This report investigates a possible solution to the problem with adapting wave powerplants to work in countries with tidal water. The wire connecting the buoy at the surface with the generator at the bottom needs to adjust to the varying water depth. Our solution to this problem is to attach the wire to a jack which is then placed inside the buoy. The jack is then powered by an electric engine. The report discuss what forces the buoy will be exposed to and then the structural integrity of the design is evaluated through simulations.

Uvån Hagfors Teknologi AB (UHT) has developed a process ? GRANSHOT® ? for quicksolidification of metals in water baths. In the process liquid metal is splintered ? granulated ?into small drops. The drops are rapidly cooled in a water bath where all the heat energy from theliquid metal is transferred into the water.

Hemp has been used for textiles for a long time in history until it became illegal to grow in many countries in the 1930s. It is interesting from an environmental point of view because it doesn?t need any pesticides and in most locations it doesn?t need any irrigation either, compared to cotton, which normally requires big amounts of both pesticides and water for irrigation. Hemp is a bast fiber, which means that the fibers are located on the bast of the stem (on the outer layer of the stem). Therefore they cannot be spun directly, they have to be removed from the stem first.

The aim for this study where to investigate the frequency of cutting cracks in saw timber harvested in the storm-damaged forests in regions where the storms Hilde and Ivar hit. The idea for this work came from one of the region?s biggest actors, SCA Skog and Jämtlands district. The purpose where to find out how big proportion of the saw timber that contains cutting cracks, their financial cost in lost wood value and also give advice and suggestions on how to work against the frequency of cutting cracks. For the field-study some guidelines where used to make sure that the samples were taken under the same conditions, they were: ? The field-study must be performed under harvesting of storm-felled forest, which are horizontal/inclined trunks. ? The averaged sized tree will make it possible to harvest saw timber. ? The trunks can?t be root cut. A methodology called in Swedish ?Trissmetoden? was used because it is the most frequent used methodology in earlier performed studies and the only one that can be used I field. Under the field-study data were collected from 570 saw timber logs, 30 logs from each one of the tested harvesters.

Most of the saw and pulp industries have stored wood nearby their production, the main reason is to have a continuous wood flow to the production. Wet storage of wood is of great importance to keep the wood quality. Without water sprinkling the risk of drying outand decomposition through biological activity increases significantly and will result in a negative effect on future production and quality. One drawback of wet storage of wood is the leaching of chemical substances into the surrounding recipient. The log yard run-off contains phosphorus, nitrogen, phenols and organic substances. These substances can cause problems for the surrounding environment. The main objective of this project is to gain an understanding of the wet storage used by the Swedish wood industry and estimate the environmental consequences that run-off water will have on the recipient.

Buffer zones play an important role for the water quality in our watercourses. When harvesting a forest close to a watercourse a buffer zone should be left. When it's not left, it will lead to radical changes in the environment for the water organisms. The overall purpose of this thesis was to illuminate the production- and environmental thinking when establishing new buffer zones in south of Värmland. The partials goals were to determine choice of tree species, ways of regenerate, occurrence of soil scarification and the occurrence of machine tracks in newly established buffer zones.

Syftet med examensarbetet har varit att studera kol i mindre vattendrag med hjälp av jämviktsmodellering i PHREEQC. Fokus har varit dynamik av löst icke organiskt kol (DIC) samt att förstå hur mycket koldioxid (CO2) som avges från mindre vattendrag och om den mängden har signifikant inverkan på den globala kolbalansen. Med hjälp av provtagen data från Krycklans avrinningsområde år 2003-2007 och 2009 har modellering av DIC och pCO2 utförts med målet att se förändring både över säsong och nedströms i ytvattensystemet. För att utvärdera modellen har tillhandahållen data över uppmätt pCO2 använts. Målet var att jämföra modellerade och tillhandahållna pCO2-värden för att se hur väl modellen kunde beskriva verkligheten och om den fungerade bättre för någon plats eller under vissa delar av året.

In the process of making carton boards into Skoghall Mill, are great quantities of water being contaminated. This water has to be treated before it is possible to release into the recipient, Kattfjorden. One of the contaminations that is important to extract from the wastewater, is organic carbon (measured as TOC-total organic carbon) because microbiological breakdown can lead to the bottom becomig free of oxygen.The wastewater treatment at Skoghall Mill is done through an external wastewater treatment that is located at the factory. The biological treatment (aerated lagoon) is a 140 000 m3 water pool with surface aerator, which is give oxygen to the water. In the lagoon live microorganisms who performs the biggest part of the TOC-reduction.One problem with the lagoon is that the treatment of TOC is considerably worse during wintertime than during summertime.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

ITT Water & Wastewater ställer höga krav på kostnadseffektiv produktion vilket är en starkt bidragande orsak till att företaget är världsledande på sin marknad. För att erhålla kostnadseffektiv produktion har kombinationen människa robot visat sig vara framgångsrik.Examensarbetets syfte var att ta fram underlag åt ITT Water & Wastewater för att ta beslut om frigörande av indirekt personal vid line 15:s isoleringsstation på Elmotorverkstaden. Syftets uppfyllande stöttades av de underbyggande syftena att försöka höja robotens utnyttjandegrad samt reducera isoleringsmaskinens omställningstid.Arbetet bygger på kvalitativa och kvantitativa data i form av mätningar, intervjuer och egna observationer. Med stöd av erhållen data lyftes fyra olika förslag fram. Förslagen understryktes bland annat av integrering av arbetsmoment, förhöjd automatiseringsgrad och outsourcing..

The purpose of this work is to develop and test a design process where quick decisions and model building has a prominent role. The goal is to develop a number of products and build prototypes to be shown during the Carl Malmsten Furniture Studies spring exhibition 2012. I?m also writing a report describing my work.To reach my goal I have each day during the first phase conducted a short research and found a concept based on that days name day. Then I have continued in the workshop and worked with three-dimensional models.

The focus of this project has been on the drainage tank of the reheater on Ringhals 1. This tank has on two previous occasions received such a high water level that the system automatically emergency stopped. For this reason, events and various readings from these two occasions has been specifically studied and analyzed. In order to prove theories about what causes these problems a model of the system was created in the program Dymola. Using simulation results from the model, we have been able to demonstrate how the system's measured values should look likeunder normal conditions with respect to flows, pressures, temperatures, valve positions and water level in the drainage tank.

The hospital in Varberg has a somewhat outmoded solution regarding the state of preparedness in its water sustentation. Today?s solution is both cause to a number of mishaps and high energy consumption.The report is initiated by looking into the present situation to get an insight to the problem.Today?s media depletion is measured and analyzed.Furthermore, it also looks into some earlier performed studies. These studies are followed up in order to see if measures have been taken.The report presents a number of arrangements which should be taken, amongst those a minor re-build of the current solution and a number of arrangements which leads to decreased water consumption..

The purpose of this work is to develop and test a design process where quick decisions and model building has a prominent role. The goal is to develop a number of products and build prototypes to be shown during the Carl Malmsten Furniture Studies spring exhibition 2012. I?m also writing a report describing my work.To reach my goal I have each day during the first phase conducted a short research and found a concept based on that days name day. Then I have continued in the workshop and worked with three-dimensional models.

Hylocomium splendens (Glittering wood-moss) is a common species in the Nordic countries and can be found in many different types of boreal forests. It usually forms dense moss carpets on the forest floor. The shoots grow in segments and new segments form annually on the previous years growth. The size of the segments is probably regulated in a high extent by local micro environmental conditions. Previous experiments suggest increased growth of H.