The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and Signal Strength of the PLC-system.

Highland Group AB was helping a customer of theirs to create an All-Terrain Vehicle (ATV), a project Highland has never been involved with before. For the wishbone arms of the wheel suspension, traditional manufacturing methods and tubes with cylindrical or square shaped cross section was preferred. We performed a simulation where the ATV was driving on a bumpy road too see the forces involved. With the results we proceeded to calculate the strength of the concepts to find out which is best suited for the tough environment in which the ATV is used. The concept that turned out to be the best was a wishbone made of circular cross section, which had good structural strength and did fulfill the demands that we required for the construction.

This examination report is a part of a program for Industrial organisation and Economics with specialization in Logistics and Management at Jönköping University. The report contains an analysis of the internal material handling at Kongsberg Automotive, and also an improvement proposal for a new material handling system.The aim with the report is to find a better material handling system and also make an analyse of the existing system. The goal is to shorten the distance for the operators when they order material, and also to increase the productivity.The investigation methods for the report have for the most part consisted of observations and interviews of key-persons who daily work in the production. During some time the actual material handling-system has been observed and some shortcomings have been discovered, and these are also discussed in the report.The shortcomings that have been discovered are for once the indistinct signal that should signal need of material in the production. Some other activities have also been discovered that does not bring any value into the final products.

Aim: The aim of the study was to investigate 1RM and what power could be generated in bench-press and half squat concentric at certain percentages of 1RM. Special interest was put to evaluate men (M) and women (K), strength trained (ST) verses non strength trained (EST) in generating absolute power as well as power relative to 1RM.Method: In total 59 subjects mean (± SD) age 24.9 ± 4.1 years divided into four test groups: 20 male non strength trained GIH-students (EST M), 20 female non strength trained GIH-students (EST K), 10 male strength trained - sprinters on national/regional level (ST M), 10 female strength trained - sprinters (ST K) on national/regional level. They did two tests on 1RM and power in events of concentric bench-press and half squat in a Smith machine. In the first test session 3 ? 5 lifts were made to measure 1RM in each event.

To identify the exchange and adaptation that takes place in the business relationship between electricity suppliers and electricity customers and analyze how these factors affect the strength of the relationship.The investigated concepts create synergies. The strength of the business relationship in the current situation is dominated by weak reciprocity in adaptation and an inefficient exchange of information with low frequency..

Publicity is argued to have relatively great impact on attitudes and behaviours of consumer. Especially great is the influence of negative information. At the same time it is likely for brands to be subject to negative publicity. Since companies are investing gigantic sums into buidling strong and positive associations around their brands it is of great economic interest to have a better understanding how negative publicity influence brand equity and what factors might moderate this effect. This thesis focuses on brand strength as a moderating factor of negative publicity.

Publicity is argued to have relatively great impact on attitudes and behaviours of consumer. Especially great is the influence of negative information. At the same time it is likely for brands to be subject to negative publicity. Since companies are investing gigantic sums into buidling strong and positive associations around their brands it is of great economic interest to have a better understanding how negative publicity influence brand equity and what factors might moderate this effect. This thesis focuses on brand strength as a moderating factor of negative publicity.

This essay examines the indirect effects of the local strength of the Swedish Democrats on refugee acceptance in the Swedish municipalities. With statistical methods this essay has aimed to investigate if such effects exist and by using statistical data from three periods of time - 2002, 2006 and 2010 ? the investigation has been able to measure effects over time. Based on former research and reasonable expectations the hypothesis for the essay claims that the Swedish Democrats has got an indirect effect upon the refugee acceptance. With the statistical analyses made, the essay is able to conclude that the strength of the Swedish Democrats in municipality elections as well as the change of this strength between the elections does have a negative effect upon refugee acceptance in the Swedish municipalities.

AbstractAim of this project was to analyse signals and try to localize the position of source of sound. It is donewith three microphones which have 90 degrees angle to each other. Each microphone detects one partof the sound wave. The microphones are connected toan ADC which turns signals from analogue todigital shape. After that the three signals are transformed to a computer.

In today?s technological society, there are increasingly less physical demands on the locomotor system. However, despite that notion strength and function in the hand?s complex biomechanical system are in fact both needed to cope with daily life. The grip function is a main function in the hand and is used in many examples of scientific research, for instance when assessing physical health and predicting the probabilities of premature mortality.

In Sweden the amount of people with obesity has increased with almost 50 % during the past 20 years and is now including 500 000 people. A larger energy intake than energy consumption is today one of the most important cause of overweight and obesity that exist in the world. This requires more knowledge about healthier eating habits combined with moderate intensive exercise, exercise that is simple, effective and amusing. A god solution is a combination of fitness training and strength training, a type of circuit training. It is distinguished by a high intensive work in short periods and with a short break.

In today?s technological society, there are increasingly less physical demands on the locomotor system. However, despite that notion strength and function in the hand?s complex biomechanical system are in fact both needed to cope with daily life. The grip function is a main function in the hand and is used in many examples of scientific research, for instance when assessing physical health and predicting the probabilities of premature mortality.

This Master's Thesis describes the design of a new system where a digital signal processor has been added to an existing imaging system consisting of field programmable gate arrays. The new system will offer a higher degree of flexibility by considerably shortening the design time and make it possible to implement more complex algorithms than the existing ones. The choice of system architecture and a test implementation are discussed. The test implementation consists of a program for the digital signal processor and VHDL code for one of the field programmable gate arrays. The code for the digital signal processor was designed for testing on an evaluation board from Texas Instruments.

In cooperation with Hälsoteamet Halmstad a pilot study was made to see if whole body vibration exercise has any effect on muscle strength, movement and experience of pain in people with knee osteoarthritis. Today whole body vibration exercise is a revolutionary exercise method that needs more studies to show the positive and negative effects. Osteoarthritis is a degenerative disease where more cartilage is destroyed than replaced. The most common symptoms are pain, stiffness, restricted movement, muscularly atrophy, tenderness and instability. The cartilage needs pressure to rebuild, it is therefore important that the patient exercise.

In today?s technological society, there are increasingly less physical demands on the locomotor system. However, despite that notion strength and function in the hand?s complex biomechanical system are in fact both needed to cope with daily life. The grip function is a main function in the hand and is used in many examples of scientific research, for instance when assessing physical health and predicting the probabilities of premature mortality.