The aim of this study is to investigate oral peer review on argumentative speech and to study the attitudes towards this peer review. The investigation was performed in an up-per secondary school class, and it focused on the different types of oral responses students give each other. In addition, the study investigated in what way the students experience this type of peer review. The results show that students reflect on form and performance as well as content, but they place more emphasis on form and performance than content. Students are positive about peer review and its importance for their progress.

A Swedish electronics company wants to make the cooling of one of their electronic components more efficient. They propose that a retrofit liquid cooler is the way to achieve this goal. The current air cooling has high energy cost due to the high amount of power needed to power fans and heat exchangers. Using high volumes of air for cooling also leads to noise pollution. The conversion from air to liquid cooling would possibly make the operation of the electronics more cost efficient and less noisy.The purpose of this project is to theoretically evaluate different concepts of drawing the heat generated by the electronic component in to a fluid, using numerical calculations in Matlab and FEM simulations in ANSYS.

This report is the written documentation of a project work carried out at the Division of Engineering Materials at Luleå University of Technology in cooperation with Seco Tools AB. The project deals with the analysis of residual stresses in Ti-Al-N thin film grown on WC/Co cutting inserts. The composition of Al varied from 0% up to 75%. Increasing the Al content in the Ti(1-x)Alx N compound improves the compressive residual stresses even after annealing of the material. The experiments have been performed in a high temperature x-ray diffractometer (HTXRD) where the interplanar atomic spacing was determined in-situ and subsequent converted into stresses.

The aim of this study was to increase the knowledge about whooper swan (Cygnus cygnus) ecology to enhance the ability to predict and also to prevent the crop damage they cause. The largest proportion of damage in Sweden has been reported at stopover sites during spring migration in February, March and April. Therefore, this study focused on an important stopover site, Lake Tysslingen, situated in south-central Sweden. Specifically, the relation between the duration and period migrating swans stage at the stopover site and mean temperature (measured at three different weather stations) for the years 2001-2010 was studied. Furthermore, the swans´ selection for certain fields in relation to field type, distance to roosting site, a supplemental feeding site and forest edge within agricultural land surrounding the lake was analyzed.

The aim of this study was to increase the knowledge about whooper swan (Cygnus cygnus) ecology to enhance the ability to predict and also to prevent the crop damage they cause. The largest proportion of damage in Sweden has been reported at stopover sites during spring migration in February, March and April. Therefore, this study focused on an important stopover site, Lake Tysslingen, situated in south-central Sweden. Specifically, the relation between the duration and period migrating swans stage at the stopover site and mean temperature (measured at three different weather stations) for the years 2001-2010 was studied. Furthermore, the swans´ selection for certain fields in relation to field type, distance to roosting site, a supplemental feeding site and forest edge within agricultural land surrounding the lake was analyzed.

The Smart Grid technology has during the last decade been established as a way to create a greater flexibility on the electricity grid that will be needed as the development moves towards an increased share of renewable primary energy sources in the electricity production. One part of the Smart Grid technology is the ability to shift loads in time, to adapt to either price or emissions, known as Demand Response. This project, which was conducted at KTH in collaboration with the consulting corporation Capgemini, examines the economic, environmental and social aspects of the Demand Response technology. In the project, three household products are used in a model that derives the potential savings in costs and emissions of CO2e. The results show that the actual savings measured in SEK are small, but that the savings measured in percent can be as high as 20 percent. Reduction of CO2e emissions is slightly lower.

ABSTRACT: Commercial swab transport systems are used for collection and transporting of fecal and other microbiological samples. This system must maintain viability and contribute to survival of microorganisms during transport to the laboratory. Four swab transport systems have been compared, eSwab, ?- Transwab and fecalSwab, all three with flocked swabs, and Copan Venturi Transystem with rayon swabs. The study followed the recommendations from the Clinical Laboratory Standard Institute; document M40-A for recovery of Samonella, Shigella, Yersinia and Neisseria gonorrhoeae after storage for 0, 6, 24, 48 and 72 h at room- (22-25°C) and refrigerated (2-8ºC) temperature.

The Smart Grid technology has during the last decade been established as a way to create a greater flexibility on the electricity grid that will be needed as the development moves towards an increased share of renewable primary energy sources in the electricity production. One part of the Smart Grid technology is the ability to shift loads in time, to adapt to either price or emissions, known as Demand Response. This project, which was conducted at KTH in collaboration with the consulting corporation Capgemini, examines the economic, environmental and social aspects of the Demand Response technology. In the project, three household products are used in a model that derives the potential savings in costs and emissions of CO2e. The results show that the actual savings measured in SEK are small, but that the savings measured in percent can be as high as 20 percent. Reduction of CO2e emissions is slightly lower.

The dissertation were performed on SP, Technical Institute of Sweden. The dissertation were carried out on the measurement technical department, this dissertation is a part of a bigger project, project ClampCal. One of SP?s returning assignments are flow-measurement. When flow-measurement is performed, the flow has to be stopped so that a meter can be installed in the pipes where measurement is going to take place. At every stop there is time delay in the flow which causes the customers to loose money. This is why SP wanted to find a better solution so that measurement can be done without any stops in the flow. Usage of a so-called Clamp-on meter was considered, but since the measurement uncertainty is too large it takes some investigation on the parts where the largest uncertainties occur and thus find a solution that can diminish the uncertainty as much as possible. The parts that were considered to have an opportunity to reduce measurement uncertainties were the fluid temperature, its characteristics and the pipe geometry and its characteristics. For the fluid temperature a Pt100-sensor with four different radii for various pipes was used.

A well known optimization-problem of multiprocessor system is scheduling of tasks. In this paper I use a variant of previous known algoritm, (Fast Critical Path) for scheduling real-time tasks on a multiprocessor system. This is made in a simulation study in MATLAB. The system architecture is assumed to be a MIMD- machine, (Multiple Instruction stream Multiple Data stream) with bus-typologi and message-architecture. Scheduling was made on this system where the number of processors varying from five to ten.

A crisis situation that has been more commonly occurred in the industry of conveniencegoods lately is the product related crises which thereby has become a challenge for everymarketer to handle. As the negative publicity tend to enlarge the crisis and spread to thecategory as a whole, it's not only important to have a crisis management to handle crisesconcerning the company itself. But also to be ready to make the best out of the situationwhere the company is threatened to get infected by the negative effects caused by acompetitor.When companies get the chance to make a response on the negative publicity on theircompetitor, as well as the category, through media, the question is - shall they act And howshall they act Which response is the most effective to send out to get out of involvement, notget infected by negative spill over's or even - to make the valenced comparison a way togenerate positive effects and gain market share The purpose of this paper is thereby to find the optimal strategy for an organization in theindustry to handle their competitor's crises through a pronouncement in media. Anotherpurpose to address is whether the brand strength is moderating the effects from the differenttypes of responses tested in this study. This purpose aims to find guidelines depending onthese moderating effects.The paper commodiously, strongly supports that there are beneficial effects to be generatedfrom making a response in either positive or negative direction in oppose of actively choosingnot to make a pronouncement at all.

ABSTRACT: Commercial swab transport systems are used for collection and transporting of fecal and other microbiological samples. This system must maintain viability and contribute to survival of microorganisms during transport to the laboratory. Four swab transport systems have been compared, eSwab, ?- Transwab and fecalSwab, all three with flocked swabs, and Copan Venturi Transystem with rayon swabs. The study followed the recommendations from the Clinical Laboratory Standard Institute; document M40-A for recovery of Samonella, Shigella, Yersinia and Neisseria gonorrhoeae after storage for 0, 6, 24, 48 and 72 h at room- (22-25°C) and refrigerated (2-8ºC) temperature.

Composting is a process in which organic matter is mineralized by microorganisms. In January 2005 landfilling of organic waste was prohibited in Sweden. With this prohibition composting has become an important alternative to handle the produced organic wastes. One problem with continuous small-scale composting is the production of organic acids that will inhibit a further composting process. The aim of these theses was to study what effects temperature and dry matter content had on the production of organics acids, and what effect the organic acids had on the mineralisation of the substrate as well as the stability during storage of the product.

The Smart Grid technology has during the last decade been established as a way to create a greater flexibility on the electricity grid that will be needed as the development moves towards an increased share of renewable primary energy sources in the electricity production. One part of the Smart Grid technology is the ability to shift loads in time, to adapt to either price or emissions, known as Demand Response. This project, which was conducted at KTH in collaboration with the consulting corporation Capgemini, examines the economic, environmental and social aspects of the Demand Response technology. In the project, three household products are used in a model that derives the potential savings in costs and emissions of CO2e. The results show that the actual savings measured in SEK are small, but that the savings measured in percent can be as high as 20 percent. Reduction of CO2e emissions is slightly lower.

Deep litter is a system for animals kept in separate stalls, loafing and bedding in wind shelters. The litter can consist of different bedding, like straw and peat. The system is allowed to build over and to ensure optimal proportions it is necessary to add new straw regularly and to have good conditions. Important conditions are aerobic state, humidity, amount of organic substance and acceptable temperatures in the litter. The micro organisms are depending on temperature for their living conditions and to get the bottom layer in the litter to start burning.