In this study it was investigated if the adoption of a new routine for quality control could improve the precision of the dimension measurement obtained by harvesters. Data was collected from three different harvesters. First, a reference data set was collected before the new procedures had been incorporated, and then when the new methodology was implemented another data set was collected by the harvester operators, allowing the two data set to be compered. The results indicated that following the implementation of the new procedures, the reliability and the precision of the measurements has increased. All harvesters included in the study had improved regarding most of the controlled factors such as standard deviation, systematic difference and hit rate within ± 2 cm for length and ± 4 mm for diameter..

I detta arbete studeras hur vinterklimatet i Sverige kommer att skilja sig åt mellan perioderna 2071-2100 och 1971-2000, med avseende på parametrarna temperatur, nederbörd, vind, snödjup och snöutbredning. Klimatmodelldata (CORDEX) i upplösningen 12.5 km baserade på tre olika strålningsdrivningsscenarier (RCP-scenarier) behandlades i Matlab och modellerades över Sverige. För att analysera upplösningens betydelse tillhandahölls även data i upplösningen 50 km för en tioårsperiod. Scenariot RCP 8.5 kan ge så mycket som 10 grader varmare vintrar, med uppemot 50% mer nederbörd. För RCP 2.6 förändras nederbörden med -5 till 20%, och temperaturen ökar med 1-4 grader.

This report describes the construction work of a radar antenna for the radar systemCARABAS. CARABAS is a long wave airborne ground radar that has been developed bySAAB Microwave Systems and will now be mounted on a small helicopter, Schweizer 300.The antenna should be able to fold up and down. When the radar is in use the antenna islowered and under transport, start and landing the antenna is folded up. An emergency dropfunction should also be included in the design of CARABAS III.The extent of this report includes construction of the antenna, frame structure attached to thehelicopter, mechanism for folding the antenna up and down and mechanism for emergencydrop function. The mechanical design of the antenna and frame structure is based on modaland stress analysis, vibration measurement of Schweizer 300 and frequency analysis, andcalculations regarding aerodynamic drag and mechanics.The exciting frequencies of the helicopter and accelerations at those frequencies weredetermined by vibration measurement and frequency analysis.

This report is a thesis work for a B.Sc. in Forestry at the School for Forest Engineers, SLU. The aim of the work was to compare two different pricelists with the actual output from a harvester. The results have also been compared with a volume estimate of standing trees done by the Swedish Forest Agency and the ?true? value registered by the Wood Measurement Association. The study confirms that the output calculated by the computer on the harvester is more reliable than the volume of standing trees estimated by Swedish Forest Agency. .

This study is a part of a larger project where the aim has been to evaluate different methods to assure the quality in stallion semen, due to the fact that some stallions in horse breeding have poor semen quality. The increased use of transport semen requires new methods to ensure good semen quality. In this part of the project the viability and concentration in fresh and cooled semen was examined with NucleoCounter SP-100. A comparison between two different commercially available semen extenders, Kenney?s and INRA 96, was made.

Today?s electrical grid companies understand that better knowledge of and information about their grid can help realize a smart grid network. One way to gain better knowledge and information about the low voltage network is to install measuring equipment on the substation transformer´s secondary low voltage side that measures the low voltage network losses for that specific substation. By doing so, grid companies can, due to the calculation of the low voltage network losses, identify and address issues such as illegal power dissipation, unmeasured power outtakes, and unsatisfied technical documentation for the substations low voltage network.During 2012, Mälarenergi Elnät AB had a total electrical network loss (both medium and low voltage network losses included) of three to four percent of their total distributed electrical volume. Converting this energy volume into a monetary figure this accounts for a loss of around 30 million Swedish crowns.

The ability to detect protein-based biomarkers, which are linked to different diseases like colorectal cancer, is very important as a diagnostic tool. Usually complex biological samples like blood are studied which will contribute to different technical issues when performing an assay. The aim with the project is to optimize and develop the high throughput protein detection technique Proximity Extension Assay, PEA, into a 96-plex panel, in hopes of discovering an expression profile for colorectal cancer. PEA was developed by Olink Bioscience and allows specific proteins in a sample to be quantitatively transformed into nucleic acid sequences that are subsequently detected and quantified with real-time PCR. Two proximity probes containing oligonucleotide sequences bind pairwise to target protein and when brought in proximity, a DNA polymerase will extend a hybridization arm from one probe over to the second forming a double-stranded DNA sequence that can serve as a template in real-time PCR.

Bakgrund: Rottne industri a?r ett fo?retag som tillverkar skogsmaskiner, na?rmare besta?mt sko?rdare och skotare. En viktig del av fo?retagets strategi i dagsla?get grundar pa? att bedriva en genero?s reservdelsverksamhet ut mot kunder. Reservdelsverksamheten har vuxit och blivit en konkurrensfo?rdel fo?r Rottne industri.

Rhodesian ridgeback is a dog breed that originates from southern Africa. The characteristic ridge (a dorsal ridge where the hair grows in the opposite direction to the general coat) is shared with an Asian breed, Thai ridgeback. The origin and inheritance of the ridge has been examined and defined. The ridge-mutation is a duplication that contains four complete genes, FGF3, FGF4, FGF19 and ORAOV1 and the 3´-end of CCND1. The ridge is inherited as an autosomal, dominant trait and predisposes for Dermoid sinus (DS), a disease that develops during embryogenesis.

The dishwasher is a wide spread product that occurs in many households. It saves the user time,water and energy. When using a dishwasher instead of doing dishes by hand a lot of energy issaved.The importance of lowering the energy consumption does not only come from the consumerwinnings but also from an environmental point of view. Scientists are certain that the globalwarming comes from the emission of green house gasses that is created by human consumptionof oil, gas and coal.Dishwashers today are a lot more energy efficient than older dishwashers, but there are stillmargins to lower the energy consumption. The aim with this project is to investigate thedishwasher and it?s washing cycle, noting different phases and components that contribute towaste of energy.

The aim of this thesis is to improve the control of urea injection at the combined power and heating plant Framtidens Gärstad (FTG). Tekniska Verken i Linköping AB is the owner of the plant.The FTG plant consists of a boiler where garbage combustion is done. From the combustion nitrogen oxides are emitted. These nitrogen oxides are hazardous to the environment. To reduce the nitrogen oxides, injection of urea into the boiler is used.

Titel: Uppföljning och styrning av lagerproduktion ? Ramverk, mätsystem och individualiseringsmodell Författare: Peter Gunnarson och Daniel Hallbäck Handledare: Adj. prof. Stig-Arne Mattsson, Institutionen för teknisk ekonomi och logistik. Prof.

The purpose of this degree-project was to investigate the possibilities for primary air preheating into the two smallest waste incineration boilers of Halmstad Energy and Environment. The investigation is a pre-study which has the primary goal to evaluate technical and financial offers from companies that manufacture primary air preheater, and investigate if it is technically and financially profitable to do a purchase on primary air preheaters in the future.In the pre-study it is proposed that it is most efficient to have individual primary air preheater, one for each incineration boiler and the primary air are also proposed to be preheated by hot water in the pre-study. Further in the pre-study it is proposed that the heat-exchanger should have plain tubes instead of finned tubes, to avoid getting dirty fast. The space in the boiler-room is limited, and therefore the major problem was to fit in the primary air preheaters into the boiler-room. By comparing the different offers from the companies, the result in the pre-study shows that the offer from the company C.A.

The purpose of this degree-project was to investigate the possibilities for primary air preheating into the two smallest waste incineration boilers of Halmstad Energy and Environment. The investigation is a pre-study which has the primary goal to evaluate technical and financial offers from companies that manufacture primary air preheater, and investigate if it is technically and financially profitable to do a purchase on primary air preheaters in the future.In the pre-study it is proposed that it is most efficient to have individual primary air preheater, one for each incineration boiler and the primary air are also proposed to be preheated by hot water in the pre-study. Further in the pre-study it is proposed that the heat-exchanger should have plain tubes instead of finned tubes, to avoid getting dirty fast. The space in the boiler-room is limited, and therefore the major problem was to fit in the primary air preheaters into the boiler-room. By comparing the different offers from the companies, the result in the pre-study shows that the offer from the company C.A.

The purpose of this degree-project was to investigate the possibilities for primary air preheating into the two smallest waste incineration boilers of Halmstad Energy and Environment. The investigation is a pre-study which has the primary goal to evaluate technical and financial offers from companies that manufacture primary air preheater, and investigate if it is technically and financially profitable to do a purchase on primary air preheaters in the future.In the pre-study it is proposed that it is most efficient to have individual primary air preheater, one for each incineration boiler and the primary air are also proposed to be preheated by hot water in the pre-study. Further in the pre-study it is proposed that the heat-exchanger should have plain tubes instead of finned tubes, to avoid getting dirty fast. The space in the boiler-room is limited, and therefore the major problem was to fit in the primary air preheaters into the boiler-room. By comparing the different offers from the companies, the result in the pre-study shows that the offer from the company C.A.