This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

This thesis is made by Carl Persson and Alejandro Saavedra for Gryaab. Gryaab is Gothenburg?s water processing plant and produces about 60 GWh biogas annually with a flow around 1150 Nm3/h. Gryaab wants to research their possibilities to become independent with electrical energy and the possibilities to enrich, upgrade biogas. The use of methane rich gases like biogas and natural gas is today low in Sweden compared to major parts of the world.

Environmental impact and management of energy is a highly topical issue in today's society. Climate impact must be reduced. The Government has set a target to reduce energy consumption in buildings by 20 % by 2020 and 50 % by 2050 compared to the energy use in 1995.With this in mind, we chose to examine how property owners can work on improving energy efficiency in existing apartment buildings. We also wanted to investigate profitability of different increasing energy efficiency measures and the calculation methods and the risk assessment performed by such investments. To tie in with government objectives, we also saw the possibilities of achieving these goals.20 companies were interviewed, of which 14 were property owners and 6 were consulting firms that works with energy efficiency.

The purpose of this thesis was to examine how locally produced bioenergy may contribute to meet the climate target year 2050 in the municipality of Uppsala. The goal of reduced GHG-emissions from current 6,8 ton CO2-equivalents to 0,5 ton CO2-equivalents per capita and year, year 2050 is based on avoiding harmful penalties of an increased level of GHG in the atmosphere. By estimating available biomass in the county together with examining future technologies and emission factors for the substrates used, four possible future scenarios has been developed focusing either on electricity generation or production of biofuels. GHG-emissions of year 2050 have been calculated using the software LEAP. The conclusion is that bioenergy, depending on how it is integrated in the energy system, may reduce greenhouse gas emissions between 0.6 ton CO2-equivalents and 1.4 ton CO2-equivalents per capita or 12% to 25% compared to 5.5 ton CO2-equivalents in the reference scenario 2050. The greatest reduction is obtained if biofuels are produced in combination with energy efficient heat requirements in buildings..

I detta examensarbete undersöktes möjligheten att installera värmeåtervinningssystem för ett flerfamiljehus i Hovgården som ligger en bit utanför Borlänge. I rapporten redovisas två olika sätt för energibesparingar som är aktuella för att ersätta borttagning av oljepannan som används i huset i dag. En rad svårigheter dök upp under undersökningen för installation av nytt värmesystem. Lämpliga lösningar kunde hittas efter mycket analys. Syftet med rapporten var att undersöka möjligheten och lönsamheten för installation av något av följande system; FVP eller VBX-modul som kan återvinna värme ur frånluften.

Rooted in Industrial Ecology (IE) theory, this report evaluates how urban agricultural concepts and techniques, can contribute to improved ecological sustainability within the inner city boundaries of Stockholm. An overarching literary study as well as an interview was carried out, resulting in a qualitative analysis followed by suggestions for practical implementations. A substantial convergence was found between the eco-restructuring objectives of IE and the principal motives for urban agriculture. Consequently, eco-restructuring objectives are found in varying degrees in the presented urban agricultural techniques. Industrial symbioses, permaculture and combinations of urban agricultural techniques are tools which are capable of corresponding adequately to the diversity of urban settings.

In this thesis proposals for different designs of a borehole thermal energy storage (BTES) have been developed for the building DN-huset in Stockholm, Sweden. To build a BTES results in savings in energy costs by approximately 44 %, i.e. 2 million Swedish crowns annually. Furthermore, a BTES would reduce the annual environmental impact with roughly 75-157 tonnes of CO2 equivalents per year, depending on how the electricity consumption?s environmental impact is estimated.

AbstractMotor sports have been around as long as motor vehicles have been. Sports are often seen as costly polluter but in the same time the motor sports have encourages a large part of development, both for vehicles and other industries. Inventions like rear mirror and ABS brakes come from motor sports. One way to once again drive development forward while making motor sports carbon-neutral is to run the race cars on hydrogen. In this thesis, the goal is to convert a spark ignition engine for hydrogen operation.

This is a paper about the effects from smoldering fire on lithic objects from an archaeological view. The introduction gives the background to this paper, a short orientation to forest wildfires and why the work is limited to: flint, quartz, quartzite and slate. Material and methods describes the stone materials and the setup that was used in the temperature logged tests with three replications for each type of material. The fuel in the burnings was peat on a bottom of sand. Flint showed a more drastic effect from heat compared with the other materials. Slate seems to have greater tendencies to change to darker colour and luster at lower temperatures than the other materials.

I denna kandidatuppsats avlägsnas organiska föroreningar från vatten genom användning av textilier, vars yta belagts med nanopartiklar utav ämnet titandioxid. När titandioxid belyses med UV-strålning sker en fotokatalytisk reaktion, vilket i sin tur bryter ned bland annat bakterier och organiska färgämnen. I hopp om att finna ultimat vidhäftning mot textil passande titandioxid har olika typer av beläggningar studerats; akrylbaserade, sol-gel och slutligen en hybrid. Dessutom har fem olika konstruktioner av textila bindningar jämförts i syfte att undersöka dess påverkan på den fotokatalytiska effekten. Förorenade vatten är ett stort problem, både i utvecklingsländer och i industriella sammanhang.

Uppsalahem is the leading housing corporation in Uppsala with its over 160 real estate properties. Uppsalahem is owned by the municipality of Uppsala, which has a climate and energy goal that aims for 100 MW of solar energy to be installed in Uppsala by 2030. The 100 MW goal, combined with Uppsalahem?s environmental policy, is a strong incentive to investigate the possibility of installing PV modules on the many available roof areas that Uppsalahem possesses. The objective of this thesis is to create a foundation for future decisions regarding PV systems for Uppsalahem.

Då det köptes in ny utrustning för kalibrering av värmestrålningsmätare till SP, Brandteknik, fanns det ett önskemål om att effektivisera proceduren vid kalibreringen. Vid kalibrering med den befintliga hård- och mjukvaran finns många manuella moment som skulle kunna reduceras.I detta projekt har ett styrprogram utvecklats i programmeringsspråket LabVIEW. Programmet använder ett seriellt kommunikationsprotokoll för att styra den kontroller som reglerar temperaturen i kalibreringsugnen. Programmet ställer in de temperaturnivåer som ska ingå i kalibreringen, upp till tio stycken, och kontrollerar när temperaturen har stabiliserat sig. När den gjort det tas ett antal mätpunkter ut och sparas till en resultatfil.

Electronic article surveillance (EAS) is widely used in shops and libraries together with an RF-tag attached to the goods or books in order to prevent shoplifting. By implementing the addition of a moisture sensor to the RF-tag, other functions become possible, including the ability to use as an alarm with regards to frozen goods, which have been shipped but which have melted and have, subsequently, refrozen. In- relation to care for the elderly, one time-consuming step involves checking whether there is the necessity for a change of diaper and this can, instead, be based on an RF-tag with an EAS-system alarm. A preliminary investigation was made using the moisture sensors, which involved how the resistance changes when liquid and/or heat is applied. A simulation of the LCCR circuit (RF-tag with the sensor) was conducted in order to determine how the resonance frequency changes for different resistances levels.

This diploma work on D-level is made in cooperation with Varnäsföretagen AB in Eskilstuna. The company performs contract manufactured aluminium goods. This work is a continuation on earlier diploma work in Varnäsföretagen AB. Even if the industry process consumes much energy for melting the aluminium goods, they consume a great amount of oil to warm up the building. The purpose of this work is to examine some places in the building and the process to see how much energy it is possible to recycles to the heating system and reduce the costs for heating.

The purpose of the study was to investigate the use and losses of energy in an existing older building. Another purpose was also to look through various options for heating systems with renewable energy in the building. The aim was to reduce the use and losses of energy. The first step was to study the related electricity bills of the building and also perform measurements and calculations of the building envelope and ventilation. The next step was to find out the possible actions for energy saving by performing measurements and calculations.