The demand for biogas as vehicle fuel has risen sharply and there is a great need for increased production. A possible addition of vehicle gas can be produced by upgrading landfill gas which is formed by degradation of organic waste. This thesis investigates the potential of producing vehicle fuel from landfill gas in the region of Biogas Öst.In 2008, an amount of 32 million Nm3 landfill gas was extracted in the region. This level can be maintained for another ten years if the efficiency of gas extraction is improved. The annual production will decrease with time since landfills aren?t allowed to receive more organic waste.

This thesis calculates and compares the values of improved environmental quality due to future possible investment alternatives in biogas production facilities at Käppalaförbundets Reningsverk (Käppala Sewage Treatment Works) in an attempt to determine which alternative yields the highest such value. Käppala faces three investment alternatives for the usage of biogas. The alternatives are production of vehicle fuel, district heating and thirdly, heat and power production. Estimates of the value of environmental change are calculated for each of the three investment alternatives, and these estimates are then compared. The environmental change in question is the change in discharge levels of carbon dioxide (CO2), nitrogen oxides (NOx), sulphur dioxide (SO2) and particle matter.

The decision of the European Commission to block the merger between Volvo and Scania in the late 90?s became the starting point to the debate of the possible discriminating effects of the European merger regulation. Especially since the Commission a few years earlier had approved of the merger between Mercedes-Benz and Kässbohrer on the German bus market, where the conditions for competition had been similar to those at hand in the Swedish case. The issue that was and still is in focus is whether the European merger regulation is more difficult to pass for large companies situated on a smaller domestic market than is the case for their competitors of corresponding size but situated on a larger domestic market.This thesis aims at examining what the judgement of the geographical relevant market means for the application of the Merger act. This is being done from two perspectives.

In Sweden, the demand for bio energy has increased in recent years due to the current energy and climate debate. In 2008, the energy supply of Sweden was 612 TWh, biofuels accounted for 123 TWh of these. Stumps have been highlighted as a potential fuel in recent years and the Swedish Forest Agency expects a technically and biologically feasible potential of 20.7 TWh annually between 2010 and 2019. The idea of utilize stumps is not new. During the 19th century stumps were used for tar production and during the 70?s and 80?s attempts were made to use stumps in the pulp industry.

Detta examensarbete har genomförts på Volvo Aero i Trollhättan och består av tre delar: en kartläggning av processventilationens uppbyggnad på ett antal utvalda maskiner och beräkning av dess energiåtgång, en jämförelse ur energieffektivitetssynpunkt mellan ett nyutvecklat maskinkoncept som kallas MultiTask-Cell och traditionell tillverkning, sist har en tomgångsanalys gjorts i verkstaden för att identifiera vad som använder elenergi då ingen produktion sker.För att kunna genomföra uppgifterna har mätningar av elanvändningen gjorts på både maskinnivå och transformatorer, detta för att kunna beräkna energianvändning på utvalda maskiner och även få en helhetssyn över verkstadens energianvändning. Det har även gjorts datainsamling och intervjuer för att få grepp över processventilationens funktion och uppbyggnad.Det finns två varianter på processluften, ett där konstant relativt högt luftflöde används och ett när man genom varvtalsreglering av fläkten använder ett lägre grundflöde som forceras en viss tid vid spindelstopp. Ur energisynpunkt är metoden med grundflöde och forcering att föredra då det leder till både mindre energiförluster genom processluften och en stor minskning av fläktens elbehov. Det har även räknats ut en teoretisk energibesparing vid införande av värmeåtervinning för två maskingrupperingar.Jämförelsen mellan MultiTask-cellen och traditionella maskiner har gjorts genom att mäta den energi det krävs för att tillverka en detalj för respektive tillverkningssätt. MultiTask-cellen visade sig använda cirka 25 % mindre energi än de traditionella maskinerna för tillverkning av samma typ av detalj.Tomgångsanalysen visar på ett högt effektuttag även då det ej sker någon produktion på Volvo Aero.

In order to counteract and to discover unethical actions within an organisation, a growing number of Swedish companies implement a so-called whistleblowing system. The purpose of our essay is to study the mindset of companies and further analyse how this mindset affects the design and quality of companies' whistleblowing systems. To do this, we have used a qualitative approach by interviewing different Swedish companies about their mindsets and systems. The study determines that there seemingly are three different categories of systems of varying quality. In this study we have chosen to call them "internal system", "external system" and "combined system".

It is possible to affect the feed costs in different ways. By steeping or fermentation the digestibility of the feed is improved for the animals with a natural process in the wet feeding system Steeping means that the feed is soaked some hours before feeding. This process activatesenzymes and improves the digestibility of for example phosphorus in the feed and make it more accessible to the animal. Wet feeding can be fermented or not. Fermentationmeans that the feed has been soaked for a certain length of time so that a biological process is started.

When the storm Gudrun hit Sweden on the 8th and 9th of January, many recreational forests in southern Sweden blew down. For this reason there is a demand for new regeneration methods as to how these storm-felled areas should be regenerated and with what species. In this study the forest is divided into three areas: production, recreation/production and recreation. The first area is a forest with production as main goal and these kinds of forests are located a bit from the city. The second type ? recreation/production forest ? has two equal goals: production and recreation, and is located close to the city.

This is the final documentation of the basis that can be the foundation of how to solve theproblem with leaking hydraulic oil in a shoe press at the company Albany InternationalAB in Halmstad, Sweden.The project has been performed at Halmstad University as a degree project commissionedby Albany International AB. The purpose of the degree project was to find a way ofdetecting the hydraulic leak of a shoe press. The reason is that the shoe press runsunattended during nights and weekends, this can cause an extensive decontaminationwork and production stop if leak. The hydraulic oil could be leaking in large amounts orslowly as a fine mist. The development of a working system that can detect a hydraulicoil leak and stop the machine before a large amount of hydraulic oil leaks out wouldconsiderably reduce the cost of the decontamination work.

Husums plant has a selection of different pulp pumps at bleaching plant 4 and 5. The displacement- (HC-pump, Sund Defibrator PTD-60) and centrifugalpumps (MC-pump, MCA 42-200, MCP 30/20) are of interest in this report. The centrifugal pumps are controlled by throttle valves, which result in an energy loss. Chemical mixers are used to mix ClO2 into the pulp before proceeding into a holding tower where the bleaching process occurs.The energy demand of the different positions has been measured or calculated to be used in comparisons against new equipment. Quotations were requested and delivered from Valmet and Sulzer.

The goal of this Masters thesis is to examine how people at the production department of Arkivator Falköping AB perceive the internal organisational communication transfer and exchange of information, by means of a communication audit. The objectives are also to characterise the communication climate and the respondents satisfaction with the internal organisational communication within the organisation. The results of the study are compared with the companys information policy and with previous research in organisational communication. Answers from different demographic groups within the population are compared. The communication audit was conducted using a modified and added version of a questionnaire originally compiled by the International Communications Association.

To implement an ERP-system is not an easy process. The success of the implementation depend on many different variables. The most important one is perhaps the requirement process, to define what the organization wants and expects from the system. In this study, the advantages of a process mapping are examined, in relation to the phase where the requirements are expressed in an ERP-implementation. The conclusion is that a process mapping generates an increased communication with the supplier of the ERP-system, hence the business knows their processes and thereby what they want from the system.

The idea with constructions made out of prefabricated elements is that it should be quick and easy to build as the demands for lower production costs, increased profitability and shorter production times are constantly increasing. High accuracy in measurements and well-balanced tolerances is required to achieve this. The fact that the concrete-elements doesn?t fit and that damage occurs during assembly is a highly topical issue even though we now have methods and systems that make this high-intensity construction possible. Through this report we want to highlight the problems that cause the dimensional and tolerance problems and give suggestions on how to come to terms with these.

Käppala wastewater treatment plant situated on the island of Lidingö northeast of Stockholm is running a project during 2004 and 2005 with the purpose to map out the capacity of anaerobic digestion in the digesters that treat primary and excess sludge. The purpose of this thesis work, which is part of that project, was to characterize the present anaerobic digestion process and to investigate its capacity to treat other organic wastes such as restaurant waste and waste from water works. To decide the potential of both methane and biogas production from different substrates batch laboratory tests were carried out. To imitate the anaerobic digestion process at Käppala continuous tests with small scale reactors were carried out. These reactors were later fed with restaurant waste.The batch laboratory tests showed that primary sludge had a potential biogas and methane production of 0,62 and 0,35 Ndm3/g VS respectively after 40 days of digestion.

An old and well known problem in sawmilling is to determine which dimensions /products those are most profitable to produce. Existing optimization models maximize the value of the log. In other words, based upon the market prices of the dimensions the models calculate the best way to split the log. Yet there is a great uncertainty if the most well paid dimensions really are the most profitable to produce. The costs of the process from lumber to sawn products are hard to determine and are therefore often left out from the optimization process. In this study the economic contribution of different dimensions/products are analysed.