The latest thing in the area of environmental building today is energy-plus-house. The idea behind the energy-plus-house is to create a house that produces more energy than it consumes. To accomplish this, the house uses renewable energy, in this particular case solar energy. With the help from a proper construction and thoughtfully projected installations you can achieve a surplus of energy. The surplus energy can then be sold to the surrounding buildings and thereby conduce to a financial profit for the household.

The purpose of this degree-project was to investigate the possibilities for primary air preheating into the two smallest waste incineration boilers of Halmstad Energy and Environment. The investigation is a pre-study which has the primary goal to evaluate technical and financial offers from companies that manufacture primary air preheater, and investigate if it is technically and financially profitable to do a purchase on primary air preheaters in the future.In the pre-study it is proposed that it is most efficient to have individual primary air preheater, one for each incineration boiler and the primary air are also proposed to be preheated by hot water in the pre-study. Further in the pre-study it is proposed that the heat-exchanger should have plain tubes instead of finned tubes, to avoid getting dirty fast. The space in the boiler-room is limited, and therefore the major problem was to fit in the primary air preheaters into the boiler-room. By comparing the different offers from the companies, the result in the pre-study shows that the offer from the company C.A.

The interest in small-scale electricity in Sweden has increased strongly in recent years. The interest is noticeable both among politicians to increase the share of renewables in the energy mix, and among electricity consumers to partially replace purchased electricity with self-produced. This has resulted in a significant increase of electricity production in low voltage grids in recent years, and the trend appears to continue in the coming years. The majority of the new production plants are solar cells, followed by wind turbines, and it is also in these the greatest efforts are made in this paper.Distributed generation is often seen as something positive since it will contribute to reduced transmission losses and reduced voltage drop in the networks, and that it increases the share of electricity from renewable sources. In cases where the grids are not strong enough, or in other ways not adapted to manage the installed production, power quality may be adversely affected.

The amount of cargo has since the 1970s increased in Sweden and the road traffic accounts for a large part of the transported volume. In Stockholm County the amount of cargo is calculated to be doubled in size from year 2001 to 2020 which means a greater need for transport is required. Much of these transports are being carried out by haulage companies of varying sizes which acts externally as carriers for their customers. All of this despite a greater awareness, laws and demands regarding environmental performance.The trend shows that the haulage industry in Sweden are moving towards fewer but larger haulage companies, which means that the competition is getting tougher for the smaller haulage companies. Smaller haulage companies and research about their competitive strategies is a neglected part of this industry.

Tomato production is a common and important agricultural activity in Nicaragua. During the last decades tomato producers have suffered great yield losses due to begomoviruses (family Geminiviridae). The genome of begomoviruses generally consists of two circular ssDNA components, DNA-A and DNA-B. Tomato yellow leaf curl virus (TYLCV) is an example of a begomovirus with only one component. An approach to manage the virus epidemics has been to breed a cultivar with begomovirus resistance genes, which have been transferred from wild tomato.

Purpose: My purpose of this study was to examine the factors that motivate Swedes to travel to Egypt and Thailand. To answer the question, I have used two questions.What are the factors that motivate Swedes to travel to Egypt and Thailand?What is the motive for Swedes choose to travel to destinations such as Egypt and Thailand?Method: The method I am using  is the qualitative method. The qualitative method has been processed through interviews of Swedish travelers, the Swedish travel agencies as well as Egypt and Thailand tourist agencies specializing in trips to Egypt and Thailand via phone and e-mail.Theory: The theory I am using are motivators and push-pull factors in achieving an understanding of the factors that influence choice for Swedes to travel to destinations such as Egypt and Thailand.Empiricism: The goal was to get a much more qualitative data from the response from the Swedish travel agencies, Egypt and Thailand tourist agency and Swedish travelers who have traveled to both of these destinations.Result: What I have come up with in my study is that the factors that motivate Swedish travelers to travel to Egypt and Thailand, is the warm climate, sun and sea, culture, variety, the cheap price situation and that there are activities for different age groups. This has led to the heat in both Egypt and Thailand has attracted Swedish travelers to travel to both destinations.

The objective of this paper is to estimate monetary and non-monetary costs for the huntercaused by deer-vehicle collisions in Sweden. These costs include losses in hunting value as wellas time and money efforts related to the handling of wildlife casualties. The calculations arebased on available statistics from 2004 on deer-vehicle collisions involving moose, deer, roedeerand wild boar and on telephone interviews with hunters involved in the tracking of injuredanimals. Altogether, the annual loss in hunting value for moose was assessed to approximately30 million SEK based on the 2004 accident statistics. For roe-deer and fallow deer, thecorresponding figure was approximately 56 million SEK and 1.2 million SEK, while wild boaraccounted for 1.3 million SEK, respectively.

A change towards using more biofuels than fossil fuels is taking place in Sweden, and in many other parts of the world. This makes the use of fuel pellets increasingly popular, causing a greater demand for sawmill sawdust products. There is a trend towards the use of multiple types of shredders, instead of a single type in each sawmill. The purpose of the study was to characterize the different flows of saw particles that can be found at Sävar såg when cutting thick or thin wood with different cutting techniques. The saw particles size, shape, moisture content and heat value were analysed by the cutting stations: first cutting fast and slow, second cutting fast and slow, grading fast and slow and planning.

Biogas is a renewable fuel that can be extracted from anaerobic digestion of many differentsubstrates, for example biological household waste. An alternative handling of the waste is tomix it with other wastes and incinerate it in a combined heat and power (CHP) plant. Thisstudy uses life cycle assessment to investigate which type of waste handling that is betterfrom an environmental point of view, anaerobic digestion with biogas production orincineration. The results are based on a case study of a biogas production plant owned by thecompany Ragn-Sells in Vänersborg. The alternative is incineration at a CHP plant inGothenburg.

The purpose of this degree-project was to investigate the possibilities for primary air preheating into the two smallest waste incineration boilers of Halmstad Energy and Environment. The investigation is a pre-study which has the primary goal to evaluate technical and financial offers from companies that manufacture primary air preheater, and investigate if it is technically and financially profitable to do a purchase on primary air preheaters in the future.In the pre-study it is proposed that it is most efficient to have individual primary air preheater, one for each incineration boiler and the primary air are also proposed to be preheated by hot water in the pre-study. Further in the pre-study it is proposed that the heat-exchanger should have plain tubes instead of finned tubes, to avoid getting dirty fast. The space in the boiler-room is limited, and therefore the major problem was to fit in the primary air preheaters into the boiler-room. By comparing the different offers from the companies, the result in the pre-study shows that the offer from the company C.A.

A common perception is that fungicide treatments increases yield, but that the nitrogen of the particular grain is diluted so that the overall removal of grain nitrogen from the field remains unchanged. The aim of this paper is to demonstrate that a healthy crop reduces the risk of nutrient loss from agricultural land. The results from genotype and plant protection trials often show constant nitrogen content in the grain, although the yield has been increased. Results from such experiments are therefore processed in order to confirm this and show that it is no statistically significant difference between the protein content (and also nitrogen content) in crops which have undergone fungicide treatment compared to crops which remained untreated. The trials processed have been carried out in the southernmost part of Sweden and are distinguished to concern winter wheat production.The explanation to the results is that a healthy crop is able to maintain the biological functions of the plant in a more efficient way than a crop damaged by a fungal infection.

The purpose of this degree-project was to investigate the possibilities for primary air preheating into the two smallest waste incineration boilers of Halmstad Energy and Environment. The investigation is a pre-study which has the primary goal to evaluate technical and financial offers from companies that manufacture primary air preheater, and investigate if it is technically and financially profitable to do a purchase on primary air preheaters in the future.In the pre-study it is proposed that it is most efficient to have individual primary air preheater, one for each incineration boiler and the primary air are also proposed to be preheated by hot water in the pre-study. Further in the pre-study it is proposed that the heat-exchanger should have plain tubes instead of finned tubes, to avoid getting dirty fast. The space in the boiler-room is limited, and therefore the major problem was to fit in the primary air preheaters into the boiler-room. By comparing the different offers from the companies, the result in the pre-study shows that the offer from the company C.A.

The purpose of this degree-project was to investigate the possibilities for primary air preheating into the two smallest waste incineration boilers of Halmstad Energy and Environment. The investigation is a pre-study which has the primary goal to evaluate technical and financial offers from companies that manufacture primary air preheater, and investigate if it is technically and financially profitable to do a purchase on primary air preheaters in the future.In the pre-study it is proposed that it is most efficient to have individual primary air preheater, one for each incineration boiler and the primary air are also proposed to be preheated by hot water in the pre-study. Further in the pre-study it is proposed that the heat-exchanger should have plain tubes instead of finned tubes, to avoid getting dirty fast. The space in the boiler-room is limited, and therefore the major problem was to fit in the primary air preheaters into the boiler-room. By comparing the different offers from the companies, the result in the pre-study shows that the offer from the company C.A.

In recent centuries the Swedish Tiled Stove has varied in its design with an aesthetic evolutionary history that has not only followed the architectural and artistic ideals but also the taste in stove design. The heat source has varied depending on the regional traditions and where it was located within the country, but the inside of the construction was of a similar five channel system. The purpose of this paper is to study and compare the design of tile matrices made by Emil Petterson with other Swedish stoves. The following questions will be addressed:What characterized the production of a small scale tile stove workroom during the years 1900-50? Which main styles can be described as Emil Pettersson?s ideal while producing his matrices? And finally, is it possible to study the tile stove matrices as objects of historical and cultural significance, and what difficult methodological issues might occur in the doing of it? To answer these questions I will present the results of the documentation of Pettersson?s tile matrices with detailed historical categorizations and schedules. The conclusion shows that Pettersson as a stove builder and -producer was characterized by eclectic ideals and a design shape based on more liberal interpretations of contemporary trends.

The master thesis ?Mechanical Integration of an IR-detector in a Micro Cooler? has beenperformed at FLIR Systems AB in Danderyd. FLIR Systems is a world leader in the design,manufacture and marketing of thermal imaging camera systems.The thesis project is divided into to two areas, Production Method and Noise.The Production Method concerns the positioning of a detector on the cold finger within the IRcamera.The detector has to be positiond with very high accuracy at the center of the cold finger,so it can be placed in line with the optical axis to avoid movement of the picture during zooming.The positioning of the detector is at present done with the help of specially designed guides on aplate on top of the cold finger. The design workes well but the special machining needed for thisplate is very expensive.The goal concerning the production method was to derive a new more cost effective method forthe assembling and positioning of the detector on the cold finger by replacing the guides on theplate with a reusable equipment or some other alignement operation.Several concept ideas have been generated with the help of concept generation methods in theform of concept classification trees and concept combinational tables. Two of these conceptswere selected to be further refined.