The background of this study is the fact that it nowadays is more common to grow wheat after wheat. Usually we plow every autumn to remove the straw, and we wanted to study the effect of alternative methods to do it. We have done this experiment to answer the question if no tillage is better than conventional plowing. The results of the field experiment indicate that there is a link between plant establishment and the choice of equipment, but also a higher weed pressure in experimental plots with only ground tillage. The equipments which left much straw on the top of the ground the problems with fungi were more severe.

Atelektaser uppsta?r inom tio minuter hos 90 % av alla patienter som so?vs och leder till fo?rsa?mrad syresa?ttning men kan a?ven leda till postoperativa lungkomplikationer. Syftet med studien var att beskriva hur anestesisjuksko?terskan med olika ventilationsstrategier kan fo?rebygga atelektasbildning under generell anestesi. Studien genomfo?rdes som en litteraturstudie da?r 19 vetenskapliga artiklar granskades och analyserades.

This thesis describes possibilities for Metso Paper to lower their costs of spray pipes for their pulp wash press TRPE, with maintained good functionality and quality.Information that can be used by competitors has been censored in this version of the essay.To find solutions, alternative suppliers have been contacted and asked to quote. There has also been a new spray pipe designed. The manufacturing costs of the new design have been calculated.The thesis also contains a concept generation of an alternative product to the spray pipes in installations where a high pressure washer is used.To be able to ask other manufacturers of spray pipes to quote, a demand specification based on the currently used spray pipe was made. This was then sent to two alternative suppliers.An investigation of earlier used spray pipes, and the currently used, shows that the nozzles are a big part of the total costs of the spray pipes. To attempt to reduce the nozzles high cost an concept generation was made to find the best solution for a new design.There was a request that it should be possible to change the internal brushes in the spray pipe without cutting and welding.

This thesis describes possibilities for Metso Paper to lower their costs of spray pipes for their pulp wash press TRPE, with maintained good functionality and quality.Information that can be used by competitors has been censored in this version of the essay.To find solutions, alternative suppliers have been contacted and asked to quote. There has also been a new spray pipe designed. The manufacturing costs of the new design have been calculated.The thesis also contains a concept generation of an alternative product to the spray pipes in installations where a high pressure washer is used.To be able to ask other manufacturers of spray pipes to quote, a demand specification based on the currently used spray pipe was made. This was then sent to two alternative suppliers.An investigation of earlier used spray pipes, and the currently used, shows that the nozzles are a big part of the total costs of the spray pipes. To attempt to reduce the nozzles high cost an concept generation was made to find the best solution for a new design.There was a request that it should be possible to change the internal brushes in the spray pipe without cutting and welding.

This thesis describes possibilities for Metso Paper to lower their costs of spray pipes for their pulp wash press TRPE, with maintained good functionality and quality.Information that can be used by competitors has been censored in this version of the essay.To find solutions, alternative suppliers have been contacted and asked to quote. There has also been a new spray pipe designed. The manufacturing costs of the new design have been calculated.The thesis also contains a concept generation of an alternative product to the spray pipes in installations where a high pressure washer is used.To be able to ask other manufacturers of spray pipes to quote, a demand specification based on the currently used spray pipe was made. This was then sent to two alternative suppliers.An investigation of earlier used spray pipes, and the currently used, shows that the nozzles are a big part of the total costs of the spray pipes. To attempt to reduce the nozzles high cost an concept generation was made to find the best solution for a new design.There was a request that it should be possible to change the internal brushes in the spray pipe without cutting and welding.

This thesis describes possibilities for Metso Paper to lower their costs of spray pipes for their pulp wash press TRPE, with maintained good functionality and quality.Information that can be used by competitors has been censored in this version of the essay.To find solutions, alternative suppliers have been contacted and asked to quote. There has also been a new spray pipe designed. The manufacturing costs of the new design have been calculated.The thesis also contains a concept generation of an alternative product to the spray pipes in installations where a high pressure washer is used.To be able to ask other manufacturers of spray pipes to quote, a demand specification based on the currently used spray pipe was made. This was then sent to two alternative suppliers.An investigation of earlier used spray pipes, and the currently used, shows that the nozzles are a big part of the total costs of the spray pipes. To attempt to reduce the nozzles high cost an concept generation was made to find the best solution for a new design.There was a request that it should be possible to change the internal brushes in the spray pipe without cutting and welding.

ABB I-R Waterjet Systems combines the robotics and motion expertise of ABB Flexible Automation with high-pressure intensifier/pumping technology from Ingersoll-Rand to provide and continue to develop innovative waterjet cutting systems for global markets. The purpose of this assignment is to develop a process water purifier. The purifier should be applicable as an option to ABB I-R?s production cell Cutting-Box. At first hand the process water should be purified well enough to let out in the municipal sewage system, but the ultimate solution is purifying the process water to the range that recycling is possible. When investigating the different principle of purifying water, a research of different products and their manufactories was done. These different products were compared and the principle of filtration was the most applicable, as most of the products were designed for far larger applications. As the process water contains quite large amount of particles, it is necessary to perform the filtration in different steps. The process water purifier is therefore composed of a module of coarse filtration and one of micro filtration. In the module of coarse filtration the mainly amount of fibres and particles are eliminated. They are kept back in the container unit with the larger fragments and dumped with these when the container is emptied. In the module of micro filtration the filtration is performed in two steps. In the first step particles larger than 50?m are eliminated, in the second step the micro filter is setting the range of purifying, in this case 10?m.

Background: Osteoarthritis is understood to be a common cause of pain and dysfunction in cats; however there are few validated pain assessment methods for chronic pain in cats. In order to design a proper pain questionnaire, it usability need to be tested in both sound and sick cats. Aim: The aim was to investigate the usability of the pain questionnaire ?Lifestyle changes in cats? by compiling the results from the pain questionnaire reflecting the lifestyle in 30 healthy cats and compare it to the results from a clinical examination, as well as proposing improvements and additions to the questionnaire based on a literature review. Material and method: 30 healthy cats participated in the pilot study; the pet owner filled out a pain questionnaire with 16 questions regarding their cat´s behavioral and eventual changes in behavior and physical function. Thereafter the cat walked over a pressure measurement mat and finally underwent an orthopedic-directed clinical examination. The literature was found on Web of Knowledge, PubMed, Sciencedirect, and Google Scholar and also with the help of my supervisors.

The purpose of our study is to find out how teachers can help their students to learn how to managestage fright. By interviewing high school teachers and high school students and also observe one oftheir classes, we wanted to find out how they think about the causes of stage fright and what youcan do to relieve it. We also wanted to find out how teachers are working to teach students how todeal with stage fright, and how they think that you also could work. As a teacher of music, among other things, the task is to assess and rate the students performancesin music. Several components are based on the students' courage to play on his or her instrument infront of other people.

In 2014-2015 a large-scale Ebola epidemic occurred in West Africa. The Swedish Civil Contingencies Agency was given the order to conduct the Swedish response. The purpose of this case study was to investigate the impact on project planning of the three factors: the nature of the crisis, political initiative and developing countries. In this case study the crisis was an epidemic, and the project was initiated by the Swedish Government and conducted in two developing countries. The results were intended to contribute to developed understanding and recommendations for future project managers in similar projects.

Every year 67000 tons of food is wasted by Swedish retail stores. The waste implies financial losses for the retailer and it has a huge impact on the global environment. Reducing in-store food waste is thus a win-win situation for both retailers and society. The most effective way to reduce waste is primarily by optimizing the logistics of supply, but customers expect a store with a wide range of products and stuffed shelves. Thus there will always be products about to expire.

The behaviour of consumers has changed rapidly during the last decade, and a healthy lifestyle and an environmental mindset has become part of everyday life. This is also something that has become prominent in the supermarkets, where the organic products are increasingly winning shelf space. Several consumer behaviour studies have shown that the attitudes towards organic products and labels are predominantly positive. According to traditional marketing theory, these kind of attitudes should affect consumers? purchase intentions in a positive manner, as well as the actual purchase behavior.

According to Nosti (2012) banks target youths to find new customers by giving them special offers such as debit cards from a relatively early age. However, Moschis and Churchill (1979) point out that age can affect the level of knowledge in the consumer. Therefore, this essay focuses on youths as consumers. Specifically, youths? awareness of security risks in using bank tools such as debit cards or internet banks was studied.

The thesis presented in this report has been made on behalf of Scania and their basic frame design department with the subject to solve an implementation of a weight sensing system in the chassis. The system is supposed to be implemented in the seat springs, and the reason for this is that all the force will have to go through the weight sensing transducers. With all the force going through the transducers the weight sensing system will not be sensitive for the differences in tolerances from manufacturing. The transducers could be pre-calibrated to avoid a calibration of the whole vehicle after it?s completed from the manufacturing line.Weight sensing systems is today a reality in trucks with air springs.

This study investigated potato growing in beds as an alternative to conventional ridges.It was based on results from field trials on bed-grown potatoes carried out by Halland Rural Economy and Agricultural Society in 2007, studies of literature and interviews with farmers with experience of bed growing of potatoes. Due to their shallow root system, potatoes are one of the most drought-sensitive crops. Potatoes are often grown on sandy soils with poor water-holding capacity. Factors such as total yield, tuber size distribution and quality defects are negatively affected when water becomes insufficient. Wide beds have a more flat top which leads to more uniform water infiltration. Further on, beds have lower soil surface area due to its shape, and therefore, retain water more efficient. In the field trials, which were carried out at the Stjärnarp Estate near Halmstad, potatoes were grown in beds alongside a conventional ridge-grown crop.