In this project a simulator has been developed (in C++) with the purpose of illustrating how changes in environmental regulations, tax levels and other policy measures affect the composition of an energy system. The aim of the project was to investigate how energy companies? investment strategies are affected when changes in economic and environmental conditions occur. A standard scenario has been created based on current Swedish conditions, but the user can create new scenarios and set parameters freely. The user is tasked with building power plants to supply the city/region with district heating and electricity during a pre-set number of years. When the simulation is finished the result is graded in the following categories: economy, environment and quality. To evaluate the simulator three scenarios were created (?early 20th century?, ?reduced environmental control? and ?future?) in addition to the standard scenario and these were compared with each other by examining how a select group of power plants perform under the given conditions.

ABB Surge Arrestors in Ludvika have for a long time had a problem to keep the moisture at a steady state in the production of their ZnO-powder, that is used to produce varistors.Some black-box models of the spray drying process have been designed and evaluated to find a solution for the problem. After evaluating the collected data it has been found that variations in the supply voltage causes control difficulties for the operator. A cascade control system was designed, consisting of three PI control loops designed with lambda tuning. The disturbance in the supply voltagewas used as a feed forward in the control system.At the end of the project the control system was installed, and tests were made to verify the functionality of the regulator. It was shown that most of the variations in the moisture of the powder could be eliminated using small resources, through purchase of a process controller and four power meters.

This thesis work has been performed at the department of diagnosis and dependability at Volvo Car Company, Torslanda. The background of this project is based on interest in ascertaining how different factors possibly can affect a diagnosis method, which has been developed to find leaks in the fuel tank and evaporation system. According to the OBD II requirements leaks with an orifice diameter larger or equal to 0,5 mm, must be detected. The idea of the diagnosis method is to create an over pressure in the system with an air-pump. The current through the pump is measured and correlates to the power consumed by the pump.

Gtherm is an innovation company who has an unique air heat exchanger underdevelopment. The purpose of this thesis is to provide data of suitable motors for theheat exchanger and to find suitable motor suppliers.A motor specification was designed. It is an important basis for the search of suitablemotors. A compilation was made of nine motor suppliers and the suitable motorsfrom those. The compilation can be used by GTherm in their choice of suppliers andmotors.The compilation of the demands on the motor and analysis of suppliers indicated thatthere were no standard motors available to GTherms air heat exchanger.

Many traffic incidents are due to the driver?s lack of attention, resulting in dangerous lane departures, either sliding off theroad or into the oppose lane. These kinds of incidents often have serious outcomes, which has led to much effort being concentrated on preventing or lessening the damages when the incident is already a fact, for example by installing safety belts and air bags. These measures may be considered to be acts of so-called passive safety. Active safety on the other hand, means that the safety systems intervene before the incidents have occurred.

The aim of this study about wind power planning in forest was to examine the factors and restrictions, which represent technical limitations, biodiversity, tourism and amount of energy for wind farms in Kronoberg County. Suitable areas for wind power were identified from the collected information about planning principles and potential conflicts. From the suitable areas the potential energy gain is calculated. Methods used were mainly a literature review, interviews with experts and practitioners, GIS analysis and a rough calculation of the energy gain. The section of information and facts describes in general wind power planning and possible conflicts.

This study titled When the spaces dominate A study of the school as disciplinary rooms is a study where the emphasis is on quality and where the results are based on observations. The purpose of the research was to analyse rooms and other artefacts in the school as seen from Foucault?s analysis of power. He emphasised that power is expressed in human relationships. To understand how that power is used one can study the techniques adopted and resistance offered.

This master thesis was initiated with the aim to answer at what level of installed capacity of wind power in the northern parts of Sweden it would be beneficial to improve the transmission capacity from the northern Sweden. During the process of this work the aim has changed to try and create a model that can be used to analyze how well the hydro power installed in the northern Sweden can even out the quick changes in wind power production.To create a good model of all hydro power in northern Sweden is a very large job, unfortunately too large for a master thesis. This report therefore ends with an extensive analysis of the simplifications that have been made and their effects as well as a list of the future work that has to be done.The model that has been created have shown to be effective and produce good results. The conclusions that can be made is that the northern Swedish hydro power have very good possibilities to balance the wind power production. Only a few cases where water have been spilled even though there has been some free capacity has been discovered.

The Swedish energy companies have several different systems for data collection of the energy consumption of their clients. Often computerized remote meter readers are put in practice in order to register the energy consumption of large companies. The majority of household clients, however, are read off by the assistance of manual methods. Household power consumption is read off once a year. As a result, these clients are not debited for their actual consumption; their invoices during the year are the result of estimations. At times when the electricity supply system is highly loaded, electricity is more expensive.

This report is an outcome of a master degree project at Linköpings University in co-operation with Micronic Laser Systems AB. The purpose with this master degree project was to investigate how to implement a receiver in a data transfer system. The system consists of several data channels, where every channel consists of three parts: driver, transmission lines and receiver. The driver send low amplitude differential signals via the transmission lines to the receiver that amplifies and converts it to a single-ended signal. The receiver has to be fast and be able to feed an output signal with high voltage swing.

Power, Criminality and the gamble about bordering normality. From theperspective of Foucault. This study is about how criminality becomes a strategy of power used by the individual to overcome difficulties and gain advantages. This strategy of power sets loose a process of identity formation within the individual that gives shape to his own norms which are opposite to the one of the society. The individual norms and the normative society cooperate with one another in a cultural teamwork.

Aim: The nuclear accident in Fukushima, Japan, raised global criticism against nuclear power. In Sweden, the criticism has not been very visible and the government now allows a renewal of the nuclear power plants. The purpose with the study is to have a closer look on how Swedes in position of power motivate their positive attitude to nuclear power and how they conduct themselves to each other and to their opponents. The rhetorical perspective will be in focus for the analysing.Method: Four different artifacts represented by Swedes in position of power having a positiveattitude to nuclear power were chosen. Three rhetorical theories (the rhetorical arena, stasis andethos, pathos and logos) were used with the research question in focus.Result & Conclusions: The analyses resulted in conclusions about the strategies used by the participants such as: the importance of contexts, meaning for example that the greenhouse effect legitimizes nuclear power as a source of energy with important benefits.

The aim of this investigation work " What was it called...Equality...? is to study a clinics current gender equailty plan from a gender approach and by a field survey see if, and in that case, how it can be improved. A connection between existing gender norms and gender power strukctures is applied in the results of this survey in order to illustrate their significance from an individual as well as a structural perspektive.The survey has been carried through by a field survey as well as a discourse analysis as method. Yvonne Hirdmans gender power system is on of the main theoretical points of departure.The results that I have achieved in this essay is that gender can be looked at in different ways within the labour market where women have the main responsibility over the family and are considered more nursing then men. Men on the other hand are thinking of their carriers and have higher salary requirements.

The Airsoft Community always search for realism and optimal performance.When the performance and/or the realism in your AEG1 aren?t enough you turn to modifications toimprove the weapon. But to manufacture such modifications isn?t that easy, hence you turn tocompanies that are specialized in creating such devices.The goal with this project is to create a prototype of a modification called ?Programmable MOSFET?and targets optimization of the electrical components within the AEG. This means that you digitalizethe control of your AEG thus entails new functions and more stability to the system that isn?t possiblewith its mechanical predecessor.A prototype has been manufactured and programmed with functions according to requirementspecificationsthen it was tested on an airsoft-gearbox with rewarding results.

Aiming to contribute to the discourse on the sustainability of consociational democracy in plural societies, this case study provides an examination of Lebanon?s power sharing model. The study begins with an evaluation of the Taif Agreement. After acknowledging its effect on Lebanon?s consociational system the function and operation of Lijphart?s four consociational elements are analyzed.