When drivers overnight in the truck lots of electric energy is consumed by heaters, fans, lights and other extra equipment. If the engine is not running, this energy is taken from the lead/acid batteries of the truck which then needs to be recharged during operating hours. The fact that the charge acceptance of the lead/acid batteries is dependent on the temperature makes it hard to fully recharge the batteries at lower temperatures. A negative charge balance can lead to starting problems within a few days use in cold climate.In this thesis work, the effects of different battery charging concept are evaluated on the most common Scania battery (175Ah). A battery model is implemented in Matlab and some simulations of charging are made.

Periods of hypoxia are a recurring issue in Brunnsviken. Main factors that trigger hypoxia in Brunnsviken are eutrophication  due to anthropogenic emission of nutrients, stratification in the water column due to salinity and temperature differences  that prevents mixing and a sill inlet that prevents water exchange. As an attempt to improve the oxygen levels, bottom water is pumped from Brunnsviken causing aerated surface water to flow back into the basin.  The objective of this Master?s thesis was to study the change in dissolved oxygen levels due to pumping.

The master thesis, conducted at Metrima AB, concerns the development of a non-intrusivedistribution meter as a basis for individual tap water billing in apartments.The project is conducted in response to the market interest in individual tap water billing inapartments as an answer to environmental concerns regarding water consumption. Due to thehigh installation cost of traditional water meters, a new method of determining waterconsumption, without having to cut water pipes, is proposed.The proposed method distributes the total water consumption for an apartment complex toindividual apartments according to distribution meters, measuring water run-time, in eachapartment. The water run-time is estimated by measuring the water pipe?s outward vibrationsand temperature changes.A test environment was established and a prototype built, using a tilt- and vibration sensor forvibration sensing and a precision temperature sensor to measure temperature changes. As bothsensors work well in the test environment, further testing was done in 3 apartments for aduration of 5 days.

Lower energy use in buildings is a result of increasingly stringent energy requirements across Europe. When conventional district heating technology is used in areas with low energy consumption heatlosses do not fall even though the amount of energy delivered is reduced. This reduces income for thedistrict heating company. To maintain their economic viability the district heating companies? majorchallenge is to implement new solutions that minimize heat loss.

This degree project has been carried out by Carolina Rapp and Jenny Tauson, students at Innovation and Design Engineer program at the Faculty of Technology and science at Karlstad University. The project was carried during Spring of 2009 and took 15 weeks of full time work.  Doppelmayr/Garaventa Group is an Austria/Switzerland corporate group and its associated company Doppelmayr Scandinavia lies in Sunne, Sweden. Doppelmayr/Garaventa Group is the world quality and technology leader in ropeway engineering. The degree project goal was to develop a new shaping of a surface lift. There are two kinds of surface lifts, platter and T-bars. The two kinds of surface lifts have some variation in design but only minor differences.

Due to human influences on the climate an increase in Earth's mean temperature is today an accepted conception. With a rising temperature discussions have started how the climate in an area will change in the future. Equally interesting and important is it also to study the precipitation in an area. Precipitation is the factor, next to temperature, that affects most how a climate in an area looks like and feels. Since precipitation is connected to evaporation the latter parameter is also of interest to study.

The aim of this thesis is to improve the control of urea injection at the combined power and heating plant Framtidens Gärstad (FTG). Tekniska Verken i Linköping AB is the owner of the plant.The FTG plant consists of a boiler where garbage combustion is done. From the combustion nitrogen oxides are emitted. These nitrogen oxides are hazardous to the environment. To reduce the nitrogen oxides, injection of urea into the boiler is used.

This thesis is a part of the project "Sustainable harvesting and storage of sugar beets, more sugar to practice". The work has included a large part of practical experimental work with weight measurement, graduation and storage planning. The aim of the project is to be able to see whether the cultivars react differently in different storage conditions. The project has included storage under controlled conditions to give as accurate results as possible. To be able to mimic the farmers own preconditions the samples was harvested with a conventional Holmer.This project has two parts, one concerning the nature, time and temperature on storage where a number of different cultivars where investigated during three different recording times, two different temperatures and controlled in a controlled environment.

Ocean Thermal Energy Conversion, OTEC, a technology using the temperature difference between cold deep seawater and warm surface water, can extract the work in the form of electricity. OTEC gives also synergies of drinkable fresh water. The temperature difference has an impact on the efficiency of the technology, which means that the feasibility of OTEC is geographically limited. The project intends to explore the possibility of replacing the atoll Tarawa?s present electricity generation with an OTEC plant and to explore synergies. In the present situation all of Tarawa?s electricity is generated by fossil fuels.

Ocean Thermal Energy Conversion, OTEC, a technology using the temperature difference between cold deep seawater and warm surface water, can extract the work in the form of electricity. OTEC gives also synergies of drinkable fresh water. The temperature difference has an impact on the efficiency of the technology, which means that the feasibility of OTEC is geographically limited. The project intends to explore the possibility of replacing the atoll Tarawa?s present electricity generation with an OTEC plant and to explore synergies. In the present situation all of Tarawa?s electricity is generated by fossil fuels.

The Earths climate is changing at a higher rate, i.e between 1861 and 1994 the annual mean temperature in Scandinavia increased with 0,68º C and according to recent climate models the annual mean temperature is likely to rise with another 3º C during this century.A warmer climate in many ways is associated with changing conditions for lake ecosystems. An expected higher water temperature and a stronger summer stratification of the water column increases the risk of anoxic conditions at the lake bottom. Thus anoxic conditions are likely to cause a phosphate leakage from the sediment, i.e. a higher internal loading of phosphate.In this project, the extremely warm summer of 2002 has been used as an example for a possible scenario for a future climate. By comparing levels of phosphorus in the summer of 2002 with a ten-year median value, a phosphorus related sensitivity to climate change has been analyzed for 55 Swedish lakes.

AbstractWith increasing population and increasing demands for comfort and thus an increase in energy demand, it is necessary to examine various energy-efficiency measures. This work deals with the ability to control the flow through the heating system to achieve the desired comfort with as little energy as possibleA heating system contains of different parts, roughly speaking, you can divide it to three main components: Heat source, Distribution and Heat emitters. All components are working together to bring heat to the building. What is examined in this report are different ways of adjusting the flow and supply temperature and how it affects comfort and energy use in a building.At today ?s date the conventional method is to use a high flow through the heating system, which affects pressure drop and cooling of the fluid.

This is a paper about the effects from smoldering fire on lithic objects from an archaeological view. The introduction gives the background to this paper, a short orientation to forest wildfires and why the work is limited to: flint, quartz, quartzite and slate. Material and methods describes the stone materials and the setup that was used in the temperature logged tests with three replications for each type of material. The fuel in the burnings was peat on a bottom of sand. Flint showed a more drastic effect from heat compared with the other materials. Slate seems to have greater tendencies to change to darker colour and luster at lower temperatures than the other materials.

Energy price are on the way up to a high level that will not diminish in the future make us to focus more on the sustainable development for a better solution of residential houses. Passive house or low energy housing are one of the solution to make residential more environment friendly, in same time it´s a financial security using less energy, and saving money. The last 10 years in Germany and all around Europe the concept of passive house been developed, and people aim to know more about these concept that leading the market more attractive for passive houses. A passive house is a well designed building highly insulated and air tight with mechanical ventilated system for the whole building envelope that minimizes the use of energy for heating [1].The housing company Mimer has chosen to invest in low energy consumption in every new housing project.  These future plan projects are decided to use less than 75 kwh per square meter annually in purchased energy [2].This thesis is about new constructed passive houses, and focuses on the evaluations of the temperature, and moisture condition for attic, external walls and joist.

This thesis has been done at the Unversity of Örebro for Örebro University Hospital (USÖ). In our work we have developed a product for hearing tests to determine hearing thresholds of small children. Our product contains software and a control surface for controlling two separate screens. One of the demands was that our software could handle big file libraries. Reliability and simplicity were essential for the user.In our work we have utilized programming of both microcontrollers and Windows software.