This master?s paper first presents some of the principal theories and concepts developed by the poverty researchers Rowntree, Titmuss, Townsend, Sen and Lister. These theoretical frameworks are then related to two documents from the EU and Sweden concerning combating poverty and social exclusion, bearing on the establishment of the ?Year 2010 against Poverty?. Finally, I discuss the value in practice of these theories and policy documents, as regards reducing poverty in Europe.It has become clear in this investigation that the theories and concepts from earlier research are still relevant to the formulation of contemporary policy programmes, and that earlier research helps us to avoid old traps in fighting poverty.

A system for sampling of alcohol and aldehyde from diluted exhaust gases from vehicles powered by ethanol has been developed and tested. The major part of the work has been research of earlier work in the field and the construction of the sampling system.The part of the system constructed for the measurement of alcohol has been shown to work, however, more test should be performed. The part of the system constructed for the measurement of aldehyde was tested parallel to a commercially available system, based on the same principle of measurement, and has been shown to work well.Determination of the concentration of gaseous ethanol using a FID has shown the since earlier known fact that a FID is not able to measure a correct concentration of ethanol. Furthermore it has been shown that high concentrations of gaseous ethanol can not be kept in a bag more than a few minutes without a substantial decrease of the measured concentration..

A cars powertrain consists of everything that is needed for its propulsion. The components in the driveline that transfer the power from the engine to the driven wheels are not absolutely stiff, hence they will wind up due to the torque and act as torsion springs. If you suddenly demand a bigger torque by stepping on the accelerator pedal, a so called tip in manoeuvre, and that torque is acquired from the engine as quickly as possible, the driveline will not be able to transfer that fast torque change due to its weakness and as a result it will start to oscillate. These oscillations will be transferred to the driven wheels and make the car to accelerate jerkily which will be experienced as uncomfortable by the passengers. Furthermore, there is a backlash in the driveline that will make the weakness in the driveline even more excited than it should have been if the backlash did not existed.To avoid too big problems with these oscillations there is a control system that controls the demanded torque.

When developing software that is meant to be distributed over several different computers and several different networks while still working together against a common goal there is a challenge in testing how updates within a single component will affect the system as a whole. Even if the performance of that specific component increases that is no guarantee for the increased performance of the entire system. Traditional methods of testing software becomes both hard and tedious when several different machines has to be involved for a single test and all of those machines has to be synchronized as well.This thesis has resulted in an exemplary application suite for testing distributed software. The thesis describes the method used for implementation as well as a description of the actual application suite that was developed. During the development several important factors and improvements for such a system was identified, which are described at the end of the thesis even though some of them never made it into the actual implementation.

As companies grow, their need for computing power will increase, which traditionally resulted in companies having to invest in more IT resources. Now, with cloud computing, companies can easily hire computer power over the Internet, on-demand. Cloud computing offers a highly scalable environment where companies can store data and host their services. This paper employs a qualitative study with interviews and literature studies to explore opportunities and challenges associated with cloud computing from a system developer perspective. The aim of the paper is to find out how cloud computing changes the conditions for system development. The paper contributes with four different opportunities and challenges that the system developer must handle to succeed in the world of cloud computing.

Title: Det nya Ryssland - En inblick over Rysslands utrikespolitik under 2000-taletAuthor: Tim Balder and Jens KindhLinnaeus UniversityDepartment of Political ScienceAutumn term 2011The purpose of this thesis is to gain a better understanding of how the Russian foreign policy is, how it is conducted and how it may develop in the future. To do that, we are going to try to answer the following questions:What characterizes Russia's official foreign policy?What theories are there for the Russian foreign policy?How can the various theories explain the Russian foreign policy actions at the international level?Our theory is to try explaining how the Russian foreign policy is continuing its development during the 21st century through three theories known as the Western liberalism, Pragmatic nationalism and Fundamental nationalism. Furthermore, to explain Russia's foreign policy and their behaviour, we are going to use the two foreign policy doctrines from 2000 and 2008. In addition, books and articles will also be used to explain how Russia's foreign policy is conducted and developed..

A large amount of our time is spent indoors in an artificial climate. To make the experience pleasant there are requirements on the ventilation and the heating system. At the present time the most common form of heating is a radiator system complemented with a ventilation system. A ceiling heating system with combined heating and ventilation can replace the two separated systems. The benefit with a ceiling heating solution is that it saves space since the radiator system is no longer needed.

The thesis describes a completely new biofuel system to generate particle-free heat from combustion of ash-containing biofuel particles at high temperatures.The suggested system gives opportunities to introduce biofuels in new areas.Main components in the suggested system is a heat radiating combustion chamber intended for pulverized wood, combined with regenerators to extract heat from flue gases and simultaneously preheating the combustion air.The thesis contains a description of the suggested system, theoretical considerations, calculations regarding the combustion, and includes results from tests performed.The results from calculations and tests performed concludes that the system is workable and possible to apply..

Syftet med undersökningen är att ta reda på om begreppet ?Tekniska system? tas upp i förskolan. Dessutom undersöks hur förskolorna arbetar med teknik enligt den reviderade läroplanen, Lpfö 98.Som metod användes enkäter där pedagoger satt i arbetslagsgrupper och besvarade frågor. Enkäten används för att få en bättre bild av hur ålder, kön, tidigare utbildningar och yrkeserfarenhet förhåller sig till kunskapen av teknikämnet.Undersökningen visar att alla förskolor använde sig av begreppet tekniska system på ett eller annat sätt i samtal med barnen, till exempel vid toalettbesök, samt frågor ?vart tar rören vägen vidare till reningsverket??Vidare framkommer det att fler fortbildningsdagar och studiebesök är önskvärt för att pedagogerna ska få en större vetskap om begreppet tekniska system.

There are certain organizations that manage to handle risk in such a successful way that they almost stay error-free, in spite of the fact that they daily face the risks of accidents. These organizations are usually given the name High Reliability Organizations (HRO). While the most common example is that of a nuclear plant the variety of what organizations can fit into the category is extensive.The purpose of this study is to describe safety culture and theories about HRO and how these can be found in practise within an organization.This qualitative research uses influences of ethnography in its method. The ethnographical approach was picked due to the field of the study and the cultural context in which it is set.The results of the study identify a number of elements sorted into four themes. These themes are deemed compatible or non-compatible with relevant existing theories.

Reading difficulties is the most common learning difficulty in the western world and it is common that people with reading disabilities also exhibit arithmetic difficulties. Different theories about the cause of the relationship exists, one theory describes the importance of good phonological ability in reading as well as in arithmetic, while another theory describes the importance of a reliable number system and that only a subgroup of students with reading disabilities also have difficulties with arithmetic. The purpose of this study is to investigate how students with reading difficulties (RD), without any known mathematical difficulties, perform on mathematical tasks relative to a control group. The study was theoretically grounded on the Triple code model (Dehaene, 1992), which is a model for numerical information processing that describes how various numerical and arithmetic tasks are processed through three distinct representation systems in the brain, a verbal and a visual representation system and a quantity system. Reading skills, phonological skills, arithmetic skills and number processing skills were examined in 61 students through a variety of tests.

The purpose of this Master thesis is to examine how college library managers perceive shelves of book reservation system in an integrity perspective. Privacy is an important part of everyday life in the society of today and according to some people, for example a former library lawyer in the Swedish Royal Library, these shelves conflicts with the Swedish law of Secrecy (Sekretesslagen 9 kap. 22 §). I am therefore interested in how they perceive this system: what weaknesses and strengths it has, why they implemented it, how they have interpreted this law. To answer this I have used a qualitative method called phenomenography and done interviews with five college library managers.

The study's aim is to create an understanding for the question why Sweden in 1921chose to create its own classification system for public libraries instead of adapting e.g.the Dewey-system which - at this time - was internationally we11 spread. It examines thesocial changes which proceeded the creation of the Swedish Library Association (SLA)in 1915 and discusses in depth the work of the committee appointed by SLA to createthe classification system. Special interest is also given to the relation between SLACSand the Dewey-system.The study shows that the main influence on the codttee's work was the formerSwedish tradition of classification practice. The Dewey-system was seen as inappropriateto adapt in the Swedish libraries because of the vast changes that wouldhave to be done, and the fact that the decimal notation was practically unused in anylibraries in Sweden.From a methodological point of view, the study tries to apply a critical hermeneuticalapproach as developed by Paul Ricoeur.The study contains an extended English summary..

Poverty among children has received a great deal of attention in the media the past few years. The group in which poverty among children has increased most is among single parents; therefore we have chosen to examine this group in this study. The purpose of this study is to take part in single parents and their children?s experiences of living within a very tight budget and the strategies they use. We found it interesting to put this information in relationship to the consumer society we live in today.

This thesis considers the development of the software for an, newly developed, embedded real-time control system, based on a Periferal Interface Controller (PIC). The control system is developed to be used for several different applications. In this thesis work, software for two different applications are developed. The first task is a time controlled system, while the other task is implementation of aPI-/PID-controller. A user interface is also developed and implemented.The time controlled system is an automatic horse feeder, which is used for feeding horses at certain predefined points in time.