The estate of Rämningstorp in the region of Västergötland in southern Sweden is administered by the holding trust company Skogssällskapet i Skövde. In 1999 measures were taken by Skogssällskapet to drain the stream Fredstorpsbäcken as a means to increase the forest Productivity of the surrounding lands, which are situated on the estate of Rämningstorp. Almost immediately after the drainage, the streamwater turned turbid and a landowner downstream reported the issue to the county administrative board of the region. The aim of this thesis was firstly to analyse the suspended matter that appeared during summer/autumn and secondly to explain why it came to be. Initial hypotheses for the explanation to the greyish turbid water were that it was either 1) a chemical/biochemical precipitate, or 2) an bacterial/algal blooming.

Sedan marknaden för lantbruksfastigheter avreglerades i början av 1990-talet så har priserna på skogsmark ökat kraftigt. Då priset på timmer och massaved inte ökat i samma takt råder år 2014 en situation där priset på en skogsfastighet är högre än dess avkastningsvärde. Detta gör frågor som rör skogsägarnas värdering inför köp av skogsmark högintressant. Tidigare studier inom samma område har haft som mål att fastställa vilka faktorer som har en inverkan på fastighetspriset. Bonitet och produktiv skogsareal är två grundläggande faktorer som beskriver fastighetens karaktär. Ändå har det ibland visat sig svårt att hitta ett statistiskt samband mellan dem och fastighetspriset.

Blast furnace is the heart of every steel plant. Steel production is based on the blast furnace process, as it is where the iron is extracted from the iron ore and turned into liquid iron, which will subsequently be used to make liquid steel. Therefore, without hot iron, steel can not be produced. Blast furnaces in this process are supplied among others with pulverized coal. Raw coal should be prepared for the blast furnaces in the form of fine coal powder.

Uganda is one country with fastest growing populations in the world and with more than 25% of the population living in poverty. There is a rapid rural urban migration with increasing demands for food for low income earners especially in these areas. One way to mitigate food insecurity is to increase milk and meat production efficiency, and thus reproductive performance of cows is crucial for good production. A well-documented strategy for improving dairy cow Productivity through faster genetic improvement is to breed dairy cows using proven semen via artificial insemination (AI). AI has been used in Uganda for over 60 years but only less than 10 %, a small population of the country?s herd has been bred that way. The aims were to study knowledge, attitude and practices factors influencing cow fertility results on dairy farms around Kampala using AI and to propose ways of promoting increased use of AI in Uganda.

The limit for mercury in fish, set by health authorities, is exceeded in about half of the lakes in Sweden. Methyl mercury (MeHg) is the most toxic form of mercury and accumulates in fish. Therefore transformation of inorganic mercury (Hg) to methylmercury (MeHg) is an important process that we need to understand in order to possibly counteract the negative effects of mercury in the environment. The seasonal dynamics of mercury biogeochemistry is likely of great importance for the accumulation of MeHg in the aquatic food web. In thesis the chemical speciation and transformations of Hg and MeHg in bottom waters and sediments is followed in Ängessjön, a small lake located on the east coast in the middle of Sweden. The lake is not directly affected by any industrial pollution and concentrations of Hg in the sediment reflect the atmospheric deposition in this area, as well as processes taking place along the hydrological pathways from soil to lake. Samples from sediment, bottom- and streamwater were collected in average every second month during the period Feb.

I uppsatsen undersöks den period då den svenska ekonomin uppnår den fulla sysselsättning som sedan blev normen för hela efterkrigstiden. I arbetet genomförs en sammanställning av fackföreningarnas arbetslöshetsstatistik som publicerats i Sociala meddelanden varje månad under perioden 1935-1948. Materialet har därefter bearbetats och utifrån förbundsredovisningen har arbetslöshetsserier skapats för sju av industrins delbranscher. Utifrån bearbetningen sammankopplas arbetslöshetsstatistiken för respektive sektor med de uppgifter om förädlingsvärden, sysselsättning och löner som publicerats i den officiella industristatistiken och som ett resultat av arbetet med svenska historiska nationalräkenskaper.Med hjälp av materialet prövas två hypoteser som kan härledas från den  Nykeynesianska teorin för arbetsmarknaden. Den första hypotesen berör sambandet mellan löneutrymme, löner och arbetslöshet.

This investigation?s task was to map manufacturing of special qualities at Stora Enso Packaging under a certain period, analyze if rules concerning special qualities is followed, which consequences this results in concerning use of paper, waste and costs and to give suggestions on alternative solutions. The goal was to give sugges-tions that help the company to reach its business ratio that the production de-partment uses within use of paper and Productivity in the corrugated cardboard machine.Stora Enso Packaging is a part of the forest group Stora Enso and is one of Swe-den?s leading producers of corrugated cardboard. Stora Enso Packaging acts pri-mary on the Swedish market, where they have a market share of 25 %.To be able to analyze orders with special qualities we did a data collection during two months, where we mapped incoming orders.

The purpose of this study is to incrementally, through a combination of various methods, examine the assumptions about the working economic outcomes that can be made based on planned ergonomic intervention in a department at Pfizer Health AB in Strängnäs. The study contributes to knowledge about how assumptions on OSH financial results can be made, based on planned ergonomic interventions. These assumptions were based on biomechanical calculations made on the basis of ergonomics measurements with inclinometer. The study is important because previous research has shown that poor work environment have a bad impact on the economy of a company in different ways. It can for example be negative impact on the company's Productivity and quality of the units produced or the services provided.

In the last decades, high speed cutting has become an attractive technology in the wood industry. The possibility of reducing global costs in addiction with an increase in Productivity, were the main reasons for the enlargement of the use of this technology. As usual, these advantages are accompanied by disadvantages that should be carefully analyzed. If on the one hand cutting forces are reduced with increasing cutting speeds, on the other hand, the centrifugal forces affecting the tool are higher. Exposed to such high loads, there is a considerable risk of tool failure that embeds hazards for both machine and workers.

Unemployment amongst Swedish citizens is higher within the group which falls under the designation foreign-born. The aim of this thesis is to examine which municipal factors that can explain the differences in unemployment amongst foreign-born relative to native born.The empirical models are examined with both cross-sectional data for the year of 2010 and panel data for the years of 2002-2012. The examination is implemented through a linear regression analysis of the type Ordinary Least Squares (OLS) and Fixed Effect regressions. A theory section will be presented where the theory on Non-Accelerating Inflation Rate (NAIRU), theories on discrimination and country-specific human capital are illustrated.The result from the cross-sectional data shows that the amount of foreign-born, the level of foreign-born immigrated from Nordic countries have a significant negative effect on unemployment amongst foreign-born. The general unemployment shows a significant positive effect on the unemployment amongst foreign-born.

In the Kolmården area, northeast of Norrköping in south-central Sweden, it was discovered that shoots of spruce Picea abies, plants to a seemingly large extent had been browsed by deer. The area inhabits a dense red deer population, alongside with moose and roe deer, and red deer is thus suspected to cause the damage. The main purposes of this study are, however, to estimate the extent of the shoot-damage and to investigate what factors that may affect the browsing of shoots. For each stand information was recorded about the age of the plants, area for the stand, height over the sea for the stand, site Productivity, type of plants and stand-history. The study was done in three areas: Simonstorp, Stavsjö and Valinge. At Simonstorp and Stavsjö, respectively, 10 stands were chosen for study and on Valinge six stands. In each stand, 10 plots were sampled.

Given that the end-customer has become more demanding, the retailer has to deliver products according to the market demands, which have forced manufacturing companies to constantly search for new opportunities to reduce costs and improve efficiency. It is, therefore important to choose suppliers that are able to compete with the market demands.The market demands in the textile industry have lead to shorter product life cycles, which have caused manufacturers to deliver flexibility with high technology to compete successfully on the global market. To achieve the market requirements the underlying factor is to be aware and optimally use and control time. New technology can have a major influence in the production development, if the company choose to take benefit of the advantages, by optimal allocation of the internal resources the Productivity and efficiency will increase, to accomplish a competitive advantage. One way to achieve this is by investing in a Unit Production System.In our thesis we have questioned what the main driving forces for an apparel manufacturing company is when it chooses to invest in new technology.

Employee turnover can cost an organization a significant amount of money. In addition, retention of employees can beneficial towards to an organization as it e.g. allows to save costs related torecruitment and training of new employees. The fast food industry is recognized as an industry which employs low-skilled employees and is especially in the United States known to be prone to high employee turnover. With regards to Europe, only little information is available in the field of low-skilled employee retention in the fast food industry.

Purpose: The purpose of this thesis is to study the adaptation of recently recruited young professionals to a top consulting firm through their identity construction efforts. We analyze the influence of a major organization-related discourse on young professionals in order to account for the effects of emotional labor on their adaptation to work. Methodology: We have studied our empirical material in the light of a reflexive pragmatic approach. Thus throughout the analysis of interview material, we try to interpret carefully the material from various perspectives. As authors, we also reflect critically upon our own interpretations.

The costs of logging and of transportation with truck are dominating the total cost of wood delivered at industry. To support the profitability for the members' forestry the processing and handling with the timber has to be as efficient as possible. Increased length of pulpwood in thinning is one conduct that can result in higher Productivity and/or lower costs. The study is scaled as a system analysis with the aim to exemplify the differences between working with 3- and 4-meter as standard length of pulpwood, related to biological aspects, timber receipts, cost of logging and cost of transportation with truck. Important aspects are if the change is technically and biologically feasible and economically profitable.