Sweden's drinking water quality is considered to be high partly due to a high quality of the raw water and a well developed sewage infrastructure. Despite this, there is water contamination that could be prevented by installation of a sophisticated early warning system. Some of the major players in the production of drinking water have already invested in different types of early warning systems to ensure drinking water of high quality. There are various forms of early warning systems where automatic monitoring of E. Coli is an interesting alternative.

Aquatic organisms are usually not exposed to single substances but rather to mixtures of toxicants in streams located in agricultural areas. The transport of pesticides used in the agricultural area in Sweden is monitored with continuous environmental supervision every year. During 2002-2008 an average of 10 pesticides were found in each sample and 40% of the samples contained substances with concentrations higher than the Water Quality Standards. Chemical risk management is normally based on single-test evaluations. A problem when assessing mixture toxicities is that the constituents and concentrations of pollutants in the environment vary greatly.

This master thesis is developed based on the desire of the water and sewage department in the municipality of Karlskrona. The department, which vouches for the quality of produced drinking water and sewage cleaning, was in need of help dealing with risk analysis.The water and sewage department is obliged to identify and assess risks according to Swedish legislation. However, no guides for this purpose regarding safety, health, environment and quality were available. The aim of this report was to accomplish a guideline for the performance of risk analysis within water and sewage plants. If the guideline is used, the requirements in the legislation will be obtained.

Students? performance in school is dependent on the indoor climate. This report studies four schools regarding air quality and thermal environment. A survey was made at the schools as well as measurements of carbon dioxide, dampness, thermal climate and, as an indicator for the furniture?s capability to collect dust, shelf factor and fleece factor.

The plants in the genus Elatine are characteristic for oligo and mesotrophic lakes. This study focuses on Elatine hexandra one of the four species in Sweden. It is stated as vulnerable by the National Environment Agency and a conservation plan with guidelines to preserve the plant in Sweden is under preparation. There have been a few previous studies investigating this plant in other countries but this is the first one for Sweden. The aim of this study was to investigate the distribution, growth and reproduction of E.

This report investigates a possible solution to the problem with adapting wave powerplants to work in countries with tidal water. The wire connecting the buoy at the surface with the generator at the bottom needs to adjust to the varying water depth. Our solution to this problem is to attach the wire to a jack which is then placed inside the buoy. The jack is then powered by an electric engine. The report discuss what forces the buoy will be exposed to and then the structural integrity of the design is evaluated through simulations.

We are always surrounded by space, not just only in a room with four walls, but also when we are outdoors.Constantly we move in a flow of space that changes whenever we move. Unaware we are affectedby this threedimensional surrounding of ours, and it reacts with our perception. Many times, we chooseto translate it into something two-dimensional, for example when we take a photo, recording a movie orframing a view with a window. It helps us to catch a moment, a piece of reality and restore it in our ownway. In this project I?ve chosen to explore this process, to interpret and create my own theories about thistranslation from space to a two-dimensional surface.

I want to find the meaning of food ?potato in today?s society. How about marketing and how does potato consumes? What can be done to achieve better competitiveness towards other products now and in the future? I will build this project on a statistic ground ?now and then? as well as a study to people outside various food- markets. The consumers answers will state my foundation in this project.

The thesis presented in this report has been made on behalf of Scania and their basic frame design department with the subject to solve an implementation of a weight sensing system in the chassis. The system is supposed to be implemented in the seat springs, and the reason for this is that all the force will have to go through the weight sensing transducers. With all the force going through the transducers the weight sensing system will not be sensitive for the differences in tolerances from manufacturing. The transducers could be pre-calibrated to avoid a calibration of the whole vehicle after it?s completed from the manufacturing line.Weight sensing systems is today a reality in trucks with air springs.

Nanofiltration is a proper way of preparation of drinking water. The process has a lot in common with reverse osmosis where a semipermeable membrane is used to separate a pure water flow from the remaining water. A pilot plant was used to ensure that nanofiltration is a suitable technology for a specific waterworks station in Glemmingebro, Ystad. The purpose was also to find out if a pH-adjustment is needed for feed water in a possible full scale plant.  In this case nanofiltration is used mainly to remove sulphate and calcium since the raw water contains concentrations of these substances which exceed the limits for potable water. It is important to receive a high recovery (RC), otherwise the deliviery of water won?t be high enough.

This paper, from Hallwylska museum collections to the exhibition ?Beneath the surface ... The Unmentionableat the turn of the 20th Century? is a survey of how the Hallwylska museum on the basis of its collections createsa temporary exhibition. The paper is focusing on how Wilhelmina von Hallwyl`s collections together with theexhibitor`s different intentions from the exhition.

Aquatic organisms are usually not exposed to single substances but rather to mixtures of toxicants in streams located in agricultural areas. The transport of pesticides used in the agricultural area in Sweden is monitored with continuous environmental supervision every year. During 2002-2008 an average of 10 pesticides were found in each sample and 40% of the samples contained substances with concentrations higher than the Water Quality Standards. Chemical risk management is normally based on single-test evaluations. A problem when assessing mixture toxicities is that the constituents and concentrations of pollutants in the environment vary greatly.

This thesis is divided into two parts. Part one contains a general description of the flexographic printingtechnique. Part two contains a more detailed investigation in the areas substrate, inktransfer and trends, which are only briefly commented in part one, and conclusions and comments.The major problem concerning substrate is washboard. This phenomena can be limited if one can control and minimize the amount of glue applied in the single- and double facer, use high surface weight on liner, use low surfaceweight on fluting and control the humidity during the conditioning of the corrugated board. Corrugated board with a smooth surface radically increases the quality in print.

This thesis is divided into two parts. Part one contains a general description of the flexographic printingtechnique. Part two contains a more detailed investigation in the areas substrate, inktransfer and trends, which are only briefly commented in part one, and conclusions and comments.The major problem concerning substrate is washboard. This phenomena can be limited if one can control and minimize the amount of glue applied in the single- and double facer, use high surface weight on liner, use low surfaceweight on fluting and control the humidity during the conditioning of the corrugated board. Corrugated board with a smooth surface radically increases the quality in print.

This thesis is divided into two parts. Part one contains a general description of the flexographic printingtechnique. Part two contains a more detailed investigation in the areas substrate, inktransfer and trends, which are only briefly commented in part one, and conclusions and comments.The major problem concerning substrate is washboard. This phenomena can be limited if one can control and minimize the amount of glue applied in the single- and double facer, use high surface weight on liner, use low surfaceweight on fluting and control the humidity during the conditioning of the corrugated board. Corrugated board with a smooth surface radically increases the quality in print.