Nanofiltration is a proper way of preparation of drinking water. The process has a lot in common with reverse osmosis where a semipermeable membrane is used to separate a pure water flow from the remaining water. A pilot plant was used to ensure that nanofiltration is a suitable technology for a specific waterworks station in Glemmingebro, Ystad. The purpose was also to find out if a pH-adjustment is needed for feed water in a possible full scale plant.  In this case nanofiltration is used mainly to remove sulphate and calcium since the raw water contains concentrations of these substances which exceed the limits for potable water. It is important to receive a high recovery (RC), otherwise the deliviery of water won?t be high enough.

1.1 billion people are today living without sustainable access to improved water. The debate over the water sector has been dominated by the discussion over whether public or private actors are the most competent to manage it. In this paper the arguments pro and contra the two positions are presented to try to overview the debate and to try to find new ways to approach the question of the people living without clean water. By examining possible alternatives towards the discussion of public and private actors, it might result in some new approaches on how to move closer towards a solution. One alternative is local, small- scale projects which focus on the situation of the targetgroup in most need.

Risk-based sampling program of microorganisms in the water source in northern SwedenAfter several disease outbreaks caused by parasites in the drinking water during the last years, it is more essential than ever to insure that the water supply companies have enough barriers to counteract the presence of microorganisms in the outgoing water. It is also discussed whether climate changes such as increased precipitation can have a connection to the increased cases of parasites in water sources. The water source at Gäddvik is Luleå municipality?s largest and provides drinking water to 64 500 of Luleå?s 74 000 inhabitants. The investigation of microorganisms in the water source, especially in the Lule River has not been as prioritized as the sampling of chemical parameters.

The filters used today to purify water are often expensive and the need to find new filter materials is substantial. Studies of pine bark have shown that this is a material that may be used as an alternative to conventional filter materials, such as activated carbon. However, the study of pine bark has shown that a leakage of phenolic compounds may occur when using the material for water purification. Therefore, the purpose of this report is to investigate the release of phenols from pine bark, in order to evaluate the use of pine bark as a filter material. Another assignment is to investigate the amount of metals adsorbed by the filter material.

In most countries, the dairy industry focuses on the volume of milk produced instead of its composition. This results in a high content of water and a lower proportion of fat and protein. A high proportion of water is not desirable when processing the milk into various dairy products like cheese, cream and milk powder. High water content also increases the costs for transport and storage, and also an unnecessary, albeit marginal, strains on the world?s water reservoir.

The thick-shelled river mussel (Unio crassus) is a red listed species classified as Endangered (EN) and is also considered within the Habitats Directive. The distribution in Sweden is fragmented and it is mostly occurring in the south eastern parts. We investigated the presence of Unio crassus in a section of the stream Storån, Östergötland County, from Falerum to the inflow into Lake Åkervristen. The environmental parameters investigated were water depth, bottom substrate, shading, water velocity and the slope over the water surface. In this thesis I have focused mainly on water depth and shading, comparing sites with and without mussels.

The master thesis, conducted at Metrima AB, concerns the development of a non-intrusivedistribution meter as a basis for individual tap water billing in apartments.The project is conducted in response to the market interest in individual tap water billing inapartments as an answer to environmental concerns regarding water consumption. Due to thehigh installation cost of traditional water meters, a new method of determining waterconsumption, without having to cut water pipes, is proposed.The proposed method distributes the total water consumption for an apartment complex toindividual apartments according to distribution meters, measuring water run-time, in eachapartment. The water run-time is estimated by measuring the water pipe?s outward vibrationsand temperature changes.A test environment was established and a prototype built, using a tilt- and vibration sensor forvibration sensing and a precision temperature sensor to measure temperature changes. As bothsensors work well in the test environment, further testing was done in 3 apartments for aduration of 5 days.

This master thesis is developed based on the desire of the water and sewage department in the municipality of Karlskrona. The department, which vouches for the quality of produced drinking water and sewage cleaning, was in need of help dealing with risk analysis.The water and sewage department is obliged to identify and assess risks according to Swedish legislation. However, no guides for this purpose regarding safety, health, environment and quality were available. The aim of this report was to accomplish a guideline for the performance of risk analysis within water and sewage plants. If the guideline is used, the requirements in the legislation will be obtained.

Pharmaceuticals that are found in marine ecosystems are a threatening environmental concern, which is known to harm both animal and plant life. One of the reasons for this problem is that the waste water treatment techniques are not optimized to clear waste water from its pharmaceuticals contain. In this master thesis four Swedish treatment wetlands were studied, and their ability to reduce numerous pharmaceuticals in waste water. The four treatment wetlands that were studied were those in Oxelösund, Trosa, Nynäshamn and Eskilstuna. Two ecotoxicological tests and chemical analysis were used.

There are today large amounts of contaminated sediments in the Baltic Sea. These contaminants are the result of many years industrial activity where the contaminants have not been taken care of and just released out in the water. When ports want to dredge in their fairways and harbor areas the contaminated sediments need to be considered since they are a environmental risk. The development in this area has been slow and new techniques have just recently made its way into dredging operations in the Baltic Sea region. As a result of this there are no clear methods for implementing new techniques today.

This pilot study examined whether treatment with Vortex Process Technology (VPT) of the irrigation water used on tomato (Solanum lycopersicum) plants had any effect on plant growth. In a block experiment, with two blocks comprising 12 vases containing 1 L water and two tomato plantlets, treatment in which, nutrient solution was based on Vortex-treated water was compared with an control using untreated water. All vases were kept in a static aerated culture system in a daylight chamber for four weeks. The results showed that the effect of the two blocks exceeded the effect of vortex treatment in terms of leaf area and weight of fresh and dry matter. Plant height, stem width and internodal length were significantly different in tomato plants grown in Vortex-processed water compared with the untreated control.

This Master?s Thesis aims to investigate and assess the methods used to decrease the discharge ofmetals, primarily copper, from the water purification plant at Assa Industries plating factory inEskilstuna.Literature studies of the purification methods precipitation, ion exchange, evaporation, reverseosmosis and electrolysis has been done to appraise the adequacy of the technique. Thesetechniques are commonly used for purification of industrial waste water.Assa has four plating lines: the Trumline, the big Zinkline, the new Zinkline and the Decorativeline. The new Zinkline is the most modern of the four lines and purification is done byrecirculation over an ion exchange unit. The demand for fresh water is thereby heavily reduced.The Trumline, the big Zinkline and the Decorative line all use older techniques.

Water constructions - as a design element in public spaces is the title of this Master thesis, with a focus on waters function and meaning in the urban environment. By way of introduction, mans relationship to places is described and the factors that contribute to the reality that we prefer some places more than others. A good place to stay is open but well defined, gives protection, offers a good view and is varying in topography and vegetation, together with contents of single landscape elements like visible water. This study then continues to discuss mans relationship to water and its means for our wellbeing. Despite the fact that people have a different relations to water due to personality, background and age, it?s an element that raises positive feelings, interest and aesthetic pleasure for most people.

This study describes what impact activity within Wifstas, Matfors,Grönstas and Nolbys water protection areas have on the quality of the drinkingwater. It considers the use of the area, environmentally dangerous activitiesin the past and present, the geology?s part, what harm hydroelectric power damsmay cause if they break and how climate change might affect the area in thefuture. It also takes into consideration activities outside the waterprotection areas which might have a suspected impact on the water quality. Theresults of the study are that pollution from infrastructure such as roads, orwastewater from treatment plants may cause occasional contamination of thedrinking water, foremost due to flooding.

The Swedish pulp and paper industry meets higher demand for energy efficiencyi mprovements with increasing energy prices and changes in the Swedish renewable energy certificate system. One action of energy efficiency improvement is by using secondary heat, that otherwise would have been treated as waste heat, for use in a system with lower temperature demands. The aim of this Master´s thesis is to identify possible secondary heat sources in a typical Swedish pulp and paper mill and to investigate what economic benefits the secondary heat will provide when being used for pre heating of wood chips to a kraft digester.The Master´s thesis focuses on three secondary heat sources; dry warm air, warm water and moisture saturated warm air located inside the pulp or paper mill. Two types of kraft digesters are simulated within this study, a typical Scandinavian digester and a modern twin vessel steam phase digester.Due to quality aspects and low temperature level drying is the drying technology with dry warm air rejected. Using warm water in direct contact with wood chips increases the quantity of water to the evaporation plant and thus reduced pulp or paper production and is therefore also rejected.