Med gallringseffekt menas att träden efter en gallring ökar sin diametertillväxt. Denna effekt har traditionellt tillskrivits den minskade konkurrensen om ljus och näringsämnen mellan träden. En alternativ förklaring till gallringeffekten är att vindpåverkan per träd blir högre i det gallrade beståndet, vilket leder till större svajningar för träden och därmed en ökad diametertillväxt. I studien undersöktes ifall vindens påverkan är en del av gallringseffekten på tall (Pinus sylvestris L). Lokalen för studien var SLU:s försökspark i Siljansfors utanför Mora. Omgivande tätheter av stamantal, grundyta, kronvolym och kronmantelyta beräknades på flera avstånd från varje individuellt träd.

The purpose of this thesis is to collect knowledge of techniques and materials for planning roofgardens. Gardens built on top of buildings is not a new phenomenon, already in the beginning of the century architects were experimenting with roofgardens. During the Modern Era roofgardens appeared as a part of the design and worked well together with flat roofs and the ideas of light, air and greenery. Today the most common kind of roofgarden is on a ground-level joist that hides parking or other underground functions. The most important difference between planning a roofgarden and a garden on the ground is the limitation of the load of the roofgarden. Plants, paving-material and equipment must be chosen with this in mind. A light and thin layer of soil demands plants with small needs for water and nutrition.

The technological legacy from the early electrification of the Swedish railroads has resulted in a power grid with a lower grid frequency than the national power grid from which it is fed. Energy transfer between these power grids with different frequencies requires substations, adapting the grid frequency for the rail road power grid. For this purpose, a feeding power grid has been built, stretching across the country from Boden in the north to Tälle/Häggvik in the south.Power transfer in the Swedish power grid results in voltage angle differences which increase with increasing loads and transfer distance. These voltage angle differences are transferred from the power feeding substations to the rail road power grid, will in some extent cause loss of energy due to unwanted power flows from north to south.To minimize the losses due to this phenomenon, a power management system called EFS 132 kV has been developed and implemented. The system minimizes the unwanted power flows and controls the desired power flow for a good distribution of loads between the power feeding substations.This thesis investigates the extent of the transmission losses avoided due to the EFS 132 kV that coordinates the idling angles to a common reference point.The results indicate that EFS 132 kV affects the power flow, especially between the northern substations through an improved load distribution.

Energy and environmental demands regarding buildings have become an increasinglydiscussed topic, both in Sweden and in Europe as a whole. The general trend indicatesthat greater efforts are being put into the energy efficiency of the built environment.There are already numerous examples of houses with a low energy demand, and thenumber of low energy buildings is constantly growing.At the time being, the maximum level for energy demands for housing in Stockholm is110 kWh/m2year, but as soon as next year the limit will be changed to 90. The Swedishagency Energimyndigheten is currently conducting a project to interpret the EU Directiveon the so-called Nearly zero energy buildings, and the preliminary results indicate thatthe level of requirements for purchased energy will end up with about 55 kWh / m2year,which is in line withtoday?s recommendationsfound in FEBY's Kravspecifikation förPassivhus.Starting with a low-energy house in Henriksdalshamnen in Stockholm, we have analyzedvarious energy-efficiency measures and their influence on power and energy needs. Thefinancial aspects associated with the measures have been studied using a model of lifecycle costs.The measures were initially studied individually to give an idea of how much impact theyeach had.

  Aim. The aim of the study was to describe how nurses in home care experience to pursue palliative care in ordinary housing. Methods. The study had a descriptive design with qualitative approach and was carried out through semi-structured interviews with 14 nurses in home health care from two medium-sized Swedish municipalities. The material was analyzed with manifest and latent content analysis. Findings. The underlying theme that emerged in the study was: Working with palliative care in the patient´s own homes is positive but challenging. Informants describe among other things that they perceived palliative home care as meaningful and that relatives have a central role in the palliative home care since they are close to the patient around the clock. The stress that emerges from the heavy work load and the long geographic distances are described as strenuous and to affect the care in a negative way. Informants describe the home environment as challenging as it is often not adapted for care and the collaboration with the palliative team is described to be experienced as both positive and negative.

  Aim. The aim of the study was to describe how nurses in home care experience to pursue palliative care in ordinary housing. Methods. The study had a descriptive design with qualitative approach and was carried out through semi-structured interviews with 14 nurses in home health care from two medium-sized Swedish municipalities. The material was analyzed with manifest and latent content analysis. Findings. The underlying theme that emerged in the study was: Working with palliative care in the patient´s own homes is positive but challenging. Informants describe among other things that they perceived palliative home care as meaningful and that relatives have a central role in the palliative home care since they are close to the patient around the clock. The stress that emerges from the heavy work load and the long geographic distances are described as strenuous and to affect the care in a negative way. Informants describe the home environment as challenging as it is often not adapted for care and the collaboration with the palliative team is described to be experienced as both positive and negative.

ProblemEn ensamföretagare måste ofta sitta på en mängd olika kunskaper, då det är vederbörande som i slutändan tar alla slutgiltiga beslut. Enligt Tomas Lindberg själv förekommer det en sviktande försäljning av produkten Wind-X Medium. Kan det då finnas kunskapsluckor hos Tomas Lindberg själv som har ett indirekt samband till dåliga försäljningssiffror? Vilken betydelse kan det ha för företagande och tillväxt om det finns skillnader mellan att vara en företagare eller entreprenör och uppfinnare eller innovatör? SyfteSyftet med studien är att undersöka problematiken en ensamföretagare kan ha med att skapa större intresse och acceptans kring sina produkter. VisionMed en vision att kunna komma med ett eller flera förslag på hur han kan gå vidare med sitt företag. MetodFörfattarna har i denna studie använt sig av en kvalitativ metod, genom att intervjua ägaren till företaget. Författarna har genom att göra olika analyser fått fram information till studiens empiri.

This report is an outcome of a master degree project at Linköpings University in co-operation with Micronic Laser Systems AB. The purpose with this master degree project was to investigate how to implement a receiver in a data transfer system. The system consists of several data channels, where every channel consists of three parts: driver, transmission lines and receiver. The driver send low amplitude differential signals via the transmission lines to the receiver that amplifies and converts it to a single-ended signal. The receiver has to be fast and be able to feed an output signal with high voltage swing.

When constructing a building, a number of aspects must be harmonized in order for it to fulfill requirements ? a building must fulfill requirements such a load-bearing, conservation of energy and a good indoor environment by means of, among other things, moisture proofing .Moisture problems in buildings can affect health negatively. As we are increasingly staying in indoors, demands on a good indoor environment are higher.This work starts with examining moisture problems in slab-on-ground solutions, and then links the various scenarios to moisture problems in a concrete slab of a real building. The building with moisture problems is located in Årby by in Borlänge and moisture damage was found in the slab at an apartment adjoining wall.By reviewing literature written within the field of moisture problem, making hand calculations and modeling in the program Comsol Multiphysics, judgments are made to find explanations as to why the rise of moisture occurred in the building in Årby by.Generally, the following guidelines may be used to reduce the risk of moisture problems in slab-on-ground constructions:Drying of construction moisture before laying the floor material.Using draining layer beneath the slab, to prevent capillary suction.Using insulation under the slab, partly for comfort and to establish the temperature difference between the ground and the concrete slab.Avoid direct contact between the wood and concrete, due to degradation and fouling smells that normally occurs.If necessary, use additional vapor barrier.In addition to the above, there are various methods for moisture-proof and moisture-monitoring by design or by the method ByggaF suited for the entire construction process various events..

  Aim. The aim of the study was to describe how nurses in home care experience to pursue palliative care in ordinary housing. Methods. The study had a descriptive design with qualitative approach and was carried out through semi-structured interviews with 14 nurses in home health care from two medium-sized Swedish municipalities. The material was analyzed with manifest and latent content analysis. Findings. The underlying theme that emerged in the study was: Working with palliative care in the patient´s own homes is positive but challenging. Informants describe among other things that they perceived palliative home care as meaningful and that relatives have a central role in the palliative home care since they are close to the patient around the clock. The stress that emerges from the heavy work load and the long geographic distances are described as strenuous and to affect the care in a negative way. Informants describe the home environment as challenging as it is often not adapted for care and the collaboration with the palliative team is described to be experienced as both positive and negative.

Swedish goats are mainly held for cheese production and therefore, both milk quality and composition are of great importance for dairymen. Today, only few data exists on milk composition from Swedish dairy goats and the casein content is still unknown. One way to reduce the work load for goat farmers and increase animal welfare can be to keep goats and kids together for longer periods. The aims of this study were to investigate how milk yield and composition were affected when kids suckled their dams during 8 weeks, and to measure the casein content on farm level by a mid-infrared spectroscopy method, previously calibrated for goat milk. Lactating goats were kept in two different MIX- systems where the dams are both suckled and milked.

Glycogen is the storage form of glucose and is used by the skeletal musculature as energy both for intense and endurance events. The glycogen content in the horse?s middle gluteal muscle is more than 600 mmol/kg dry weight, and almost 400 mmol/kg dry weight in the human?s Vastus lateralis. In some special occasions, for example in competitions with several moments on following days, there is a need of a fast muscle glycogen resynthesis. The feed intake is of importance for the velocity of the resynthesis.

Detta examensarbete genomfördes våren 2013 på Karlstads universitet där TD Rail & Industry i Västerås stod som uppdragsgivare. Projektet innefattade att kartlägga nuvarande omlastningslösningar av enhetslaster mellan järnvägstransporter och vägtransporter, och utarbeta en konceptuell omlastningslösning med fokus på att öka järnvägstransporternas flexibilitet gentemot vägtransporterna. Där vikten lades på att utarbeta ett välarbetat helhetskoncept.Projektet genomfördes med designprocessen som grund och innehöll bland annat momenten; förstudie, kravspecificering, idégenerering, konceptval m.m.Resultatet blev en vidareutveckling av det redan befintliga systemet CCT som bygger på horisontell överföringsteknik och möjliggör därför omlastning av enhetslaster direkt under kontaktledning. Skillnaden mellan RES och CCT är att man tagit bort ombyggnationen av tågvagn och lastbilschassi, som var en av CCTs stora svagheter, genom två hydrauliska ?teknikplattor?.

The main goal with this thesis report was to come up with ideas of how to make the use of energy more effective and thus save money for the company.First a survey was made to find out where and how the energy consumers were divided within the company. The results were then used in calculations to find out how much money that could be saved and how long it would take to get back the investments.There is a big potential in saving money by recovering heat from the UV-lamps with a heat exchanger. It would also even out the pressure in the factory which is a source to heat loss and a cause for discomfort amongst the employees. It?s possible to save 105 000 kr in a year and the money needed for the investments is 600 000 kr.By using the recovery air more effectively the company could save up to 250 000 kr a year in lowered heat purchases, but this would require the use of automatic dampers.If you reschedule the running times for the wood chipper and invest in some kind of load management, for example Sydkraft?s ?Energidirigent? you can save at least 42 000 kr.

Linux is a growing operating system in embedded systems. Today, Linux is not only in heavy servers but also in cell phones, PDAs, cameras and other devices running on battery power. While current technology is more energy efficient, more and more technologies are implemented into a single unit resulting in an overall increase of power consumption.Low power consumption is an increasingly important feature of a system today. Lower power consumption means lower costs, less environmental impact, and longer life for applications that runs on batteries.This work compiles methods to reduce power consumption of Linux systems. The work includes examining whether the available opportunities are platform-specific or of a more general nature.