Cooling down the indoor air can be done in several ways. One way is desiccantcooling which will be used at the Stockholm Arena. This method is used in airhandling units that use temperature changes and moisture fluctuations in the air. Oneof the steps is to add heat during the cooling process in order to reduce the relativehumidity of the exhaust air. The air passes thru an adsorptions rotor which thenabsorbs moisture from the supply air.

This EEF-project is a part of a larger project at SLU, Division of Reproduction, Dept of Clinical Science, with the intention of developing and evaluating new methods for the assessment of stallion semen quality. Over the last 10 years there has been an increase in the use of artificial insemination with cooled semen in Swedish horse breeding. At the same time, foaling rates have decreased. This has lead to a need for new and better methods of assessing the quality of stallion semen. This EEF-project was based on an objective method to calculate motility, with QualispermTM, in fresh and cooled stallion semen, and after selection. Today sperm motility evaluation is mainly done subjectively by visual assessment with a light microscope, and the correlation between these motility results and fertility have varied.

This thesis is a study of humidity at Knauf Danogips external plasterboard. The study is performed at the building project Kv. Maskinen in Jönköping in cooperation with NCC Construction AB and Knauf Danogips. The measuring was performed during five winter/spring months to see how the weather influenced the plasterboard.The measuring was performed at a small two-storied building and a larger fourstoried building. From the buildings` placement were a couple of measuring dots selected and to get a good result was the dots located in the four cardinal points.

In the spring of 2009 Silva Sweden AB was contacted for a collaboration within the scope of a MasterThesis project. The company had discussed the possibility to develop a device that monitors usermovement during different types of exercise. The objective of this Master Thesis has therefore been todevelop and design a multi training device that records the user?s physical performance during severalactivities. The purpose of the thesis project has been to use scientific methods for product development inorder to design a multi device that supplements Silva?s range of products.The project followed a product development process divided into four phases; Market Analysis, ConceptCreation, Concept Development and Construction.

This thesis work has been performed at the department of diagnosis and dependability at Volvo Car Company, Torslanda. The background of this project is based on interest in ascertaining how different factors possibly can affect a diagnosis method, which has been developed to find leaks in the fuel tank and evaporation system. According to the OBD II requirements leaks with an orifice diameter larger or equal to 0,5 mm, must be detected. The idea of the diagnosis method is to create an over pressure in the system with an air-pump. The current through the pump is measured and correlates to the power consumed by the pump.

The Swedish prehospital/ambulance organization has the last decades evolved from a transport organization to a an organization that focus on alleviate and treating acute medical conditions in the field as well as transporting patient to the emergency ward. The ambulance service is developing continually and offers today a high-tech and highly specialized nursing/care. Which in turn demand a higher standard and competence on the care provider. Ambulance mission can vary in priority and magnitude. This in turn demand a high medical competence our capacity.

This project consists of an adaptation, trial and evaluation of a model for practicing. Based on prior research I created a model aiming mainly to raise a musician?s self- awareness around the different parameters a performance consists of. An additional wish was for it to simultaneously assist the musician in monitoring his or her progress. With video recording and self-evaluation as the two main parts I tried the model by using it over a period of three months.

Ever since ABB has begun diecasting their rotors instead of permanent mold casting it,variation in the quality of the cast has arisen. Diecasting is performed in three differentmachines, M1, M2, M3 with 400, 660 respectively 800 tons of die locking pressures.The aim of this thesis is to answer the following questions:What is the ?right? cast quality? How is the right quality achieved?For sizes 160-180 solutions will be proposed that consider eccentricity between thelaminate and the short circuit ring as well as elimination of the thin Al film that appearson the outer periphery of the rotors.Through considering the statistic material the most often diverging rotor type has beenidentified and one of the actual rotors has been sent to a laboratory to be analyzed inorder to establish the current defects. The result of the analysis shows that there areplenty of gas- and oxide-porosity.It has been proved that every time the dies temperature decreased below 120°C thecontent of gas porosity increased. It is due to rapid solidification of metal that flowsthrough the ?cold? laminate.It has confirmed that enhanced porosity in squirrel cage causes high impedance in therotors.

Diabetes mellitus is characterised by persistent hyperglycemia in all species. Fructosamine is a glycated protein reflecting blood glucose concentration during the preceding weeks. It has become a valuable analysis to differentiate persistent hyperglycemia from transient stress induced hyperglycemia in cats. It is also used to evaluate current therapy in diabetic patients. Although fructosamine is a well accepted analysis, it is sometimes regarded with scepticism.

SummaryIn the area to the east of Hue city, in Vietnam, lays Tam Giang lagoon, one of Asia's largest lagoons, with an area of 22,000 hectares. This lagoon is suitable for aquaculture. One reason for this is because the salinity differs from sweet to salty in different parts of the lagoon. The Vietnamese Government advocates an increase in environmentally-friendly aquaculture and the fish Siganus guttatus (Rabbit fish) is a candidate for this. This fish eats mainly algae and can be cultivated in a polyculture.

Beans are a global source of plant-based protein, and in some countries, they constitute a primary source of protein intake. With ongoing climate change, including rising temperatures, it is necessary to adapt beans to ensure a reliable food supply. An important mechanism that many plants have, to cope with high temperatures, is cooling through transpiration. During transpiration, stomata open and release water vapor. Water molecules use heat energy from the leaf to convert into gas, thereby cooling the leaf.

Syftet med denna studie var att utvärdera Perrongen, en insats med kvalificerade kontaktpersoner för ungdomar i riskzonen för missbruk eller social problematik, och följa upp de ungdomar som medverkat i insatsen. 8 ungdomar deltog i den kvalitativa studien, och intervjuades under ungefär en timme vardera om deras bakgrund, insatstid och om livet efter insatsen med utgångs-punkt i ungdomarnas familj och nätverk. Resultatet var övervägande positivt, och samtliga ungdomar lever idag ett, i olika grader, betydligt mer hälsosamt liv än vid perioden för insatsen. .

This master thesis was carried out for Saab Avitronics, a business unit of Saab ABactive in electronic systems for military aircrafts. Reliability and weight are of crucialimportance in this environment. To improve reliability and lower the weight graphitemay be used for electronics cooling. Graphite is an anisotropic material and hasthereof high thermal conductivity in two directions (in-plane) and a relatively lowconductivity in the third direction (through thickness).The purpose of this thesis was to investigate if graphite is an adequate thermalconductor to use in PCB carriers. The carriers support and cool the PCB by divertingthe heat dissipation from the PCB components to the edge.

Stem rust, Puccinia graminis, has caused enormous yield losses throughout history which have had significant consequences for oat and wheat production. Today in Sweden stem rust is only reported from rye, oats and wild grasses. Stem rust infections in wheat have become unusual due to the general use of resistant wheat varieties and also due to the eradication of barberry, Berberis vulgaris, the alternate host for P. graminis. According to international sources, new races of P.

Periods of hypoxia are a recurring issue in Brunnsviken. Main factors that trigger hypoxia in Brunnsviken are eutrophication  due to anthropogenic emission of nutrients, stratification in the water column due to salinity and temperature differences  that prevents mixing and a sill inlet that prevents water exchange. As an attempt to improve the oxygen levels, bottom water is pumped from Brunnsviken causing aerated surface water to flow back into the basin.  The objective of this Master?s thesis was to study the change in dissolved oxygen levels due to pumping.