The Island of Öland has one of the best wind climates for land based wind power in Sweden. An objective for the Island is to become self sufficient using electricity from renewable source of energy such as wind. There is currently 55 MW capacity installed on the Island and it is estimated that grid congestion will occasionally occur if more than 135 MW was installed.The aim of this thesis is to investigate he possibilities for load management by smart charging of electric vehicles, EV. The definition of smart charging is that the charging is done to some extent with an ICT-system, (information and communication technology) that correlates wind electricity generation to the charging of electric vehicles. The purpose is to avoid grid congestions on the sub-sea cable that connects Öland to the mainland because that in turn would curtail wind energy production.

This paper examines the power producing dams along the Ume-river as an integral part of and a result from the urbanization process in Sweden during industrial capitalism. The aim of the paper is to contribute to the knowledge of the urbanization process in Sweden in general and of its traces along the Ume river in the county of Västerbotten in particular. The paper applies the theory of concentrated urbanization and extended urbanization put forward by Neil Brenner and Christian Schmid (2015) and argues that the building of power producing dams along the Ume-river is part of an extended urbanization process. This becomes particularly evident when examining the vast physical structures that is the dams, situated in an otherwise remote and sparsely populated area. These vast physical structures are also very well connected to a nation wide electric grid that has connections to bordering countries as well.

AbstractIn the fall of 2003 a project was started in the Swedish building sector that is called BASTA (the building sectors’ termination of especially harmful substances). The project is operated by the building companies NCC, Skanska, PEAB and JM, the Swedish Building Industry and the Swedish Environmental Institute IVL. The purpose of the project is to create a common environmental assessment system for the entire building industry and with the help of this system phase out the use of especially harmful properties from building products.In a large sense BASTA works like this; On the BASTA web site there is a database, to which a supplier can register the company and the company’s products. Only those products with a substance content that fulfil the demands of the BASTA system, is to be registered. As it is the supplier himself that carries out the registration of the company and the company’s products to the system, the BASTA-organisation annually controls that the companies that are registered in the database, fulfils BASTA’s demands.Since NCC is one of the companies that operates BASTA, BASTA is probably going to be the environmental assessment system that is recommended for the company in the future.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

AbstractIn the fall of 2003 a project was started in the Swedish building sector that is called BASTA (the building sectors’ termination of especially harmful substances). The project is operated by the building companies NCC, Skanska, PEAB and JM, the Swedish Building Industry and the Swedish Environmental Institute IVL. The purpose of the project is to create a common environmental assessment system for the entire building industry and with the help of this system phase out the use of especially harmful properties from building products.In a large sense BASTA works like this; On the BASTA web site there is a database, to which a supplier can register the company and the company’s products. Only those products with a substance content that fulfil the demands of the BASTA system, is to be registered. As it is the supplier himself that carries out the registration of the company and the company’s products to the system, the BASTA-organisation annually controls that the companies that are registered in the database, fulfils BASTA’s demands.Since NCC is one of the companies that operates BASTA, BASTA is probably going to be the environmental assessment system that is recommended for the company in the future.

This thesis is a qualitative study of a new law that was applied in December 2010. The law is called Lagen om etableringsinsatser fo?r vissa nyanla?nda invandrare, and is meant to help newly arrived immigrants that come to Sweden to establish themselves in the Swedish society. The aim of the study is to see what discourses the Swedish government produces as a result of this new law. Interesting for the study is to see what happens in the implementation stage at a local level, in this case in the municipality of O?rnsko?ldsvik.Theoretically and methodologically I emanate from critical discourse theory and institutional theory.

The actual project presents the development of a testing rig for a steam engine. A short overviewabout the development of steam engines is presented, until arriving to the development of thepresent engine, which will require to be tested in different ways.The testing rig studied on this project (based on a Lanchester engine) will be used to testdifferent materials and layouts for the group Piston-Cylinder.The engine is a high performance steam power engine, which is going to have a highpower/dimensions ratio, what will lead to require high performance components and materials.An introduction to the testing rig is presented, and the entire design project is done in order toreplace the disappeared documentation of the current testing rig, built on the 1970?s. Also somemodifications done in the original testing rig are presented, as well as some detected problemsand their possible solutions..

When building large buildings, such as compartment buildings, there is a number of deliveries arriving on the construction site daily. In order to receive these deliveries without disturbing the rest of the work going on JM often books a fixed unloading time. When doing that they can be prepared when the delivery arrives. Making sure there is a suitable unloading area, someone to meet the delivery and when needed proper machines, such as a tractor or a crane, to help unload bigger deliveries. The person receiving the delivery is supposed to make an acceptance control where they check the delivered goods making sure nothing has been damaged in transport and that they have received what they were supposed to receive.

The aim of this study has been to examine the role of control mechanisms when it comes to building relationships in a small business network. In order to reach this goal, we have performed a case study of a Swedish supplier of machines to the engineering industry, which acts as the exclusive representative of a foreign manufacturer on the Swedish market. Main results: A number of control mechanisms, both formal and informal, could be identified in the network. Their specific use, as well as relative importance differ between different actors in the network. In general, the importance of formal control mechanisms decreases as the relationship evolves over time and the importance of informal ones, mainly trust, increases in a corresponding manner..

AbstractIn the fall of 2003 a project was started in the Swedish building sector that is called BASTA (the building sectors’ termination of especially harmful substances). The project is operated by the building companies NCC, Skanska, PEAB and JM, the Swedish Building Industry and the Swedish Environmental Institute IVL. The purpose of the project is to create a common environmental assessment system for the entire building industry and with the help of this system phase out the use of especially harmful properties from building products.In a large sense BASTA works like this; On the BASTA web site there is a database, to which a supplier can register the company and the company’s products. Only those products with a substance content that fulfil the demands of the BASTA system, is to be registered. As it is the supplier himself that carries out the registration of the company and the company’s products to the system, the BASTA-organisation annually controls that the companies that are registered in the database, fulfils BASTA’s demands.Since NCC is one of the companies that operates BASTA, BASTA is probably going to be the environmental assessment system that is recommended for the company in the future.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

Wind power is an energy source that is becoming increasingly popular in Sweden and around the world. The establishment of large wind farms supply and contributes to energy production within grid in search of a more sustainable energy production. Wind power is becoming more popular and opens up new areas of implementation. More cities are starting to use small-scale urban wind power, everything from full-scale work for a little less work adapted to the villas. Sweden has high goals regarding the production of green electricity and the work which deals with the conditions Sweden plays in achieving those goals.