Stockholm is growing with almost two fully loaded SL-buses a day. One of the consequences that derive from this is the increase of public transport travelers who put the regionally governed public transport up to the test in terms of its capacity. The Transport administration in Stockholm County initiated 2015 a project with the purpose of simplifying the calculation of bus stop capacities. A hypothesis (set up by the Transport administration) based on that a model for calculation of bus stop capacities could be calibrated for Stockholm conditions is being researched in this bachelor?s essay.The study is implemented by self-collected traffic data from bus stops located in the Stockholm city center.

The purpose of this of this essay is to explore the construction of a conservatory that is livable allyear around. When you build a conservatory there are several factors that need to be regardedthat usually are of no importance when you build a regular conservatory. The glassed facadeneeds to have a very good U-value and all the parts of the facade need to be isolated and theconstruction needs to prevent thermal bridges.In this essay we will start by looking at the shape of the conservatory. Due to the façade consistsof glass the conservatory will need to have a good ratio between the area and the façade so thatthe heat losses will be at a minimum. However, due to the fact that one of the sides of the façadeis connected to the warm house, you quickly realize that the shape of the conservatory is of noimportance.There are two common ways to build a foundation for a conservatory, a molded concretefoundation and isolated wooden beams.

AbstractWork to develop the Eurocodes started in 1975 by the European Commission adopted a program to eliminate trade barriers within the construction area. The goal was to create common European design standards that would replace the member countries' own rules. Eurocodes will replace The National Board of Housing Building and Planning, National Rail, The National Road Administration and other agencies' calculation rules for the buildings structures. The transition to the use of Eurocodes looks like this:Eurocodes set to Swedish standards  between 2002 ? 2007They can be used parallel with national standards 2006 - 2009 The total transition is at the end of 2010/2011.Right now is going on a lot of work for replacement of the existing standards to Eurocodes.  The transition to the new calculations` standards, many construction companies and consulting firms facing a big changes and competitions.

This thesis concerns partial discharges in stator windings and the possibility of analyzing data using statistical methods. Partial discharges, or PD, are a physical phenomenon in which discharges occur locally due to large electric fields. PD can occur in or adjacent to the insulation of stator windings and causes breakdown of the insulating materials. PD measurement can provide an idea of how widespread the PD activity is. A technique to measure and analyze PD that has become very popular over the last few decades is phase resolved PD patterns.

Hudiksvall Municipality will build a new preschool. The goal is that the pre-school should reflect the municipality's environmental goals and meet building regulations. The wall structures that are compared in the report is an insulated wooden frame and a frame of lightweight concrete blocks from H + HWall structures are compared within the areas of U-values, air tightness, thermal storage capacity, fire ratings, moisture, durability, emissions and environment. In these categories the two wall structures will be rated in a scale from 1 to 5 and then the categories are weighted against each other. The weighting is based on Hudiksvall Municipality's assessment of the categories importanse for their final selection.The results of the comparison show that the concrete structure is recommended for the construction of pre-school with 27.55 points against the wooden structures 23.70 points.

This examination paper is a study of the indoor climate in a theatre and a practice room for orchestras placed in Sickla in Stockholm. The designer of the ventilation system wondered if he had managed too make a good environment for the users and he also wondered which of the rooms that had the most desirable climate. The project includes polls for visitors, interviews of people connected to the rooms and measurements of the physical environment. The results show a small dissatisfaction about the thermal indoor climate, it?s a little bit to cold and the air draws.

Detta examensarbete utreder lönsamheten i en systemlösning för termiskt akviferenergilager tillsammans med ny VVS-teknisk lösning i fastigheterna kv Hästskon 9 och 12 vid en föreslagen framtida helrenovering. Dessutom utreds förutsättningar för miljöklassning i energi- och miljöcertifieringssystemet Miljöbyggnad avseende energianvändning, dagsljuskomfort, solvärmelast och termisk komfort för om- och tillbyggnadsförslaget med målsättning på nivå GULD.Genom att utnyttja akviferen under fastigheterna kvarteret Hästskon 9 och 12 idag kan man åstadkomma mycket låg energianvändning med en säsongsenergiverkningsgrad via kylmaskiner för värme- och kylaförsörjning på 5,6. En LCC-kalkyl visar att det finns en energikostnadsbesparing för fastighetsägaren Vasakronan omkring 3,65 MSEK per år jämfört med dagens situation om den beskrivna akviferlösningen används. Det ger en återbetalningstid om cirka 4,5 år på investeringen som måste göras. Energiklassning i Miljöbyggnadssystemet för befintliga fastigheter är troligtvis möjlig utan andra åtgärder än akviferlagersystemet, men då med BRONS eller möjligtvis SILVER nivå.Vid ett framtida om- och tillbyggnadsförslag får fastighetsägaren cirka 13 000 m² ytterligare uthyrbar lokalyta för handelslokaler och kontor.

The present study examines a new production line of glue-laminated wood (glulam). The glulam is produced from non-planed boards of spruce, which also is convex, that is pressed together with high pressure during the gluing. According to a economic calculation, the material has a economical potential mainly on account of the absent planning. The study mainly found out that the shear strength of the material tolerated the demanded values in standard SS-EN 386, but the delaminating values did not. Since there are more areas to be studied around the material, the prospect to achieve the right delamination values is seen as positive..

This thesis is an evaluation of a new design concept for statorfeets in Gallejaur hydro power plant. Founder of the work is Vattenfall AB Vattenkraft. During the 70- and 80´s nuclear power began to be phased in to the Swedish grid, which meant that hydropower became an important source of rules. The generators began running in so called intermittent operations instead of basic operations, which meant 300-600 start/stop per year instead of one-ten numbers start/stop per year. In order to deal with the thermal forces that arise at every start and stop suppliers began to mount so called sliding joints, which is to take advantage of these forces and maintain the stator shape.

Weathering on rocks is an important component of the world?s geomorphology. One way to measure weathering on rocks is to analyse rock hardness. This is a study conducted in the northern hemisphere on granite rocks in Uppsala, Sweden. A Schmidt hammer is used to create a correlation analysis between the aspects on three glacial erratic boulders and rock weathering.

The energy consumption continues to increase as the use of electronics and energy consuming equipment increases. The use of fossil fuels has to be phased out for this to be sustainable in the long run while the use of renewable energy continues to increase. A renewable energy source is solar energy but the production of heat and electricity are today very expensive compared to other energy sources and an important task for the solar energy market to grow is therefore to minimize the production cost of the solar collectors while increasing its efficiency to produce heat and/or electricity. One way to convert solar energy into heat is by using solar collectors and electricity can be produced by utilizing the produced heat, or by applying solar cells.This thesis aims to recommend a reflective material for the next generation solar collectors from Absolicon and to recommend a commercially available coating for the receiver tube of the solar collector. A market study has been carried out to investigate the cost-related aspects along with the optical and durable aspects for the optical material of the solar collector.

This thesis deals with the numerical 3D simulation of a four stroke, spark-ignited, internalcombustion engine, which is mounted on a high performance motorcycle. The work, carried outin collaboration with Politecnico di Milano and MV Agusta, focuses on the simulation of theintake, compression and expansion stroke, including combustion simulation, using an opensource CFD code.Simulation of internal combustion engines offers a great challenge in the field of CFD research.Moving boundaries of the solution domain, caused by the motion of the piston and valves, leadsto deformation of the computational grid, with decreasing quality of the solution as result. Basedon this, a previously developed mesh motion strategy was employed where a number of meshesare used to cover the whole simulation cycle. Within each mesh interval the internal cell pointsof the mesh are moved to account for the boundary motion of the piston and valves. This strategywas previously applied to simplified geometries as well as real engine geometries.

The housing sector of today represents for almost 40% of the energy consumption, an energy consumption of which the major part consists of non-renewable energy sources. This is not sustainable and utilization of new energy-efficient technologies in buildings can be a step in the right direction, towards a sustainable energy society.This report has been made on behalf of and in cooperation with Älvstranden Utveckling AB in Gothenburg to examine how future energy-efficient technologies can affect the energy demand in energy-efficient multi-dwelling buildings.The report is based on Älvstrandens passive house, Hamnhuset, a house whose energy consumption is far below the BBR's requirements. The report looks at the opportunities for improvement within windows, insulation, solar energy technologies, as well as white goods. Computer simulations are then made to apply the selected technologies into a reference building. Technologies are selected from an energy efficient perspective and no account has been taken of other aspects such as the economy.

Ocean Thermal Energy Conversion (OTEC) is a technology that utilizes the temperaturedifference in oceans between the warm surface water and the cold water at 1000 m depthto produce electricity. The purpose of this report is to investigate if OTEC with its synergiescould become a commercially feasible energy solution for a small island. A literature reviewis conducted to explore the different OTEC technologies and to what extent the threesynergies; fresh water, air conditioning and aquaculture, could be used. In order to calculatethe profitability of these synergies there is also a study conducted on the conventionalmethods and cost of fresh water production, aquaculture and air conditioning. A model is setup using a scenario of a small tropical Island with population of 100 000 people.

This report describes a new foundation method and compares it with a traditional founding of concrete. This new method is called the Koljern technique and uses cellular glass which is called Foamglas. The Foamglas is compounded to founding elements by lightweight steel beams. Foamglas is an insulation material with high compressive strength, and is rot, insect, vermin and acid proof. The cellular glass is also fire proof and watertight, which makes it a very good construction material.The report contains a study of a number of cases for which the Koljern technique is compared with a foundation of concrete.