This master thesis studies distributed navigation which isa function implemented in a future network based combat information system to improve the accuracy in navigation for combat vehicles in a mechanized battalion, above all in the event of loss of GPS. In the event of loss of the GPS the vehicles obtain dead reckoning performance through the backup system that consists of an odometer and a magnetic compass. Dead reckoning means a drift in the position that makes the accuracy in the navigation worse. The distributed navigation function uses position and navigation data with measurements between the vehicles to estimate the errors and uncertainties in positions, which are used to improve the accuracy in position for the vehicles. To investigate and demonstrate distributed navigation, a simulation environment has been produced in Matlab.

An excessive input of nutrients to lakes and other water bodies has created a problem with eutrophication in Sweden. Untreated, or partially treated, domestic sewage is a major source for discharge of phosphorus (P), which is the nutrient most frequently responsible for eutrophication of most fresh waters and the Baltic Sea. The waste water can be cleaned by filter materials, which have a high P-retention ability and which after saturation may be used as fertilizers. Four potentially suitable filter materials were tested in batch- and column experiments in this study. In the batch experiments, the following materials were shaken with waste water in time series ranging from 5 seconds to 60 minutes: coarse (1-4 mm) and fine (0-2 mm) Polonite® (heated bedrock from Poland); Filtralite® (light expanded clay aggregates with limestone added before burning); water cooled blast furnace slag (BF-slag) and BF-slag mixed with 10% burned limestone.

The global Positioning System (GPS) provides location and time information as long as there are unobstructed lines of sight to four or more GPS satellites. However, when this is not the case the signal may be inaccurate or sometimes even completely blocked. In these situations the Inertial Navigation System (INS) is an appropriate choice for positioning.  An INS has already been proposed in a previous thesis by Erik Andersson and the objective of this thesis is to fuse the GPS with the INS in a proper way. A part of this project is to decide the reliability of the GPS.Three methods for GPS reliability detection have been proposed. One method based on the statistical properties of each of the separate systems, and two methods based on the statistical properties of the residuals between the GPS and INS.

This reports goal is the give BSR AB more information that's useful towards their customers in marketing of their products.It involves tests of different air filters designed for cars and 3D-modelling of Opti-Flow systems. The three models thats being tested is SAAB (93SS), VAG (1.8T) and Volvo (S60). To every brand there are three different models. A orginal- , sport- and an open cone air filter (Opti-Flow).The results indicate that the open Opti-Flow filter has better performance compared to the other cased filters. The sport filters for SAAB and Volvo has better performance then the original filter.

When a helicopter is flying, the dynamics vary depending on, for example, speed and position. Hence, a time-invariant linear model cannot describe its properties under all flight conditions. It is therefore desirable to update the linear helicopter model continuously during the flight. In this thesis, two different recursive estimation methods are presented, LMS (Least Mean Square) and adaptation with a Kalman filter. The main purpose of the system estimation is to get a model which can be used for feedback control.

The purpose of this report is to evaluate different methods for identifying states in robot models. Both linear and non-linear filters exist among these methods and are compared to each other. Advantages, disadvantages and problems that can occur during tuning and running are presented. Additional measurements from accelerometers are added and their use with above mentioned methods for state estimation is evaluated. The evaluation of methods in this report is mainly based on simulations in Matlab, even though some experiments have been performed on laboratory equipment.The conclusion indicates that simple non-linear models with few states can be more accurately estimated with a Kalman filter than with an extended Kalman filter, as long as only linear measurements are used.

In Sweden more than 400 000 private households have not yet sufficient wastewater purification. These effluent is considered as an increasing problem and many onsite purification methods have been studied. In this investigation, the method of reactive bed filters have been tested by column and batch experiments. Five different kinds of filter materials with reactive surfaces have been studied concerning their capacity to absorb ammonium and phosphorus from wastewater. The materials that were examined are Filtra N, wollastonite Filtra P, blast furnace slag and Polonite®.

Vid mixning i en hemmastudiomiljö finns det ofta stora akustiska problem, speciellt vid låga frekvenser. Vid just låga frekvenser orsakas problemen främst av stående vågor. För att reducera de stående vågorna används vanligen passiva absorbenter, men i en hemmastudiomiljö kan dessa av praktiska skäl ofta inte användas. I denna uppsats har något som kallas inversa filter undersökts som möjligt alternativ. Dessa skapas från ett uppmätt rumsimpulssvar och appliceras på signalen till högtalaren genom faltning.

Vid mixning i en hemmastudiomiljö finns det ofta stora akustiska problem, speciellt vid låga frekvenser. Vid just låga frekvenser orsakas problemen främst av stående vågor. För att reducera de stående vågorna används vanligen passiva absorbenter, men i en hemmastudiomiljö kan dessa av praktiska skäl ofta inte användas. I denna uppsats har något som kallas inversa filter undersökts som möjligt alternativ. Dessa skapas från ett uppmätt rumsimpulssvar och appliceras på signalen till högtalaren genom faltning.

Today?s wind power plants are only compensated for their reactive power consumption at no-load. As the wind power plants grow bigger the amount of reactive power they need also increases. This is no longer a problem that can be ignored, especially as the net owners are beginning to charge the reactive power they transport.In this thesis a couple of different methods of compensation and their prices will be discussed and evaluated. Problems, such as self-excitation, that can occur if one fully compensates the wind power plant will also be brought to surface.

Today?s wind power plants are only compensated for their reactive power consumption at no-load. As the wind power plants grow bigger the amount of reactive power they need also increases. This is no longer a problem that can be ignored, especially as the net owners are beginning to charge the reactive power they transport.In this thesis a couple of different methods of compensation and their prices will be discussed and evaluated. Problems, such as self-excitation, that can occur if one fully compensates the wind power plant will also be brought to surface.

Today?s wind power plants are only compensated for their reactive power consumption at no-load. As the wind power plants grow bigger the amount of reactive power they need also increases. This is no longer a problem that can be ignored, especially as the net owners are beginning to charge the reactive power they transport.In this thesis a couple of different methods of compensation and their prices will be discussed and evaluated. Problems, such as self-excitation, that can occur if one fully compensates the wind power plant will also be brought to surface.

Implementering av FIR filter kan göras på olika sätt. I detta examensarbete har två olika varianter beskrivits med hjälp av VHDL, syntetiserats, simulerats och sedan jämförts med avseende på effektförbrukning..

Today?s wind power plants are only compensated for their reactive power consumption at no-load. As the wind power plants grow bigger the amount of reactive power they need also increases. This is no longer a problem that can be ignored, especially as the net owners are beginning to charge the reactive power they transport.In this thesis a couple of different methods of compensation and their prices will be discussed and evaluated. Problems, such as self-excitation, that can occur if one fully compensates the wind power plant will also be brought to surface.

Violent crime can traditionally be classified as a reactive or an instrumental aggression. A reactive aggression is often characterized by some sort of provocation by the victim and the act is impulsive and the offender reacts by harming the victim. The provocation can be a threat, an insult or an attack and the act can be said to be a reaction induced by emotions. An instrumental act of violence however, often described as planned, targeted and emotional cold. The goal of the act can be to acquire money or power to maintain their status.