When establishing a groundwater protection area it is of great interest to be able to estimate the transit time of the groundwater from different places of the aquifer to the withdrawal well. These estimates can be uncertain due to heterogeneities in the aquifer. As a part of the work to develop methods for a more certain delineation of protection areas, a tracer test was performed in an esker located 25 kilometres NW of the town Uppsala.The purpose of this master thesis was to perform, describe and evaluate the tracer test. Travel times from the tracer test should then enable comparison against stochastic simulated travel times of the groundwater in the area.Three dyes (rhodamine WT, uranine and naphtionate) and a salt (NaBr) were used in the tracer test. The tracers were injected in four different wells located 25 meters from a pumping well.

Background: Examinations with the intent to assess neurological functions and level of conciousness are common in neurocritical care, but the effect on the patient is not entirely researched.Aim: The purpose of this study was to describe the patient?s situation at the neurological wake-up test concerning the environment, nursing interventions and the possibility given the patient to become awake, and if these conditions affect the outcome of the wake-up test.Methods: A quantitative observational study took place at a neurocritical care unit, where 20 patients were observed from interruption of sedation to the neurological assessment, which was performed by a neurosurgeon or a specialized critical care registered nurse. Nursing interventions, environmental factors and physiological parameters were documented.Result: Twelve intervention varieties to control patients? physiological parameters were used. CPP > 80 mmHg was found in 90 % of observations.

The student project Elba at KTH started in 2011 and is a project where a battery driven prototype car is developed. The vehicle competes in Eco Shell Marathon in Rotterdam, Holland. In this competition the vehicle that travels a certain distance including several starts and stops with the lowest energy consumption wins. To minimize the consumption is therefore very important, which requires knowledge of the vehicles energy losses.A vehicle's energy losses depends on several factors and can be divided into the powertrain efficiency and the driving resistance. The driving resistance can then be divided in to rolling and air resistance, if smaller losses like vibrations are ignored.

The aim of this essay is to investigate which of the goals in the syllabus, and with that what knowledge of Swedish, four students taking the SFI (Swedish for Immigrants) level 3 course believed themselves to have attained and to compare their self-assessments with their results on the National Test of Swedish for adult immigrants.The method used for the investigation is the individual interview. In addition to taking the National Test, the participants in the investigation were asked to mark the goals they believe themselves to have attained.The results show that the informants who best demonstrated awareness of their own knowledge are able to talk freely about their knowledge and difficulties, and when they mark the goals they believe they have attained, these correspond, on the whole, to how they responded in the interviews.One of the informants finds it more difficult than the others to assess her knowledge. A comparison between her experiences and the National Test results revealed several inconsistencies. For example, she claims that she can communicate in Swedish, but still she didn?t pass the test..

This thesis deals with different methods for measuring moisture-related dimensional changes ofwood. Typically relative humidity is measured to determine if the ambient climate around anobject is harmful to it or not. Values between 40 to 65% RH are recommended for hygroscopicmaterials. To know how a wooden object actually reacts to changes in the surroundingenvironment requires methods that involve the object itself. Because of the wood anisotropy,differences in wood structure, finishes and other restraints, it is not always possible to predict themovements.This paper addresses various measurement methods, primarily methods that have been testedin the field of conservation, with examples of their use.

The market-leading wage and PA-.system for the Swedish public sector Palasso is developed in Karlstad. In order to achieve the highest quality of code , the developing team behind Palasso has been conducting extensive testing. Testing is done to ensure that the software does what it should do. However, the testing has been done at a high level. In order to continue to evolve, the group that develops Palasso has started to look at the new development methods that have become popular in the computer industry in recent years.

The aim of the Master?s Thesis work is to study and develop algorithms for autonomous travel of a UGV (Unmanned Ground Vehicle). A vehicle for the mounting of sensors has been constructed in order to perform the work. Since the UGV is to be used outdoor in urban areas, GPS can be used. To improve precision and robustness, inertial navigation is used in addition to GPS, since GPS reception is likely to be diminished in such areas.

To measure losses in a transformer with today?s methods is either slow or insecure. There s a new method developed by Alstom that hasn't been actualize in to a test-system and that has been the assignment in this project. The idea is built on a switched system and a CLR- circuit in the resonant frequency. The test-system has a calculated power-loss that make the efficiency to be as high as 99,8% and in reality over 95%.

Different field tests are currently used in a wide extent in different levels of soccer teams. To be able to assess the players? physiological status the tests must have high validity, reliability and external validity. Many different tests have been developt, but currently only five of these tests are most commonly used: Yo-Yo intermittent recovery test (YIRT), Yo-Yo intermittent endurance test (YIET), Multi-sprint-test, Beep-test and Cooper-test. Presently there is no definitive conclusion regarding which of these tests is most suitable for soccer players.

Stunning of pigs at slaughter constitutes of primarily two methods; carbon dioxide and electricity. Both methods have advantages and disadvantages from an animal welfare point of view. The purpose of this study is to compare different methods of stunning pigs from a welfare point of view. Questions included in the study are 1) What differences are there, from an animal welfare point of view, between CO2 and electricity as methods for stunning pigs? 2) What alternatives are there to the methods currently in use? 3) Which method for stunning pigs is preferable from an animal welfare point of view?This report is a literature review.

Background: Since1994, the EU NickelDirective is limiting the release of nickel from objects that are in prolongedcontact with skin. Despite this, nickel is still the most common cause of contactallergy in industrialized countries. This could implicate that other productswith short contact to the skin, which are not restricted by EU´s legislation inREACH (Registration, Evaluation, Authorisation and Restriction of Chemicalsubstances), could be a source of nickel or cobalt exposure. There is no limitfor cobalt release within REACH. To determine if there is cobalt or nickelpresent on the surface of a material and if metal can be released in contactwith the skin, there are quantitative and qualitative methods, such as the DMG(dimethylglyoxime)-test, the cobalt spot-test and a method for releasedetermination according to EN1811.Objectives: Laptops are not included in the REACH legislation.

The purpose of the study was to investigate, through an experiment, if positive mood promotes creativity and flexible thinking. Participants were a total of 93 college students. The main hypothesis was that subjects induced with positive mood would perform better than subjects induced with negative mood, at a test reflecting creativity. To further explore the implications of priming (subliminal manipulated moods), a neutral control group was included. The cognitive test used in the study was Duncker´s The Candle Problem, a test which aims to get the subjects to apply flexible and creative thinking.

Dagens utveckling av mjukvara går snabbare och snabbare samtidigt som mjukvaran blir allt mer komplex. Att under dessa omständigheter kunna bibehålla en lika om inte högre kodkvalité är en utmaning. På UIQ bestämde de sig för att undersöka om ett automatiserat unit test kunde hjälpa dem. Metoderna för att komma fram till resultaten i denna rapport har varit intervjuer, en enkät, intern information och litteratur så som forskningsartiklar m.m. Denna rapport är en utredning av automatiserade test, vad man bör tänka på, vilka fördelarna är, vilka testfall som är möjliga att automatisera med mera. Rapporten kommer även att presentera grunderna i testning av mjukvara, en introduktion till eXtreme Programming och Test-Driven Development samt hur testningen utförs på UIQ idag. Då jag kom fram till att ett automatiserat unit test skulle passa sig bra på UIQ kommer jag i slutet av denna rapport presentera ett implementerings förslag. Man bör även införa en test driven utvecklings metodik för att säkerhetsställa att det kommer att utvecklas automatiserade testfall..

A growing problem in Swedish herbicide free agriculture, the Canadian thistle has been the object of several new trials, seeking methods for non-chemical weed control. The new trials have mainly confirmed earlier experiences; that the most successful methods of control are springtime ploughing, repeated cutting and competition from a stout crop. Row hoeing has also been proven effective. As opposed to earlier recommendations, half season fallow has shown to be a risky and often ineffective method of control. Trials regarding biological methods have shown that above others thistle rust (Puccinia punctiformis) may have the potential of controlling Canadian thistle the future. .

Osseointegrated titanium implants have become a commonly used method in edentulous jaws and today there are success rates in the magnitude of 82 % in the lower jaw and 98 % in the upper. During first year after implantation a fully normal marginal bone loss of 1-2 mm occurs. If the bone loss continues there is a risk of implant failure. High tensions in bone and inflammation caused by bacteria are possible reasons for this problem. It has been shown that a leakage of bacterias occurs between the parts of the implant and there are theories that this has effects on the marginal bone loss. The aim of this thesis has been to increase the knowledge about microbial leakage with help of in vitro tests and virtual simulations.