Sök:

Sökresultat:

179 Uppsatser om Sensor - Sida 11 av 12

Halvledare för höga strömmar i fordon

Mechanical relays are more and more being replaced with semiconductortechnology. In this thesis it is investigated if and how the larger loads couldbe controlled by transistors. The main part of this work aims to create andverify a solution that can control the starter motor, as well as protect it incase of any failure. The different malfunctions that the solution protectsagainst is high current, too high peak current, low current, maximum cranktime and minimum cool off time. The timers also protect indirectly againstoverheating of the starter engine.The transistors used are BTS555, from Infineon.

Noggrannhet vid målinmätning : Analys av ett eldledningsinstrument med förbättringsförslag

This Master Thesis has been conducted as an assignment of the Swedish Defence MaterialAdministration and the Swedish Armed Forces and aims to examine the Target Location Error(TLE) of a Forward Observer System. The targeting accuracy of the system is vital if the systemis to be used as a Sensor for precision munitions. The analyzed system, EOI (FOI 2000), wasdelivered to the Swedish Armed Forces in 2007. The targeting sequence starts with deciding theposition of the system with a GPS-receiver, continues with methods where the north direction issettled and ends by measuring the distance, direction and elevation to the target. When allparameters have been measured the system calculates the position of the target.

Kadenssensor med en accelerometer och ANT+

Rapporten presenterar det examensarbetet som har gått ut på att undersöka möjligheterna att konstruera en Sensor som mäter kadens med hjälp av en accelerometer. Implementation av kadensprofilen till ANT+ har gjorts för att möjliggöra synkronisering mellan en sportklocka och Sensorn. Kadens är hur fort cyklisten trampar med pedalerna mätt i enheten Varv per minut vanligt förkortat RPM från engelskans Revolutions Per Minute. Hur fort en cyklist trampar påverkar kroppen på många olika sätt och ofta vill cyklisten veta vad aktuell kadens är för att optimera sin prestation. Den undersökta principen att använda en accelerometer för att mäta kadens syftar till att en eventuell prototyp skulle vara lämplig till inomhuscykling även kallad spinning.

Bildanalys för navigering i autonoma sensor-platformar

Det bör vara möjligt att skapa verktyg för att beskriva scenarion och med hjälp av tillgänglig mjukvara för visualisering kunna spela upp både verkliga och simulerad bilddata. Detta examensarbete beskriver hur några sådana verktyg tagits fram. Till förfogande fanns en stor mängd bilddata, insamlad på ett militärt övningsområde som dessutom finns representerad som en syntetisk omvärldsmodell. Insamlingen gjordes med en UAV (Unmanned Aerial Vehicle)- prototyp, som var utrustad med videokamera, IR-kamera och tröghetsnavigeringssystem. För att simulerad bilddata skulle få ett verklighetstroget intryck placerades markfordon ut i den syntetiska modellen på exakt samma position som under fältförsöken.

Kan obemannade undervattensfarkoster förbättra ubåtens förmågor?

Denna uppsats ger ett bidrag till frågeställningen runt hur en obemannad undervattensfarkost (UUV) kan ge operationsfördelar för en konventionell ubåt. Uppsatsen grundar sig på en analys av den amerikanska flottans UUV-planer samt en operativ kommersiell undervattensfarkost (HUGIN) från företaget Kongsberg i Norge. Syfte är att identifiera lämpliga förmågor, samt undersöka möjliga operationsfördelar med att applicera dessa på en svensk ubåt inom insatsförsvaret.Metodmässigt bygger uppsatsen på en jämförelseanalys mellan en konventionell ubåt som är utrustad med dessa UUV-förmågor och en utan, för att därmed klargöra operationsfördelar. Resultatet av den genomförda analysen med fokus på det internationella uppdraget ger att den slutliga helhetsjämförelse visar att UUV-förmågor som förbättrar ubåtens spaningsförmåga är de mest lämpliga att implementera. Denna inkluderar förbättrad lägesbild med framskjuten Sensor, karteringsmöjligheter medförande bottennavigeringsmöjlighet, en bättre planering och utnyttjande av Sensorer och vapen.

Unified Flow Sensor

Value stream mapping is a tool that is frequently used by many different companies. It is a great tool used to achieve the work that follows the theories of lean production. The tool is used, however, only frequent on the factory floor and the method is also designed based on this type of use.An interest of applying the method on administrative parts of the company has occurred lately. Administrative parts of the company refers to the part that does all the planning such as purchasing, receiving orders, customer contact, contact with factory floor and other work that is made around the actual manufacturing. But the knowledge about applying value stream mapping on the planning part of the company is lacking because the method is relatively new.In this work, a comparison is made between the introduction of value stream analysis on production and planning.

Bildanalys för navigering i autonoma sensor-platformar

Det bör vara möjligt att skapa verktyg för att beskriva scenarion och med hjälp av tillgänglig mjukvara för visualisering kunna spela upp både verkliga och simulerad bilddata. Detta examensarbete beskriver hur några sådana verktyg tagits fram. Till förfogande fanns en stor mängd bilddata, insamlad på ett militärt övningsområde som dessutom finns representerad som en syntetisk omvärldsmodell. Insamlingen gjordes med en UAV (Unmanned Aerial Vehicle)- prototyp, som var utrustad med videokamera, IR-kamera och tröghetsnavigeringssystem. För att simulerad bilddata skulle få ett verklighetstroget intryck placerades markfordon ut i den syntetiska modellen på exakt samma position som under fältförsöken. Markfordonens position mättes in med DGPS och UAV:ns hastighet, position och rotation bestäms med GPS och tröghetsnavigeringssystem. Resultatet, i form av lagrad tröghetsnavigerings- och Sensorstyrnings-data, ges efter en Kalmanfiltrering och blir vanligtvis noggrannare än vad som erhålls från de respektive delsystemen. Tyngdpunkten i arbetet låg i att ta fram Matlab-funktioner som plockar ut rätt vy vid rätt tidpunkt och åskådliggör detta på ett tydligt sätt, samt att placera ut markfordonen enligt de givna koordinaterna.

Utveckling och dimensionering av en lastupptagande provningsram

ÅF Test Center in Borlänge had a need to expand their capacity for compressive and tensile strength tests. They wanted to do this by using a hydraulic cylinder, which they already possessed, to apply the force with. This required a load receiving structure. The aim of this work was to design and dimensioning a test bench for a cylinder marked NIKE 300 tons. The work would result in a completed design proposal on a test bench which could manage to run the compressive and tensile strength tests of up to 3000 kN.

Konstruktion av patientsimulator för anestesimaskiner

A patient simulator for testing anaesthesia machines has been developed at Maquet Critical Care AB, to reduce costly and time-consuming experiments on animals. The device simulates human lungs regarding lung dynamics and volume, uptake of anaesthetic agents and the production of carbon dioxide, heat and moisture. Further demands on the simulator are durability and size; the device shall be compact enough to be moveable.The resulting simulator fulfils the requirements and enables better repeatability and ability to test extreme cases than experiments on animals do.Uptake of the anaesthetic agent is achieved in a active carbon filter and controlled by regulating the flow. The flow is created by a regenerative blower and controlled using a proportional valve. The uptake can be set by the user or by a simple uptake model modified to recursively handle changes in the concentration of anaesthetic agent.Carbon dioxide is fed into the system from a tank by a mass flow regulator.

PIEZOELEKTRISK TRYCKSENSOR : En undersökning om textil struktur och piezoelektricitet

Arbetet syftar till att skapa en prototyp av en textil tryckSensor som kan känna av och skilja på olika typer av belastning. En lämplig metod för att på ett vetenskapligt sätt testa sagda prototyp har också utvecklats. Prototypen har tillverkats för hand på en datoriserad vävstol och de ingående materialen är piezoelektrisk poly(vinyldifluorid), PVDF, tvinnad tillsammans med ett konduktivt garn, Shieldex®, samt polyester. När PVDF-fiber utsätts för töjning genererar de en spänning, vars storlek står i relation till töjningen. Den vävda konstruktion som valdes till prototypen är en distansvara där väftinläggen lagts in i 7 olika lager för att skapa volym.

Hur kan personer med hja?rtsvikt testa va?rden i hemmet, fo?r en snabbare behandling och korrigering av medicinering?

- To be trapped in a roller-coaster That ?s how some of the patients are describing the situa- tion of living with heart failure. To be stuck in their home not knowing if they will have to seek care today and not knowing if they will have the energy to attend that birth- day party later this week.Each year 2-3% of the Swedish population are diagnosed with heart failure, which results in 30,000 new individu- als with the disorder. Cardiovascular disease is rapidly in- creasing in the world and before 2030, people with heart failure will increased by 100%. Our improved living condi- tions and better health have allowed us to grow older and made us more dependent on other types of care, care at home.Today the patients are only looking for changes in weight and if they have excessive water in their body.

Augmented Reality i mobiltelefonen : En kunskapssammanställning med trafikinriktning

This master thesis is about Augmented Reality (AR), a phenomenon that has existed since the mid-fifties but only recently has become available for the general public. This report is a knowledge compilation about AR, focusing on AR in cell phones and the use of the technology in traffic related situations.AR is usually described as adding a digital layer of information onto the real world. There are different technologies to make virtual images; in cell phones Sensor-based and camera-based technologies are the most common ones.In this report, the market of AR applications for cell phones has been investigated. Three use cases have also been investigated in order to get more knowledge about the designers' thoughts and visions.In order to analyze the technology and the applications in a broader and more scientific perspective, two theories has been used: Situation Awareness (SA) and the Service Dominant Logic (SDL). These theories seem useful when reflecting on the Swedish road administrations vision, and to investigate what the applications and the AR technology can contribute to the traffic domain.The conclusions of this thesis are that:- AR can be applied on most of the human senses, but augmenting by visualization is most common.- The market for cell phone applications is growing rapidly: AR applications are relatively new but on the rise.

JAS 39C - markförbandens nye rotekamrat?

När vi nu står inför en ominriktning i Försvarsmakten mot ett insatsförsvar kommer förband och organisationställas inför nya utmaningar och uppgifter. För flygvapnet kan detta ställa till en del problem i och medatt materielplanen är långsiktig och tiden från beslut om anskaffning till implementering av nya system oftaär lång. Detta är inte fallet med politiska målsättningar vilka kan vara mycket föränderliga och ändra inriktningfrån ett försvarsbeslut till ett annat. När den politiska inriktningen för Flygvapnets förmåga till internationellainsatser nu även innefattar förmågan till flygunderstöd till Nordic Battle group, har då Flygvapnetmed JAS 39C som verkanssystem möjlighet att genomföra direkt flygunderstöd i moderna internationellakonflikter?Syftet med denna uppsats har varit att analysera om JAS 39C, med tillhörande vapen-, Sensor- och kommunikationssystem,uppfyller de krav som ställs på ett flygsystem vid genomförandet av DFU i en internationellinsats.

Dietary fibre composition and sensory analysis of heat treated wheat and rye bran

When grains of wheat and rye are conventionally milled, large quantities of bran classified as by-products are left and are mainly used for animal feed. Bran is a complex material composed of the aleurone layer, nucellar epidermis, a seed coat, a fruit coat and a small proportion of the germ and endosperm depending on extraction rate. The bran fraction consists of approximately 40-50 % dietary fibre which can contribute to increase the nutritional quality of human cereal food. It would also be valuable for the food industry to convert by-products as bran to products with higher commercial values. The aim of this thesis was to analyse the content and composition of dietary fibre of heat treated wheat and rye bran according to the Uppsala method with some modifications in order to analyse soluble and insoluble dietary fibre separately. Half of the bran samples were precooked, dried and roasted and the other half dried and roasted (uncooked).

Statistical ion distribution functions from the IMA sensor on Venus Express

Idag är turismen en av världens största näringar och den förväntas växa ytterligare framöver. Turismen bidrar på många sätt till den ekonomiska utvecklingen världen över men effekterna av tillväxten kan även få förödande konsekvenser för miljön. En ökad miljömedvetenhet inom turismbranschen har på senare tid resulterat i olika miljöledningssystem och miljömärkningar. En miljömärkning är Svanen som bildades som ett svar på den ökade miljömedvetenheten i samhället. År 1988 beslöt sig det Nordiska Ministerrådet att utreda möjligheterna att införa en frivillig nordisk miljömärkning.

<- Föregående sida 11 Nästa sida ->