Performance of an intersection affects the total travel time in a traffic network. An intersection with good performance can easily be described by its contribution to lower travel time than in a comparable intersection. The travel time is of importance in the cost calculations when a specific intersection is to be chosen and designed. It is important to be able to make correct and precise performance calculations so that the cost calculations will not be incorrect. For that purpose the software Capcal, which is a traffic model for intersection analysis on performance, is used in Sweden.

Continuously grazed grasslands have remarkably high plant species diversity. In Sweden this type of habitat has declined for the last two centuries. Changed land use has caused habitat fragmentation and loss of habitat quality. This has caused a great number of plant species to end up on the verge of extinction. To try to save this unique habitat and the species that are tied to it, lots of resources are laid on restoration of abandoned grasslands. In this study, plant species richness of continuously grazed, abandoned and restored grasslands were related to degree of overgrowth, time since overgrowth started and rate of overgrowth.

The purpose of the present study was to explore if blood lactate levels are increased in bitches with pyometra, and if the lactate measurement could be used as a prognostic indicator and to determine outcome. The present study included 16 bitches with pyometra that were admitted to the University Animal Hospital, Swedish University of Agricultural Sciences, Uppsala, Sweden. For comparison, a control group consisting of 14 healthy staffowned bitches was also evaluated. In all bitches, a physical examination was performed and blood samples for analysis of haematological and biochemical parameters were obtained. In all bitches with pyometra, surgical ovariohysterectomy was performed and a uterine sample for bacteriological culture and identification was collected.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

The viscosity of air buildings is a hot topic within the construction performers, which the industry feel they have too little knowledge about. This study is mainly aimed against air density in apartment buildings and airflow measurement. The study consists of a theoretical reference, educational visit, interviews and a survey conducted among construction workers at Magistratshagen in Linkoping.Earlier requirement in terms of air leakage through the climate screen was removed and today there are only energy requirement for a dwelling in Boverkets Building Regulations. The difference between a passive and a typical air tight construction is that the passive house have a maximum requirement of 0.3 l /s m2 of air leakage through the building climate screen. The requirement imposed on passive houses is to minimize the supply of power and energy for heating the building.Air tight constructions have heavy demands on the performance and accuracy of everyone involved with the project. The client must specify their requirements and also be prepared to pay for any additional costs. The architect and building planners have to design the building with regard to air tightness. Finally, the construction workers are required to do a careful work in order to get all the connections in the building air tight.The study suggests that an air tight building is a closed system where no forced ventilation exists. There are no reasons not to build too tight as long as there is a functioning ventilation. In this study the authors ask themselves how an air tight building changes over time. No theoretical information has been found on these changes, but the respondents assume that air density decreases with time. The deterioration is mainly assumed to be caused by construction materials changes over time. The study shows that construction workers knowledge of air tight construction is mixed, which they themselves admit in the survey..

The purpose with this bachelor thesis is to identify risks and insufficiencies concerning the production at WilloMaskin AB. The project is limited to only 4 machines, where theories as ?OEE? (overall equipment efficacy) should be illuminated and analyzed. The theory of ?Single Minute Exchange of Die? is also presented.The method used in this project is mostly based on qualitative studies but also quantitative studies are presented.

Sågverksindustrins logistikkostnader är idag höga och utgör närmare en fjärdedel avslutpriset på produkten. Branschen möter nu konkurrens från andra delar av Europa ochkunderna ställer samtidigt högre krav på snabbare och mer flexibla leveranser. I Varberggörs sedan hösten 2009 en stor satsning för att effektivisera logistikflödet inom branschenför sågade trävaror vilket har resulterat i ett koncept som sedan 2011 går under namnetTimberbridge.Med utgångspunkt i de höga logistikkostnaderna inom sågverksindustrin är studiens syfteatt studera om samarbete mellan företag kan effektivisera sågverkens transport-ochlogistikupplägg från sågverk till kund. För att utreda detta genomfördes inledningsvis endjupintervju med en representant från Port of Varberg för att få relevantbakgrundsinformation. Dessutom har tidigare forskning inom olika teoretiska områdenstuderats och har sedan kombinerats med empirisk data från en undersökning i form avtelefonintervjuer med 29 svenska sågverk.Det insamlade datamaterialet har sedan analyserats och resultatet visar att Timberbridgehar goda förutsättningar för att bli en etablerad leverantör för svenska sågverk.

The purpose of this study is to examine how employees in an organization using flexible work practices, experience that passive face time influences the evaluated of them. Further, the study aims to understand to what extent that perception of passive face time motivates the employees to spend more time at the office than is necessary for their work situations. The study concludes that employees in general perceive that passive face time does influence how they are evaluated and that this perception motivates employees that are relatively newly employed by the company to spend more time at office..