wind power is an variable energy source that needs to be balanced by other energy sources. In Sweden the Swedish hydropower can be used for balancing a large scale introduction of wind power.

The Swedish Government has decided that Wind power should have a higher contribution to the electricity generation in Sweden. Their goal is that, by 2015, the yearly production by Wind power should generate 10 TWh. In year of 2006, the 760 wind mills in Sweden generated only 0,936 TWh. Despite good wind conditions in a large extend of Sweden's land- and coast areas, the slow rate of new wind mills establishments will likely result in unattainable goals. The major problem for new establishments of wind mills is the extensive and complicated permission process. An expert group of environmental studies (Expertgruppen för miljöstudier) was commissioned by the Government to make a report concerning the problems with the expansion of wind power in Sweden.

This thesis assignment at C-level is focused on calculation models and prediction methodswhish can be used in the stage we call ?prospecting? of possible windmill locations. Thelocation is southeast of Halmstad at the Farm ?Stjernarpsgods?. The rapport has two mainareas directed towards this task.

This thesis concerns how the power quality in the grid is affected by the connection of wind power plants. As things are at present, Fortum Distribution AB has a number of wind turbines and wind parks connected to the own grid. As the pressure on building and connecting additional wind power is increasing, so is also the interest of how the already existing wind power generation affects the power quality in the nearby distribution grids. The study is performed by direction of Fortum Distribution AB and is limited to the 10 kV/40 kV-grid in Bohuslän, Sweden. The methods for calculation of power quality are compared to the results of a number of measurements.

This thesis describes the processes of establishing wind farms in Sweden. The workcontains a thorough literature review regarding both the establishing process andproject management, including complex project theory. The main part consists of theexecution of 15 interviews with organizations involved in wind farm establishment.The result of these interviews laid the foundation for a process description identifyingdifferent steps and activities in these types of projects. The outcome was thencompiled in a project model, which includes five phases and four processes.When analyzing the project of establishing wind farms from the theory of complexprojects one discovers that the amount of different requirements and stakeholdersnecessitates a systematical and dynamical project structure. Since projects are in needof different types of competences there are also many consultants and contractorsinvolved.

At the time being there is limited experience within turbine decommissioning in Sweden and the economic effects are unknown. Despite this, there are expectations that revenues generated by sales of materials will cover decommissioning costs. The model developed identifies thirteen parameters that vary between different types of turbines and that affect the economic consequences of decommissioning. The three most important parameters are turbine location, tower material, and the scope of decommissioning. Trends in the wind energy industry show that these three factors are developing in a manner that increases decommissioning costs dramatically.

The Swedish government have a goal that wind turbines shall produce 30 TWh by the year 2020, compared to about 3,5 TWh produced in Sweden during 2010. To minimize the disturbance that wind turbines create the Swedish Environmental Protection Agency has stated a guideline value that noise from wind turbines at nearby residents shouldn?t exceed 40 dBA, at 8 m/s wind speed. With advanced calculation models, like Nord 2000, the emitted sound from future wind turbines can be calculated at an early stage to optimize the power production without exceeding the 40 dBA. When the turbines have been built there is a need to verify that they really are within the guideline.

To get rid of our dependence on fossil fuels we need to make use of renewable energy sources like wind power to a greater extent. Even though wind power is a renewable energy source it can still cause some problems for the close environment. One of the problems is shadow flickering. When the sun is low and the wind blows in a direction so that the rotor blades are positioned at right angles to the sunbeams and ?cut? the sunbeams off.

We are heading towards a huge switch of how energy is produced with fossil fuels being replaced by renewable energy sources. It is not difficult to replace the energy you use in the house and there is no need for futuristic technology. There are already many established products on the market such as high efficiency vacuum solar collectors, heat pumps & small wind power stations that can supply the energy being used in a house. The company Sol & Energiteknik SE AB in Huskvarna has many different products which can reduce the need for an outside energy distributor. An average house in Sweden uses 15 000 kWh for heating, 5000 kWh for tap water and 5000 kWh for electricity.

I denna rapport har det utförts två fallstudier från två olika vindkraftsanläggningar och med hjälp av en utarbetad modell har livscykelkostnaderna jämförts för de två fallstudierna.Resultatet visade att livscykelkostnaden per producerad kWh sjunker allteftersom den installerade effekten blir högre.Kostnadsmodellen som utarbetats och tillämpats för resultaten har visat sig ha hög verifierbarhet då resultaten har varit jämförbara med litterära studier..

Construction of an autonomous wind station was a project with the goal of creating a product that could collect wind data from a sensor and then transfer this data to a server wirelessly over the GSM network. The device would be powered by batteries and solar cells and function fully without requiring external power supply. This required that a small computer was constructed and programmed to store and send data at predetermined cycle times and programming of a server that received the sent data. The project also required optimization of power consumption and dimensioning of solar cells and batteries based on this. The construction of this station demanded research both for the selection of hardware and programming software. The computer was based on a microcontroller and a GSM module that sent the data over the 2G network.

Micro-power wind energy convertors have recently increased in popularity. The reasons for this are among other things the increasing cost of electric energy and enviromental concern.In this thesis the connection of these micro-power wind energy convertors to the utility network is discussed. Electric standards for the connection of small production units is presented. Finally some calculations and measurements of electric quality are also presented. The utility network used in the calculations is part of Halmstad Energi och Miljö network..

Along with the rapid expansion of wind power in Sweden during the last decades the competition about favorable areas has hardened. This among other reasons has caused the projectors to look into development of wind power in forests. There are several aspects regarding fatigue loads on the constructions that are severe in complex terrain, among which turbulence is one. The levels of turbulence which are accepted in order for the turbines to face a life length exceeding 20 years are regulated by the International Electrotechnical Commission, (IEC). In order to keep the turbulence below these levels there are three major steering tools to use: The ambient turbulence decreases with height and can therefore be regulated by the hub height of the turbines.