A clean and affordable energy source for cooking is deficient in developing countries. People rely on fuels that contribute to environmental, social and health problems.Biogas is an alternative energy source and an increased investment in small-scale biogas production can in several developing countries be found. Several projects have started to use the technology in developing countries because of the benefits with biogas. Some cases in the establishment of biogas plants have succeeded and some have not. The study is a literature review supplemented by two field studies.

This master thesis has been carried out as a prototype development project. The project hasbeen performed in cooperation with ÅF Combra AB. The purpose with the master thesis is toconstruct a Bluetooth interface between an accelerometer and a smartphone and constructinga physical prototype containing an accelerometer. This is done to test a new user interface tomobile phones. The master thesis has also included a research about the possibility toimplement distance measuring with Bluetooth.

The purpose of this work is to study a circulation project in Enköping municipality, where the society?s rest products are used to make beneficial products. In Enköping the rest products from waste treatment plants and private sewers are used to fertilize and irrigate Salix plantations that later are harvested and burned at the local combined heating and power plant, ENA Energy AB, to produce electricity and heat. Possibilities to apply this kind of project ona municipality in Russia are also explored.Guryevsk municipality in Kaliningrad region was chosen since there is a need to improve energy systems and reduce emissions to water and air. This municipality strives to become environmentally friendly.

Today, high-yielding leys of good quality are a must for Swedish dairy and beef enterprises if they are to become profitable. Thus, it is of interest to evaluate the quality of the recently released high-yielding Festulolium hybrids ((Festulolium braunii (K.Rich.) A.Camus). The aim of this project was to determine at what phenological stage three different Festulolium hybrids should be cut in order to get the highest nutritional value. The hybrids studied were Hykor, Perun and Paulita. In the study I also investigated if leaf proportion of the crop could be useful for predictions of the crop content of metabolizable energy. The cultivars were grown in plots within a variety trial with ryegrasses.

Many of todays studies show that district heating is one of the betteralternatives as heating source because of its low environmental load.The energy source is often leftovers from other processes producing energy or waste, like garbage or chips.Electricity in combination with geothermal heating is another heating system that has increased sharply during the last years, and also this system decreases the discharges that have negative affectson the environment compared to several other heating methods.This report aims to, concentrated towards these two different heating systems, estimate the amounts of discharges they indirect cause and how the environment is affected.We have calculated the mean value for discharges of carbon dioxide, nitrogen oxide, sulphur oxide and dust generated from electrical power used in Sweden.Through interviews and research we have gained data for the same substances that district heating based on combustion of garbage and biofuel generates.We have also in cooperation with a housing company chosen a building we see representative for many of the new single-family houses built in Sweden today.Based on its shape and appearance we theoretically created three alternatives of the same house, each of them with climate screens different from each other.Together with the amounts of discharged environmental affecting substances, these houses were the base for our calculations and studies when investigating the different heating sources environmental effect.The results have thereafter been analyzed and discussed from different angles..

This thesis examines the effects of electricity visualization in an office building. The subject was investigated through the creation of a web based visualization tool that was made accessible to the about 1500 employees in a large office building. The visualization was available for three weeks. During this period interviews, user studies and observations took place in order to evaluate what, if any, effects the visualization had on the attitudes and behaviors in the office. Electricity use data was collected and analyzed to see if the project had a statistically significant effect on the electricity consumption in the office.The results from the interviews and the data analysis indicate that no reduction in electricity consumption took place, and a number of factors that could increase the chances of success were identified.

In order to accomplish that a construction is correctly built, it is critical to obtain a well functioning control mechanism throughout the project. The way to enable this is not by having an independent inspector constantly at your side. Today it is praxis to use check lists and have people responsible of quality to make sure that these are followed. This is where discretionary inspections play their part. These among others are documents needed to com-plete the check list.

AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.

A clean and affordable energy source for cooking is deficient in developing countries. People rely on fuels that contribute to environmental, social and health problems.Biogas is an alternative energy source and an increased investment in small-scale biogas production can in several developing countries be found. Several projects have started to use the technology in developing countries because of the benefits with biogas. Some cases in the establishment of biogas plants have succeeded and some have not. The study is a literature review supplemented by two field studies.

A clean and affordable energy source for cooking is deficient in developing countries. People rely on fuels that contribute to environmental, social and health problems.Biogas is an alternative energy source and an increased investment in small-scale biogas production can in several developing countries be found. Several projects have started to use the technology in developing countries because of the benefits with biogas. Some cases in the establishment of biogas plants have succeeded and some have not. The study is a literature review supplemented by two field studies.

Denna uppsats avhandlar möjligheter och begränsningar vid användande avhögenergilaser för nedskjutning av luftmål. Uppsatsen har inte ambitionen attvara heltäckande över området utan presenterar några av de fördelar ochnackdelar som finns..

The district heating load is seasonally dependent, with a low load during periods of high ambient temperature. Thermal energy storage (TES) has the potential to shift heating loads from winter to summer, thus reducing cost and environmental impact of District Heat production. In this study, a concept of high temperature borehole thermal energy storage (HT-BTES) together with a pellet heating plant for temperature boost, is presented and evaluated by its technical limitations, its ability to supply heat, its function within the district heating system, as well as its environmental impact and economic viability in Gothenburg, Sweden, a city with access to high quantities of waste heat.The concept has proven potentially environmentally friendly and potentially profitable if its design is balanced to achieve a good enough supply temperature from the HT-BTES. The size of the heat storage, the distance between boreholes and low borehole thermal resistance are key parameters to achieve high temperature. Profitability increases if a location with lower temperature demand, as well as risk of future shortage of supply, can be met.

A clean and affordable energy source for cooking is deficient in developing countries. People rely on fuels that contribute to environmental, social and health problems.Biogas is an alternative energy source and an increased investment in small-scale biogas production can in several developing countries be found. Several projects have started to use the technology in developing countries because of the benefits with biogas. Some cases in the establishment of biogas plants have succeeded and some have not. The study is a literature review supplemented by two field studies.

To create multifunctional buffer strips along a watercourse in an economically sustainable way requires consideration of many different factors. In this plan we have selected pollutant reduction as the main purpose of the buffer strip. We have also strived to achieve minimal income loss due to reduced production, increased biological diversity, good game preservation that leads to higher income from hunting, aesthetical satisfaction and possibility to profit from available subsidies. This is done mainly to make landowners/farmers more interested in creating buffer strips along water courses.As sand is the dominant type of soil in the area, the water course is less affected by surface runoff compared to if the soil would be clay or some other finer texture. Game preservation and subsidies have therefore been the main factors when establishing the width of the strip, because these require wider buffer strips in some cases.

AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.