An energy study has been performed on two blocks in an area called Gävle Strand. The buildings are owned by a tenant-owner?s association called brf Carolina and were built by the company Skanska 2008. The builder as well as brf Carolina are pussled by the fact that electricity use is higher than expected while heating is less. Skanska is also very interested in finding out how much heat recovery from stale exhaust air through a geo-thermal heat pump is contributing to the general heating requirement and energy balance in four out of the ten buildings located on the properties.To find possible answers to the higher electricity use a literature survey on user behaviour was conducted.

The study evaluated the Mutant Prevention Concentration (MPC) of Pradofloxacin on three Escherichia coli (E.coli) strains, 2 wildtypes and one first-step gyrA resistant mutant. We also measured the value of AUC (Under the Concentration)/MPC that prevents growth of resistant mutants. It is of importance to reach a concentration above MPC that prevent E.coli from developing resistance against the antibiotic.We used an in vitro kinetic model where we added bacteria? and antibiotic. The culture flask was attached to a pump with an adjustable pump-speed.

The energy use in a workshop company has been examined in this work in order to find areas for energy efficiency improvement. The combined oil and electricity heating in the company were compared with other alternative heating systems including cooling of the premises in following combinations:Ground source heat pump for heating and coolingDistrict heating and absorption coolingDistrict heating and low temperate surface water coolingEnergy use, operation costs and carbon dioxide emissions were calculated for the current heating systems and the three alternatives including cooling. The ground source heat pump for heating and cooling decreases bought energy with 34 MWh annually compared to current heating only. The district heating and low temperate surface water cooling has the largest reduction of operation cost and carbon dioxide. The operation cost decreases with 42 kSEK and the carbon dioxide with 43 metric ton CO2 annually.

This report is made as a literature review, focusing on the work done to increase understanding of efficiency in the categories of substations and secondary heating systems, with respect to the deviation from the theoretically possible cooling off in the distribution network as well as the economic benefit that appear. The main purpose of a considerable part of the literature used in this report addresses the issue of identifying individual causes of reduced cooling in district heating systems. These literature resources have been compiled and summarized as part of the report.The technology of district heating is associated with benefits such as better use of the energy in a fuel. This is the case of cogeneration plants where serial generation of electricity and thermal energy increases efficiency compared with the parallel generation where heat is generated locally and electricity is generated centrally. Serial generation thus allows for lower primary energy demand.

The purpose of this master thesis was to study the water system for mechanically cleaned water at Skärblacka mill, in order to find and evaluate possibilities of using energy more efficiently. The thesis also includes an evaluation of the software tool ?Pumpanalys?Skärblacka mill produces pulp and paper. The large amount of water required is cleaned mechanically through filters and called mechanically cleaned water (MR0). The MR0 water is pumped out to the factory by four crude water pumps.

Uppsala County has ambitious environmental aims for the planned residential area inÖstra Sala backe. In this thesis different energy sources have been evaluated todetermine which system that would be most favorable given currently availableinformation about the project. Planned energy usage has been divided into tap waterheating, space heating and power. Three base case scenarios were made with districtheating, small scale bio fuel and heat pump. Solar power and solar heating were thensimulated and the production from the two could individually be deducted from theenergy need in the base cases, constituting 9 different scenarios.

Simulation is a vital tool during development of JAS 39 Gripen, since money and time can be saved.The Auxiliary and Emergency Power System, AEPS, is a subsystem of the secondary power system in Gripen. It has the function of providing the aircraft with electrical and hydraulical power before activation and after deactivation of the main engine. The system also functions as backup in case of a safety critical problem in the main power supply system. The system basically consists of a control unit and an auxiliary gearbox. The gearbox is driven by an air turbine.

Detta examensarbete utfördes på Metso Minerals (Sala) AB i Sala mellan mars och augusti 2006 och handlar om kartläggning av ledtiden vid produktlinje pump. Förutom kartläggningen har även analys och förslag till förbättring arbetats fram. Denna rapport är resultatet av detta examensarbete vilket har skrivits som avslutning på programmet Ergonomisk design& produktion med inriktning Industriell produktion vid Luleå Tekniska Universitet. Metso Minerals (Sala) AB har cirka 200 anställda och är en del av affärsområdet Minerals. Verksamheten i Sala tillverkar slurrypumpar samt processmaskiner och är en stor leverantör av pumpar till mineral och processindustrin.

Hydroware Elevation Technology AB sells control and regulation equipment for hydraulic elevators. The company now wants to investigate the possibility of changing their present softstarters to frequency inverters to supply power to their pump engines. They also want to investigate the possibility of future use in so called ?intelligent? houses.The purpose of this report is to investigate these possibilities..

Several technical solutions are ready to step forward as the new generation of propellant, and this report aims to explore the possibility of commercializing fuel cell cars. The report is based on current research and data from today's technology and engineering solutions that are estimated to be commercially realized before 2020.A mapping of today?s different fuel cell options has shown that the most suitable fuel cell option is the Proton Exchange Membrane Fuel Cell, which uses hydrogen as fuel. The report is focusing on a techno-economic well-to-wheel analysis of hydrogen and the energy balance and costs in a system perspective. The basis for this analysis consists of two centralized methods of production, steam methane reforming (SMR), and alkaline water electrolysis.

The project was performed at SiemensIndustry Drive Technologies with theobjective to provide actual values forthe energy savings potential withinSiemens scope of practice.In Sweden the electrical drives standfor about 30 % of the total electricityconsumption and about 60 % of theelectricity consumption within theindustry. During the pre-study phaseelectrical drives with pump applicationswere identified as large energy users.Because of this a case study at one ofSiemens customers, Stora Enso Fors wasperformed. The system that was evaluatedduring the case study was a throttledsystem with a centrifugal pump forpumping pulp.The results yielded that a saving ofover 50 % could be achieved by replacingthe throttle valve with a variable speeddrive, a frequency converter. Thepayback period was two years and twomonths and the present value for thetotal life cycle cost of the variablespeed system was 662.566 SEK lower thanfor the throttled system. As aconsequence, Stora Enso Fors is advisedto invest in a frequency converter forregulation of the system.The general conclusion is that a focuson system efficiency is the mostimportant factor in energy efficiencyprojects and that the system regulationmethod has a large impact on the overallsystem losses and hence its efficiency.Energy efficiency potential forthrottled systems with centrifugal pumpsis large and significant economicalsavings can be made through investmentswith short payback time..

The purpose of the house which is the basis of this report is to be able present itself on the market as a relatively cheap and at the same time a climate friendly choice. The house is supposed to be able to be built anywhere in Sweden and the rest of Scandinavia in a short period of time. This puts demand on what kind of heating system the house can have, since not all places have the geographic advantage of being able to use geothermal or district heating. Therefore the heating system choices will only include those that are not limited by their geographic location. The house will be built in modules which only require the groundwork to be done before the house can be erected. In this report "System solutions for plus or passive-housing" a comprehensive literature search has been conducted as well as a number of calculations.

Bioethanol is one alternative energy fuel that can be produced from different types of biomass. Second generation bioethanol comes from fermentation of lignocellulosic material and can be seen as a more environmental friendly alternative as e.g. forest residues and agricultural by-products are used. To be able to use lignocellulosic biomass in ethanol production, it has to be subjected to different treatments first. In this study, aspen sawdust was used as lignocellulosic material.

Increased resource efficiency in an energy system could result in large economic and environmental benefits. Tekniska verken i Linköping AB (Tekniska verken) is responsible for the district heating network in Linköping. Their vision is to create the world?s most resource efficient region. An important step towards this vision is more efficient usage of produced heat, something which could be achieved through integration of a seasonal heat storage in the energy system.

Thermia Värme AB is one of the market leading manufactures of heat pumps. In order tomaintain this position, the company wants to improve the vibration characteristics of theirproducts. The aim of this thesis is to develop product design changes that lead to a reductionof vibrations in the heat pump Thermia Diplomat 8.The main cause for vibrations in the system is flow pulsation and mechanical forces inducedby the scroll compressor. Vibration is transmitted through the compressor piping and receivedby the heat exchangers, from where it is further transmitted to the connection points for theradiator and heat source circuits.A number of design changes in order to improve the vibration characteristics have beenevaluated through calculations and practical experiments. The changes have included thecompressor and heat exchanger mountings, the compressor suction and discharge line pipingand also pulsation dampening.The results of the experiments show that the vibration levels in the connections for the heatingand brine circuits can be decreased strikingly through changes in suction and discharge linepiping.