This final project discusses renewal and upgrading of the area of Prim. It is discussed how this industrial area can be an attractive neighborhood with a varied range of services and commercial trade. Prim is located 2km north-east of the center of Barcelona. The area boarders to a deep railway valley that historically has separated Prim from its neighboring districts. At present there is almost no housing, services or commercial trade within the area and the industry is discontinued or the existing industrial buildings are derelict.

Rock groundwater has always caused major problems when tunnelling. Water leaking into tunnels can cause large problems, not only on the construction itself but also on the environment. A continuous water leakage can lead to a declining water supply, and geotechnical problems can occur as subsidence in the ground. Therefore it is of great importance to predict the consequences that can appear in the surroundings due to a declining groundwater surface.The aim of the study was to investigate different methods for predicting leakage and changes in groundwater level due to tunnelling excavations in rock. This thesis was performed by comparing mathematical methods, actual groundwater changes and results from preliminary investigations.Investigations were made for three railway tunnels planned by Botniabanan AB.

Train travel has increased in Sweden, and future increase of train transports putdemands on the already vastly exploited railroad net. The increased need of capacitycan be seen in the ongoing and planned expansions of the railway track. One part ofthe railroad infrastructure which is affected by an increase of travellers is the design ofthe station platform. Since the platform is the place where the traveller meets thetrain, dangerous situations can occur in this environment. A number of studies focuson single safety risks, albeit there is no research to show the full picture of safety inthe platform environment.This study aims to treat and put together a compilation of risks for the traveller in theplatform environment in the form of a checklist, which can be used as support inplanning and design of a safer platform environment for existing or planned platforms.The thesis has, through case studies of five ongoing projects within the NationalRailroad Administration (Banverket), interviews with train company personnel andinternational railroad administrators, identified and treated safety (and security) risksin the platform environment.The conclusion of the study is that the relations between the traveller, the physicalplatform environment and the project organisation are important to explore andexploit when designing effective safety measures.

The aim of this essay was to describe the power elite of the Swedish town Karlshamn, and its influences on the local political process before the realization of the narrow-gauge railway Karlshamn-Wislanda-Jernväg. During the mid 19th century, a revolutionary period began in the Swedish pre-industrial epoch. The political and institutional regulatory frameworks were disassembled and restructured, away from protectionism and centrally controlled administration, for the benefit of free trade, local self-government and liberalism. The changes were carried through during times marked by a drastic increasing native population and upcoming demands for adjustments to meet the growth of the industrial-, trade- and labour markets. An essential industrial development factor was the building of the national railway network, which started after some important decisions in the Swedish Riksdag during the 1850´s.

This final project discusses renewal and upgrading of the area of Prim. It is discussed how this industrial area can be an attractive neighborhood with a varied range of services and commercial trade. Prim is located 2km north-east of the center of Barcelona. The area boarders to a deep railway valley that historically has separated Prim from its neighboring districts. At present there is almost no housing, services or commercial trade within the area and the industry is discontinued or the existing industrial buildings are derelict. There is also a lack of green recreational areas.

To achieve a working collaboration in a big, complex organization where there are vast requirements on both quality and profitability is not always an easy task. An example of this is the organization that was created in the Swedish railway industry following a series of deregulations during the past 25 years. A partial market in this organization is the railway maintenance. In order to achieve a working collaboration between actors in this organization the so-called Purchaser-provider model (PPM) is presently used for the procurement of rail maintenance projects. Previous research has shown that this market-based instrument has clear positive effects regarding the cost-efficiency but hinders the collaboration.

Green public procurement (GPP) can be used as an instrument to reduce carbon dioxide emissions, and consideration of environmental aspects within public procurement is becoming more common in Sweden and internationally. Two product groups that have been pointed out as especially important are transports and electricity, where the opportunities for public purchasers to reduce emissions are relatively large. This paper studies GPP which aims at reducing emissions, primarily of carbon dioxide, through environmental requirements within these two product groups. A theoretical analysis of cost-effectiveness, transaction costs and effects on technological development is performed, followed by a closer study of how these aspects appear in practice within GPP. The results indicate that a cost-effective allocation of reductions between the two product groups is most likely to be attained if the main part of emission reduction is achieved through environmental requirements on electricity. The cost for emission reduction within transports is relatively high, especially for heavy transports. For transportation services, more generally focused requirements on emission reductions could probably give greater environmental gains, but the existence of transaction costs steer the environmental requirements towards more technology specific types.

Detta examensarbete genomfördes våren 2013 på Karlstads universitet där TD Rail & Industry i Västerås stod som uppdragsgivare. Projektet innefattade att kartlägga nuvarande omlastningslösningar av enhetslaster mellan järnvägstransporter och vägtransporter, och utarbeta en konceptuell omlastningslösning med fokus på att öka järnvägstransporternas flexibilitet gentemot vägtransporterna. Där vikten lades på att utarbeta ett välarbetat helhetskoncept.Projektet genomfördes med designprocessen som grund och innehöll bland annat momenten; förstudie, kravspecificering, idégenerering, konceptval m.m.Resultatet blev en vidareutveckling av det redan befintliga systemet CCT som bygger på horisontell överföringsteknik och möjliggör därför omlastning av enhetslaster direkt under kontaktledning. Skillnaden mellan RES och CCT är att man tagit bort ombyggnationen av tågvagn och lastbilschassi, som var en av CCTs stora svagheter, genom två hydrauliska ?teknikplattor?.

This master thesis investigates the possibilities of using GPS-information from trains to create a model of a railway system, register the routes of the the trains and predict how the trains will travel in the railway system.The thesis work was done at Icomera AB which is a company that specializes in internet connected vehicle solutions.We describe how the GPS-information is sent from the trains in the form of samples and investigate limitations and possibilities with the available information. About three million samples from 83 SJ-trains were analysed and the samples were filtered with the intent of removing erroneous information. We here found that about 30 % of the samples from the trains were unreliable.A solution for how the samples from the trains can be used to create a model of the railway system traveled by the trains is presented. We use a large set of historical samples and use cluster nodes and Hermite curves to generate a graph that represent the railway system with stations, nodes and the railway itself. A fully automatic solution is not presented since it did not fit into the time frame of the thesis; instead we created a simple tool which can be used to manually finish the model of the railway system.Furthermore, we describe how the railway system and the samples from the train can be used to register the routes the trains travel.

Global warming is going to affect our society in many ways. One can say that the problem we face has two different sides. One of those sides has received a lot of attention, namely how we can reduce our emissions of greenhouse gases. However, because of the climate system's inertia the climate will continue to evolve over a period, no matter how much we will cut back on emissions. Because of this, we have to start adapting our society to the climate changes that we cannot influence.

This master thesis investigates the possibilities of using GPS-information from trains to create a model of a railway system, register the routes of the the trains and predict how the trains will travel in the railway system.The thesis work was done at Icomera AB which is a company that specializes in internet connected vehicle solutions.We describe how the GPS-information is sent from the trains in the form of samples and investigate limitations and possibilities with the available information. About three million samples from 83 SJ-trains were analysed and the samples were filtered with the intent of removing erroneous information. We here found that about 30 % of the samples from the trains were unreliable.A solution for how the samples from the trains can be used to create a model of the railway system traveled by the trains is presented. We use a large set of historical samples and use cluster nodes and Hermite curves to generate a graph that represent the railway system with stations, nodes and the railway itself. A fully automatic solution is not presented since it did not fit into the time frame of the thesis; instead we created a simple tool which can be used to manually finish the model of the railway system.Furthermore, we describe how the railway system and the samples from the train can be used to register the routes the trains travel.

This master thesis investigates the possibilities of using GPS-information from trains to create a model of a railway system, register the routes of the the trains and predict how the trains will travel in the railway system.The thesis work was done at Icomera AB which is a company that specializes in internet connected vehicle solutions.We describe how the GPS-information is sent from the trains in the form of samples and investigate limitations and possibilities with the available information. About three million samples from 83 SJ-trains were analysed and the samples were filtered with the intent of removing erroneous information. We here found that about 30 % of the samples from the trains were unreliable.A solution for how the samples from the trains can be used to create a model of the railway system traveled by the trains is presented. We use a large set of historical samples and use cluster nodes and Hermite curves to generate a graph that represent the railway system with stations, nodes and the railway itself. A fully automatic solution is not presented since it did not fit into the time frame of the thesis; instead we created a simple tool which can be used to manually finish the model of the railway system.Furthermore, we describe how the railway system and the samples from the train can be used to register the routes the trains travel.

Title: Process description of round timber transports ? a case study at Tra?frakt Go?taland ABAuthors: Karl ? Johan Tern, Christian Johansson and Andreas IvarssonTutor: Anders JerrelingExaminer: Fredrik KarlssonBackground: Today the profitability of forest haulers is unsatisfactory. Negotiations on prices are more about the relative strength of the negotiation parties rather than a discussion about actual costs. Adding extensive changes in the forest haulers cost structure has led to insufficient knowledge of whether the negotiated prices really correspond to their costs.Methodology: We decided to carry out a case study at Tra?frakt Go?taland AB, a special interest organisation whose members represent the majority of forest haulers in Go?taland.Purpose: To describe the processes and underlying activities of round timber transports.

This master thesis investigates the possibilities of using GPS-information from trains to create a model of a railway system, register the routes of the the trains and predict how the trains will travel in the railway system.The thesis work was done at Icomera AB which is a company that specializes in internet connected vehicle solutions.We describe how the GPS-information is sent from the trains in the form of samples and investigate limitations and possibilities with the available information. About three million samples from 83 SJ-trains were analysed and the samples were filtered with the intent of removing erroneous information. We here found that about 30 % of the samples from the trains were unreliable.A solution for how the samples from the trains can be used to create a model of the railway system traveled by the trains is presented. We use a large set of historical samples and use cluster nodes and Hermite curves to generate a graph that represent the railway system with stations, nodes and the railway itself. A fully automatic solution is not presented since it did not fit into the time frame of the thesis; instead we created a simple tool which can be used to manually finish the model of the railway system.Furthermore, we describe how the railway system and the samples from the train can be used to register the routes the trains travel.

Title: Process description of round timber transports ? a case study at Tra?frakt Go?taland ABAuthors: Karl ? Johan Tern, Christian Johansson and Andreas IvarssonTutor: Anders JerrelingExaminer: Fredrik KarlssonBackground: Today the profitability of forest haulers is unsatisfactory. Negotiations on prices are more about the relative strength of the negotiation parties rather than a discussion about actual costs. Adding extensive changes in the forest haulers cost structure has led to insufficient knowledge of whether the negotiated prices really correspond to their costs.Methodology: We decided to carry out a case study at Tra?frakt Go?taland AB, a special interest organisation whose members represent the majority of forest haulers in Go?taland.Purpose: To describe the processes and underlying activities of round timber transports.