Wastewater handling of private Sewage systems has become an all increasing matter. In Stockholm region the 90 000 private Sewage systems contribute with larger phosphorus flows to the Baltic Sea than the two biggest Sewage plants in the area, Henriksdal and Käppala, contribute together, even though these two plants purify wastewater from more than one million inhabitants. When summer house areas turn into areas for permanent living ? transition areas ? the load on the existing systems increases, systems that already often are unsatisfying. In those areas it is not clear what the best system choice is; On-site systems for single households; Local collective systems or Connection to central systems.

The private Sewage systems in Sweden releases around 600 tons of phosphorus per year, compared to about 350 tons from municipal Sewage treatment plants, and they account for approximately 21% of the total anthropogenic discharge of phosphorus into Swedish waters. About 40% of Sweden's nearly 1 million private Sewage systems are inferior with respect to emissions to surface and groundwater. The technology of small Sewage plants is under development and knowledge of treatment effects for different solutions is poorly consolidated. Municipal authorities lack resources to keep up with the technologic development and assess the reliability of the treatment performances that suppliers report for their products. The thesis aims to conduct a market review and evaluation of wholly or partially prefabricated small Sewage plants, to make it easier for municipalities and property owners to assess different technical solutions. The goal is a compilation of the products on the market, evaluated on the basis of the reliability of specified degrees of reduction.Information on sampling procedures and test results were collected through a questionnaire to all active suppliers and the responses were then used to classify the products.

On-site Sewage systems are common on the countryside of Sweden with approximately one million on-site systems installed. Due to insufficient function, these contribute significantly to the total discharge of phosphorus to rivers and lakes, causing eutrophication. In order to reduce eutrophication and to fulfil one of the environmental quality objectives, the decision was taken by the Swedish Government in 2005 that 60 % of phosphorous in Sewage sludge is to be recycled to arable land before 2015. To make recycling a reality, new solutions have to be found. Federation of Swedish Farmers (LRF) takes an active interest in this issue and has initiated this study. One problem is that the food industry is sceptical towards recirculation due to the risks that products from Sewage systems may contain pathogens, heavy metals and unwanted chemical compounds, e.g.

There are around 855 000 on-site Sewage systems in Sweden and some 1 800 of these are located in the municipality of Sigtuna. The Sigtuna local authority has set the goal that all Sewage systems with insufficient function should be improved before the end of year 2010. A malfunctioning on-site Sewage system may cause three main problems: spreading of diseases, discharge of eutrophicating compounds and wastage of resources. The municipality strives to reduce these problems already at the stage of granting permits for installation of on site sanitation systems. The municipality has recently adopted new guidelines, which demands certain minimum reductions for different compounds. The guidelines also state that it is preferred that neighboring house-owners cooperate in jointly built and operated Sewage systems and that the system should be able to recycle plant nutrients.

For many years, the construction industry in Sweden has not developed much of an integral approach for design across disciplines. The sector?s impact on society, economics and environment is huge. To make the interactions within the construction industry more efficient, a relatively new concept called BIM (Building Information Modeling) has been introduced. The idea with BIM is that the different actors of the construction industry will work through intelligent CAD software, with common file formats and more cooperation between different actors during the various steps of the building and construction process.The technical consultancy company WSP Sweden is working actively to implement BIM within the frame of its activities.

Filtermaterial av 75 % torv och 25 % kolaska har använts under 2 respektive 4 år för rening av avloppsvatten från två biltvättar. Jämförelse med Kristianstads kommuns riktvärden för avloppsvatten från fordonstvättar visar att filtren fungerat. För avfallsklassning krävs kunskap om innehåll av miljöfarliga ämnen i produkter som använts i tvätthallarna. I brist på kunskap om innehåll av ej analyserade miljöfarliga ämnen i filtren anses förbränning vara ett bra omhändertagande ur miljösynpunkt, då energi och aska återvinns..

Bringing back the nutrients from the city to the country is becoming increasingly important, as the world?s stores of nutrients get more exhausted. Sewage sludge is an unapplied resource, rich in plant nutrients, which could replace parts of the commercial fertilizers used in Sweden today. Sewage sludge may contain large amounts of pathogens, such as Campylobacter and Salmonella, why use can cause severe spreading of infections, both to animals and humans. These pathogens have the ability to survive for a long time in soil and water and therefore some sort of treatment of the sludge is recommended before use.

Wastewater treatment is increasingly controlled by the Swedish environmental quality objectives, adopted by the Swedish parliament. There is a need for a Sewage system that can fulfill stringent requirements concerning the environment, recycling and resource use and hygiene. Additional environmental aspects in recent years are the impact of climate change, new knowledge about the effects of pharmaceuticals in water, the need for improved wastewater treatment and increased recycling of nutrients to agriculture. This report has, from a future scenario of the year 2050, analyzed seven different systems for wastewater treatment and treatment of compostable biowaste from households in Eskilstuna. A future scenario was chosen based on that within a forty year period new challenges may arise which can result in higher demands on Sewage treatment than those we see today. Another reason why the future scenario was established is that changes in wastewater treatment systems are slow to establish. The analysis is mainly focused on the economical aspects but environmental aspects such as emissions to receiving waters and potential recycling of plant nutrients has also been evaluated briefly.

Biogas is a renewable energy produced through anaerobic digestion, which means that organic matter is degraded by microorganisms under anaerobic conditions. The produced biogas can then be used for cogeneration, electricity, heat or upgraded to vehicle gas. Eskilstuna Energy & Environment AB has four digesters at Ekeby water Sewage treatment plant, Eskilstuna. One of the biogas reactor (RK4) is equipped with a jet-mixing system while the remaining digester uses top-mixing. The mixing system is an important parameter to achieve optimum operating conditions for the process regarding gas production and degree of digestion.

The access to good sanitary facilities is an important factor that elevates the experienced living standard as it improves hygiene and reduces the transmission of deseases. The ratification of the millennium goals by 189 countries demonstrates that this is an important international issue. Together the countries have taken upon themselves that the proportion of the population that lacked access to sustainable safe drinking water and sanitary facilities in the year 2000 will have been reduced by half by the year 2015. In Peru, the construction of Sewage pipe networks to transport the Sewage out of the direct human environment is progressing. The safety and sustainability of these systems can be questioned, since in Peru the Sewage seldom receive any treatment before being emitted to a recipient. This is taking place in Picota and sorrunding villages as well. In the last 25 years several systems implementing small-scale onsite treatment have been introduced throughout Latin America in an attempt to give more people access to sustainable and safe sanitary facilities, reducing water consumption and taking advantage of the agricultural values of the Sewage fractions while protecting the environment from its negative impact. In this study three different sanitary systems and the effects of different population growths were compared.

Ground construction has to a large extent been dominated by traditional meth-ods during the last 50 years. Although the construction has been changed meanwhile innovations are not accepted. In collaboration with NCC Ltd Region South, I have examined a modern con-struction methodology that has been developed by NCC for future large pro-jects. The method is divided into two central phases. Phase 1 is? Single Pro-duction? which is a preliminary period for ground constructions to come.

Swedish biogas is currently produced mainly by anaerobic digestion of Sewage sludgeat Sewage treatment plants, landfills and anaerobic digestion of household or industrialwaste. Also cattle ma-nure from farms can be used to produce biogas. Upgradingbiogas represents an increase in methane concentration from about 65 % to about 97%. In addition, particles and contaminants must be sepa-rated from the upgradedbiogas. There are various methods for upgrading and this report compares sixdifferent methods with respect to environment and economy: water scrubber,Biosling, cryo technology, chemical absorption, Pressure Swing Adsorption (PSA) andmembrane separation.According to the used ORWARE model, chemical adsorption with amine has the leastenvironmen-tal impact (methane emissions) and the lowest costs.

The purpose of this study has been to make an inventory of combustible waste in the region around Norrköping and to investigate the composition of domestic waste, industrial waste and two different types of sludge. The work was performed at the request of Norrköping Miljö & Energi, due to the planning of an incineration plant. The inventory of the waste was performed through inspection of environmental impact reports, from waste disposal plants in a number of local government areas in the region. The quantities were also compared to another inventory, carried out in a different way. The characterisation of the wastes was compared to the fuel specification determined by Norrköping Miljö & Energi.

ABB I-R Waterjet Systems combines the robotics and motion expertise of ABB Flexible Automation with high-pressure intensifier/pumping technology from Ingersoll-Rand to provide and continue to develop innovative waterjet cutting systems for global markets. The purpose of this assignment is to develop a process water purifier. The purifier should be applicable as an option to ABB I-R?s production cell Cutting-Box. At first hand the process water should be purified well enough to let out in the municipal Sewage system, but the ultimate solution is purifying the process water to the range that recycling is possible.

Eutrophication of lakes and streams are nowadays a well known environmental problem and implies an enrichment of the nutrients phosphorus (P) and nitrogen (N). Phosphorus is considered to be the most important component for the growth of aquatic plants and leads in too large quantities to an intensification of growth. Phosphate (PO4) is the fraction of phosphorus that can easiest be taken up by plants and thus have the greatest impact on eutrophication. Increased plant growth in lakes and unfavorable conditions for aquatic animals are two examples of negative consequences. A significant portion of the increased nutrient supply to nearby water can be derived to phosphate leaching from agricultural areas, where private sewers and agriculture is two main sources.