The energy sector of modern time is currently faced with several challenges. These are both production oriented and environmental oriented in nature. The energy of the future is intended to support an increasing demand while at the same time reduce its environmental affection. This stresses a development towards production methods of Renewable energy. Among the existing methods, biogas is presented as an attractive alternative.

In the thesis we have shown that it is possible with current technology, to buildneighborhoods that are largely self-sufficient. We have obtained some information aboutongoing work in the field of energy efficient buildings and active house which we have usedto develop a model. The feasibility study for Ranagård we have e.g been forced tofollow laws on groundwater covered, resulting in the construction of basements for singlefamilyhome is not possible. The model that we have built up overtime has been the central part of the work. The model illustrates very well what an activehouse neighborhood means and potential of such an area.

In several countries that have been early in the development of wind farms, there is today a second hand market for the used wind turbines. The European Union (EU) has established a waste hierarchy in order to minimize throwaway mentality. The second hand market is a part of this as the steps are to minimize, reuse, recycle, extract energy and landfill.In order to promote the development of Renewable energy, there are energy certificates for the producers that provide it, wind power being one type of Renewable energy. After 15 years the energy certificates for a specific wind turbine are no longer paid, and after that there are several different scenarios for the wind turbine. The scenarios investigated in this bachelor?s thesis are export of the wind turbine to countries that are not as far along as Sweden in their development towards Renewable energy, selling in Sweden to individuals, and recycling of the wind turbine, as it mostly consists of metals and therefore is recyclable.

This study concerns the energy future of the county of Stockholm up until 2050 and describes how the energy consumption can be compared to today with the use of scenario methodology. Within energy future studies the backcasting approach is well known and has been put to use in this study. Due to the characteristics of backcasting the study is self-fulfilling, i.e. the future energy scenarios presented in this study satisfy the targets set up in this study. In the light of what may be the largest challenge of our time ? the climate change - the aim of this study is to describe how the energy consumption in a fossil fuel free Stockholm county in the year of 2050 may be.

A possible way to reduce pollution and slow down the process of global warming is to increase the usage of Renewable energy sources. One of these Renewable energy sources is solar power. With the aid of solar panels and solar cells the energy from the sun can be transformed into both heating and electricity. The requirement to use the sun in this fashion is a suitable surface, for example a big roof, an angle between 40-60 degrees and that the surface should be exposed to the south. Almost every farm meets these requirements.

With the climate change issues growing in importance on the social agenda, the field of urban masterplanning is of no exception when it comes to minimizing the carbon footprint in a variety of projects. The aim of this thesis has been to prepare the Carbon Critical Masterplanning tool, a software plugin for carbon dioxide emissions assessment developed by Atkins, to be used in Swedish conditions. The main targets were to improve the areas of the tool associated with energy conversion and Renewable energy sources, and to test the tool in a real case. A planned construction of a new campus in Albano, Stockholm was chosen for the pilot study. A 3D model was built in the tool and the carbon footprint was calculated for a variety of combinations for energy supply to the future area.

With the climate change issues growing in importance on the social agenda, the field of urban masterplanning is of no exception when it comes to minimizing the carbon footprint in a variety of projects. The aim of this thesis has been to prepare the Carbon Critical Masterplanning tool, a software plugin for carbon dioxide emissions assessment developed by Atkins, to be used in Swedish conditions. The main targets were to improve the areas of the tool associated with energy conversion and Renewable energy sources, and to test the tool in a real case. A planned construction of a new campus in Albano, Stockholm was chosen for the pilot study. A 3D model was built in the tool and the carbon footprint was calculated for a variety of combinations for energy supply to the future area.

With the climate change issues growing in importance on the social agenda, the field of urban masterplanning is of no exception when it comes to minimizing the carbon footprint in a variety of projects. The aim of this thesis has been to prepare the Carbon Critical Masterplanning tool, a software plugin for carbon dioxide emissions assessment developed by Atkins, to be used in Swedish conditions. The main targets were to improve the areas of the tool associated with energy conversion and Renewable energy sources, and to test the tool in a real case. A planned construction of a new campus in Albano, Stockholm was chosen for the pilot study. A 3D model was built in the tool and the carbon footprint was calculated for a variety of combinations for energy supply to the future area. The results show that use of locally installed Renewable energy sources can reduce the total climate impact when life cycle perspective is applied.

With the climate change issues growing in importance on the social agenda, the field of urban masterplanning is of no exception when it comes to minimizing the carbon footprint in a variety of projects. The aim of this thesis has been to prepare the Carbon Critical Masterplanning tool, a software plugin for carbon dioxide emissions assessment developed by Atkins, to be used in Swedish conditions. The main targets were to improve the areas of the tool associated with energy conversion and Renewable energy sources, and to test the tool in a real case. A planned construction of a new campus in Albano, Stockholm was chosen for the pilot study. A 3D model was built in the tool and the carbon footprint was calculated for a variety of combinations for energy supply to the future area.

The Swedish building and property management sector are responsible for about 30 % of the total energy use. In order to take environmental consideration, different environmental assessment tools and standards are used. Miljo?byggnad, Svanen, FEBY12 and PHI are some of these. There has been increased interest to certify buildings and therefore it is of interest to evaluate the assessment of the energy field to see if relevant energy aspects are assessed.

The housing sector uses 40 % of the energy in Sweden and half of the electricity usage. Theuse of energy is the main reason to the increasing rate of carbon dioxide in the atmosphere.This is the main motive but also a wish of higher safety, that is a higher rate of selfsufficientenergy production in Sweden, we want to decrease the need of using fossil fuel. Now whenthe energy price rise, the interest in energy issues increase and more people discuss thepossibility of reducing the usage of fossil fuel. A change to Renewable energy such as sun,wind and water is the only solution where we can get a sustainable development.One way to contribute to a better use of energy is to build in the principle of passive house.The house is being built with a thick and tight insulation. If you use a heat-exchanger withhigh degree of efficiency and a final heating battery on the ventilation system, the heat fromlamps, devices and the ones living in the house should be enough to fulfil the criteria ofliving.

Australia is one of the largest producers and consumers of fossil fuels in the world. In a society where the effects of fossil fuels on global warming are constantly discussed, the nation?s production and consumption are subject to debate. Problems arise when negative aspects of consumption, such as emissions of greenhouse gases, are put in relation to an increased need of energy and economic growth. However, it is important to distinguish between different types of fossil fuels when it comes to their individual impact on the environment and to analyze the possibilities to increase the more environmental friendly ones.

Wind power is one of the sources of Renewable energy which has to be developed further in order to lessen our dependence on non renewable sources of energy. It's mainly oil and coal which have to be replaced by green energy. Wind power is already established in many countries, for example Germany, The United States of America and Denmark but it has to be continually developed and expanded to meet the needs of the growing energy consumption in the world. During the last few years many types of small wind turbines have appeared on the market. These small wind turbines are an alternative to the big wind turbines or power generators which demand huge sums of investment money.A new target group can now buy the small wind turbines in order to cover their own usage of electricity.

Photovoltaic Systems in Sweden has longbeen heavily dependent on subsidies and grants to bring in a profit for the investor. Production of excess electricity is a major reason for this as the compensation for excess electricity today is low. However, there are businesses that have an electricityneed that are particularly suitable for solar electricity. These businesses have an electricity demand when the sun shines the brightest and if the Photovoltaic System is properly scaled, the excess electricity can be minimized. A golf club is that kind of a business and this thesis aims to examinate the solar power potential for golf businesses in Sweden.Nine golf clubs was selected from different locations in Sweden.

As the Swedish governments long term goals include a reduction of fossil fuel dependency, increasing pressure is placed upon energy companies to create and develop new solutions for Renewable energy. The following case study was done in collaboration with the company Sydved Energileveranser AB and one of their contractors, Enarssons Skogsentreprenad AB. The objective of the study is to examine the bioenergy situation in region of Skåne and evaluate the potential solutions in the region for a forest-fuel assortment, based on a bioenergy-cutting-system. As a part of this study I have compared ordinary manual cuttings done with a chain saw and cuttings made using the new ?bio- energy cutting system?. The cuttings made under both systems were tested in areas near agricultural fields or pasture land in order to maintain an open landscape.