The main project Dry preservation of source-separated organic household wastes involves a new technique for treatment of biowaste through drying. Investigations are going on to determine how the dried biowaste best can be used to close the natural circular flow of nutrients. The objective of this degree project is to determine if the dried biowaste can be used as a soil conditioner. By restoring the nutrients in the material to the ground, the natural circular flow is closed. A declaration of contents, including the nutrient levels, C/N ratio, pH and the electrical conductivity of the dried biowaste, was constructed and a germination test was done to make sure that the material did not inhibit sprouting.

The purpose of this study is to increase the understanding of activities, flows and waste in a company's production process. By performing a value stream analysis, non-value adding activities are identified in a production process and then the suggested improvements that can reduce lead times will be stated. The value-stream mapping identifies the flow of information and the flow of material in a production process and this provides the basis for the identification of non-value adding activities.We conducted the study at Lammhults Möbel AB in Lammhult Sweden, where the production flow of Spira-21 has been investigated. This to identify any non-value adding activities that affect the flow negative and consumes time and money in a non-value adding way.A reasonable approach for the project was taken by studying the methodologies and theories. We conducted interviews and site surveys at Lammhults Möbel AB where the flow of information and material in the production process were investigated.

My bachelor?s dissertation concerns the creation of a proposal for interior decoration of the Boland High School?s canteen. I have been in contact with personnel, students and the school principal through the duration of the project. In the end, substantive changes of lighting, interior decoration and movement were proposed for the canteen. In the proposal I have focused on accentuating the school?s profile, on creating smaller spatial configurations within the larger configuration of the room, lowering the noise level, creating a good movement flow, increase the number of seats and creating a pleasant environment in which to eat..

The Transport division is responsible for the internal transports on Sandvik MaterialTechnology AB. At the moment there is no clear picture of how the straddle carriers aremoving at the division Primary Products and if it is working in a satisfying way. It isimportant to see the whole picture of the transportation flow so improvements can be made.The purpose of this essay is to survey and analyse the truck flow in a Lean Productionperspective. The essay is delimited to only include straddle carriers transportation ways in thePrimary Products division. To survey the truck flow we have used a method called Walkthrough.This means that we have walked thorough the whole production flow andinterviewed some of the employed on the way to get the necessary information.

Detta  examensarbete  undersöker  skillnaden  i  tre  olika  nybörjargruppers  upplevda flow  då  de  spelat  Magicka  (2011)  med  motståndarantal  som  den  enda  skiljande variabeln.   Undersökningen   baseras   bland   annat   på   Csikszentmihalyis   (1990) flowteori och Caillois (2001) teori om att tävlande slutar vara roligt då det  urartar i kaos.  Syftet  med  examensarbetet  har  varit  att  hitta  när  mest  flow  uppstår  då nybörjare på Magicka (2011) spelar mot  en viss motståndartyp, samt om  detta flow bryts  när  för  många  motståndare  introduceras.  Undersökningen  har  visat  att  nio motståndare har resulterat i betydligt mer flow än tre, medan skillnaden mellan nio motståndare  och  18  har  varit  obetydlig.  Examensarbetet  har  dock  inte  lyckats kvantifiera  var  flow  övergår  till  kaos  med  den  testgrupp  och  motståndartyp  som använts.  Framtida  forskning  skulle  exempelvis  kunna  undersöka  på  vilket  sätt  ett varierande  motståndarantal  skulle  påverka  flow  för  en  mer  erfaren  testgrupp  som spelar mot andra motståndartyper..

This project started when LIC Audio AB wanted help with development of a hearing aid for public rooms. The problem is that a lot of people suffer from some sort of hearing impairment. In places with a lot of people and background noise the problem becomes bigger and the sound seems to flow together. During the project we found the solution for the problem in the shape of a headphone. The headphone receives a signal from a preinstalled hearing loop.

Starting out as a minor form of amusement, the game industry has become one of the most lucrative andsuccessful in the entertainment business competing against giants such as television, movies and music.As the internal competition within the developer community grows companies work hard at discoveringnew ways to attract and keep customers. By having a playcentric approach focusing on user experiencethey hope to achieve that goal. This thesis describes the process of designing a game with focus on theplayer. We apply the concept of flow on game development and investigate through research throughdesign if we are able to create a game that keeps the player in flow.Play tests showed several elements such as control issues and too difficult challenges early in the game,affecting the possibility for players to experience flow while playing. These negative factors came to becalled flowleakers.

This report deals with the performance of a batch flow treatment of landfillleachate compared with a continuous flow system. The parameters in focus were total Kjeldahl nitrogen (TKN), BOD5 and COD. The pilot-scale experiment used eight barrels with a volume of 150 liters. Each barrel was constructed differently concerning its flow, its bed material grain size and its presence of plants or not. Four of the barrels worked in batch mode, thus four in continuous flow mode.

Producing a building is a long and complex process. It consists of several parts, from the feasibility study and design stage onto the construction and finally the management of the building. The design process is a critical part of the process where construction plans are made. The quality of the plans affect the production phase in great extent and faulty plans can pose a risk for extra costs for all parts in the process. The cost of producing dwellings has increased the last years and the detail design process is one of many phases where improvements can mean cost savings within the whole building process.This report aims to point at parts within the detail design process which could be more efficient, regarding communication, follow-up and time planning, and to give suggestions for improvements.

The content of the following report is the summarized result of three students thesis at Blekinge Institute of Technology in co-operation with Water Jet Sweden AB. This report will give the reader a description of principles how to measure the abrasive mass flow in a waterjet cutting system. The work began with a visit to Water Jet Sweden AB to get a closer look at the problem. When the analysis of the problem was done the criteria were defined in the form of demands and desires. The main task of the criteria was to guide the search for the solution.

Syftet med föreliggande studie var att undersöka hur ryttare upplever Flow, och vidare även hur ryttare upplever samspelet inom ekipaget vid Flow. Studien inkluderade 10 kvinnliga informanter (M = 18.7, SD = 1.48) med tävlingserfarenhet som sträcker sig från ingen alls till internationell nivå (Hoppning= 4, Dressyr = 3, Fälttävlan = 2, Ingen tävling = 1). En semi-strukturerad intervjuguide utvecklades utifrån Csikszentmihalyi's holistiska perspektiv på de nio dimensionerna av Flow (Jackson & Csikszentmihalyi, 1999), och data analyserades kvalitativt genom en innehållsanalys. Resultatet visade både att ryttares upplevelse av Flow stämmer väl överens med andra idrottsutövares upplevelse (Swann, Keegan, Piggott och Crust, 2012), och bekräftar tidigare tolkningar av att ridsporten skiljer sig från de flesta andra idrotter genom att utfallet till stor del är beroende av interaktionen och samarbetet mellan häst och ryttare (Beauchamp & Whinton, 2005). Vidare visar resultatet även att samspelet mellan häst och ryttare är en viktig och oersättlig del i upplevelsen av Flow..

The smelting process at Sapa Profiler AB in Sjunnen generates large quantities of waste heat which is absorbed by the cooling water when the aluminum is cooled down. This paper is the result of a Master?s Degree Project aiming to present the conditions for recycling the waste heat. The cooling water absorbs the heat from the aluminum at an average rate of 600 kW and the paper shows that it can be used to replace electrical power consumption for heating the production plant?s facilities.

AbstractEmbla 5 is an office building which has done a large improvement. The clients of this building has made an order of WSP and the student Anders Kempe to calculate the use of energy for the building, and after that result proposing further measures which can decrease the energy use of Embla 5.The ground for this report is when calculation of the present energy use of the building is stated. To make that information of a number of parameters such as envelope, the heating system and ventilation has been located and set in to the simulation program IDA ICE which calculate the energy use.To improve the energy use further this project has been concentrated to change the system of ventilation. Today the ventilation system is of the kind CAV (constant air volume) and the air flow is dimensioned for after recommendations from BBR and Arbetsmiljöverket in the office spaces. Consider that Embla 5  is an office building where the people only staying for 8-10 hours/day so was the ide to see how much energy saving if the air flow is reduced the time people not being in the building.

The content of the following report is the summarized result of three students thesis at Blekinge Institute of Technology in co-operation with Water Jet Sweden AB. This report will give the reader a description of principles how to measure the abrasive mass flow in a waterjet cutting system. The work began with a visit to Water Jet Sweden AB to get a closer look at the problem. When the analysis of the problem was done the criteria were defined in the form of demands and desires. The main task of the criteria was to guide the search for the solution. The work proceeded with an extensive search for abrasive flow meters along with obtaining information about flow measurement in general. When the search for abrasive flow meters resulted in nothing all the efforts were concentrated on finding a principle of measurement that could cope with the criteria.

Syftet med denna studie är att undersöka hur elever i en vanlig svensk mellanstadieklassupplever flow i sitt lärande och vilka faktorer som påverkar upplevelsen av flow.För studien valdes en kvalitativ metod i form av enskilda intervjuer. Tre pojkar och treflickor i en klass 4 på mellanstadiet fick berätta vilket deras favoritämne var, och sedanbesvara frågor om hur de upplevde sitt favoritämne och hur de upplevde de övrigaämnena. Frågorna var skapade utifrån de olika faktorerna som påverkar flow enligtMihaly Csíkszentmihályis flowteori (Csíkszentmihályi, 1993).Resultatet av min undersökning visar att eleverna som intervjuades upplever flow iskolan, och då mest i favoritämnet. Det finns även exempel på motsatsen där entusiasmoch flow saknats i skolarbetet. Faktorer som har betydelse för att flow ska uppkomma ärbland annat rätt svårighetsgrad på uppgiften så att utmaningen anpassas efter individen,rätt tid och arbetstakt för genomförandet av uppgiften, möjlighet till medbestämmandeoch inflytande för den som utför uppgiften samt eliminerandet av störmoment underarbetet med uppgiften.Undersökningens resultat visar att flow har betydelse för elevens motivation och iförlängningen sannolikt också för elevens lärande.