IntroductionSuccessful training is a key for athletes to make progress in their development. Training must not just involve overload, but also must prevent the combination of excessive overload plus inadequate recovery. Athletes can experience short-term performance decrement without severe psychological or lasting other negative symptoms. Too much hard exercise or too little sleep can cause overtraining, a condition in which the subject can prevent to be away from the sport for several weeks or months. Previous studies have detected that it is important to avoid overtraining.

Vertical hydropower units has a rotating mass of up to 1000 tons. For the generator and turbine to work well the rotating system is required to be centered in relation to the surrounding structure. This is achieved by means of radial bearings. The dynamic characteristics of these bearings have a strong impact on the overall rotational dynamics of the total system and thus influence the vibrations in the unit. At Vattenfall Research & Development in Älvkarleby ongoing research is taking place on how the bearing parameters should be represented in the rotor dynamic calculations.

I uppsatsen undersöks hur 11 globala miljö och/eller etiskt märkta fonder har presterat i jämfö-relse med 17 konventionella fonder i det svenska premiepensionsutbudet genom tillämpning av utvalda finansiella prestationsmått. Detta med anledning av att miljö och/eller etiskt märkta fonder har haft en stor framväxt under det senaste decenniet och det finns därför en efterfrå-gan av att klargöra ifall en pensionssparare behöver göra avkall på den finansiella avkastningen vid val av miljö och/eller etiskt märkta fonder. En jämförelse av det statliga förvalsalternativet och 10 globala miljö och/eller etiskt märkta fonder har även gjorts för att undersöka skillnaden av att vara en aktiv respektive passiv premiepensionssparare då antalet som inte gör ett aktivt val är omkring 50 procent. Resultatet visar ingen statistisk signifikant skillnad med avseende på den riskjusterade avkastningen mellan fonder som är miljö och/eller etiskt märkta och fonder som inte tar hänsyn till dessa kriterier vilket överensstämmer med tidigare forskning. I jämfö-relsen mellan det statliga förvalsalternativet och 10 globala miljö och/eller etiskt märkta fonder har det förstnämnda presterat på en hög nivå..

Hemoplus® (Sarstedt, Nümbrecht, Tyskland) is a guaiac-based fecal occult blood test developed for human medicine. Guaiac-based tests make use of the pseudoperoxidase activity of hemoglobin so the test is not specific for human hemoglobin and can therefore be used in veterinary medicine. Peroxidase-containing foods such as meat (hemoglobin and myoglobin) can cause false-positive results of the test. To ensure that a positive result is not caused by diet, it has been suggested that canine patients should be fed a meatless diet for a few days prior to fecal occult blood testing. The aim of this study was to evaluate the effect of commercial dog food on guaiac-based tests. In this study fecal samples from healthy dogs were analyzed with Hemoplus®.

Introduction: A complex interaction between muscles, tendons, bones, joints and nerves are required for optimal function of the human hand. It is known that an individual?s grip strength is vital for performance of physical demanding tasks such as strength training with free weights. Strength training including a thicker grip around the bar may enhance the strength of the grip in the athlete without other special routines for grip strength development. The purpose of this investigation was to examine the difference in performance in multiple repetitions in two strength training exercises using two different sizes on the bar, to look for correlations between grip strength of the subjects hand and the amount of repetitions executed with two different size of the bar and finally the correlation of hand size and the amount of repetitions executed with two different size of the bar.Method: 15 strength training men (23,9 ± 4,1 years), underwent measurements of hand size, maximum grip strength, 1 repetition maximum (1RM), a 80 % of 1RM weight strength test with two different  bar sizes.Results: The results from the present investigation indicates a 21,1 % reduction of 80 % of 1 RM weight performance in repetitions executed in the bench press with the thicker diameter of the bar and a 66,2 % reduction in repetitions executed with a 80 % of 1 RM weight in the lying bench row with the thicker diameter of the bar.

The main aim of this research was to investigate four humour styles, affiliative, self-enhancing, aggressive, and self-defeating humour, and compare these with emotional perception. Forty-eight persons took part in the research, 27 women and 21 men living in the southern part of Sweden. Two humour tests were used: the Humour Scale Questionnaire ? HSQ, with 32 items, and a newly composed video test, assembled after pilot testing from 26 video clips, the Humour Video Questionnaire ? HVQ. To measure perception and interpretation of emotion, the revised version of the ?Reading the Mind in the Eyes? Test was used.

Our purpose with this essay was to explore students? experiences of interdisciplinary working method in thematic form. With a starting point from Lpf-94, the curriculum for the upper secondary school and several theories of learning, we wanted to explore if interdisciplinary working method in practice could create an environment for a meaningful learning situation. The study took place in an upper secondary school class, study preparatory, third grade, who works interdisciplinary in thematic form. Our study was qualitative and we used an open structural questionnaire where the students confidentially were able to describe the working method, explain which subjects that participate in the work, and bring forward good respectively bad factors about the method.

When harvesteing ley there is always mechanical losses from the harvest machines. During the last years the roundbalers with knives,cutting the material-are more common, This use increase the mechanical losses of material. MATERIALS AND METHODS The roundbaler which used in this test was a Krone Vario Pack 1500 Multi Cut. This roundbaler has 17 knives. The theoretical length of cut was 64 mm. During the test we stretched a rubber tarp under the balechamber and collected the materials which fell down from the balechamber.

AbstractThe present thesis examines reading acquisition. The aim of the study is to gain a deepened understanding of various methods used for reading acquisition, how teachers? are dealing with these methods and what aspects require special attention. The overall research question of the thesis is: How can one assess children?s future reading ability and identify a method that is appropriate to this ability? The overall aim leads to several more specifically addressed issues.In the theoretical part, different perspectives and theories about reading acquisition are presented along with different methods for how to work in order to facilitate reading.

An investigation of the heat impact of laser cutting on the material properties when producing tensile and impact test specimens of different steel types of varying thickness has been performed. The purpose of the thesis project was to provide recommendations regarding how much material that needs to be milled from the laser cut edge before tensile and impact tests. The study has been performed partly by investigating the test specimens by heat camera when the specimens were cut in the laser cutting line and partly by performing hardness tests, investigation by microscopy, and tolerance and roughness measurements and tensile tests of the laser cut material and material produced in the traditional multi operation machine. The results show that the heat affected zone in the thicker materials is greater than previously thought of, and that the currently used recommendation has to be adjusted. The study clearly shows that the thicker the material, the greater the heat affected zone, independently of the steel type, since the thicker material takes longer time to cut.

The purpose of this study is to create a method that can be used to produce decision supportdata for the climate goals of a municipality. The method should be able to demonstrate the potential for reducing energy use and greenhouse gas emissions for measures aimed at the stationary energy system in the municipality. It will be used to make long term projections of energy use and greenhouse gas emissions in order to be able to demonstrate the ability to reach climate goals. The aim was also to test the method's applicability by using the municipality of Uppsala and the Uppsala climate protocol project in a case study. Uppsala climate protocol is a project consisting of participants from business, government and organizations that voluntarily want to commit to reducing their carbon footprint by reducing their energy use and thus work to achieve the municipality's overall climate goal.

In order to be able to change, to maintain competitiveness as a company in a world where rapid changes is part of the daily life, it is crucial to have knowledge and methods in how to change. One method, originally developed in Finland, is the Change Laboratory. This method is said to be efficient, not only concerning change aspects but also learning, since change and learning in this method is intertwined. This Master Thesis (20p.) tells about the process of conducting a Change Laboratory with a Swedish high-tech company and analyses factors in the process that makes change possible..

Antalet kretskort som monteras i multikortssystem, till exempel telekommunikationssystem, ökar ständigt. Samtidigt som ytmonteringstekniken och packningstekniken blir allt bättre utvecklas även tillverkningsmetoderna för olika integrerade komponenter, vilket medför att varje kretskort rymmer allt fler integrerade komponenter. Detta gör att testning av integrerade komponenter och multikortsystem blir alltmer komplex. En förutsättning för att kunna genomföra effektiv testning är standarder. Standarder över hur testning ska genomföras medför att en komponent som uppfyller kraven från en standard är direkt utbytbar mot en komponent från en annan tillverkare som uppfyller kraven från samma standard.

The purpose of this essay is to describe how Boverkets Byggregler has affected the cost ofnewly built houses from 2003 to 2012, to Boverkets Vision 2025. The purpose is also to findagent-principal relations in the construction sector.When investing in an energy efficient house the operating costs are reduced compared to aconventional house. But due to the lower operating costs, the investment cost rises. In thisstudy, we find out if it is economically viable to invest in an energy efficient house comparedto a conventional house from the customer's perspective.The study's approach has been qualitatively where we in collaboration with Derome Hus hadaccess to three conventional reference houses and a passive house and data that was necessaryto conduct viability assessments on houses. We conducted five interviews with people fromDeromekoncernen and Varbergs kommun.The calculation methods we have used in this study are present value method, annuity methodand a sensitivity analysis.

Goal: To describe which evaluation method is used by Swedish retailers to assess a potential retail location and to describe to what extent the retail brand effects this strategic decision. Design: Analysis of ten interviews with companies within five retail sectors in Sweden. Main study: Indication of what methods are used to evaluate a location and how a company's retail brand affects the decision. Results: Retailers use a mix of theoretical methods to evaluate the location attributes and possible profit. Most common among mixtures was an application of the analog method, residual method or the checklist method in combination with a financial assessment.