This report describes the work of developing a specification of requirements for Waste Heat Recovery Units. The main part of the paper describes how the work with the specification of requirements has been performed. One specific question to be answered is:What are the customer?s demands in case of properties for the Waste Heat Recovery Units and how is that information collected as an order documentation to suit the business area Oil & Gas?The report begins with a description of the assignment and continues with the aim and background. A theoretical part describes the different areas and methods that have been important during the process.

The purpose of this study is to investigate the way George W. Bush used the language as a means to exercise power in an attempt to justify Operation Iraqi Freedom. The theories used to answer the purpose are discourse analysis and three different moral metaphors that are applied on the data.The collected material for the metaphors is constituted of cognitive linguistic books from prominent linguists, such as George Lakoff, Alan Cruse and William Croft, and the material for the discourse analysis is also collected from prominent discourse analysts such as Michél Foucault and Norman Fairclough. The official White House website provides the material for my data. The scientific method used in this study has been qualitative text analysis where the hermeneutic approach has been an essential part of it.The main question: In what way did George W.

In this thesis a number of energy saving methods for a multiplier on algorithmic level are investigated. For the investigation a multiplier is constructed in VHDL, after which the circuit's performance is investigated. A number of techniques for reduced power consumption are introduced in the circuit and are then evaluated. The conclusions are that all investigated methods, pipelining, interleaving and voltage scaling, should be maximally made use of in order to minimize the power consumption..

The purpose of this report is to investigate the possibilities with drain water heat recovery (DWHR) in residential buildings. Information and relevant theory has been collected and summarized in this report. Calculations have been done for given scenarios to evaluate profits. DWHR heat exchangers use simple technology and have long life-time. The heat exchanger is connected to outgoing drainage pipe and incoming cold-water supply so countercurrent flow is accomplished.

Voltage sag indices are a way of quantifying the performance of the power supply, as far as voltage sags are concerned. Indices can be defined for individual events, for individual sites, and for a whole system. A standard method for single-event methods is part of IEC standard 61000-4-30.This thesis emphasizes the importance of voltage sag indices and different methods for calculating three-phase voltage sag characteristics. Three-phase events measured in a medium network voltage over period of one month were analyzed, results examined and statistically evaluated. An algorithm for calculating voltage sag characteristics and indices was created in Matlab.

During the last decades the questions about environment and social ethics, so called Corporate Social Responsibility (CSR), have increased in importance. It is in the business world highly important for the corporations to show the public that the company care about these questions. A common approach nowadays is to outsource productions to other countries resulting in that suppliers have a great part of the work with CSR. CSR as a trend is a rather new phenomenon, and therefore interesting to see how the corporations handle these questions and how the approach looks like. The purpose with this study is to show how corporations which are recommended by CSR organizations for their handling regarding these questions approach CSR and how the work look like in the supply chain.

Previous studies have shown positive results on the use of music as postoperative pain relief. Quantitative studies have examined the effect of music on rated pain and otherparameters such as anxiety, relaxation and blood-pressure. The purpose of this study was to investigate the expectations and experiences of patients and nurses onimplementing music as postoperative pain relief in an orthopedic unitQualitative design and semi-structured interviews were used to examine expectations and experiences. Five patients and five nurses in the unit were interviewed.Four themes developed during the data-analysis. These themes were ?Expectations on music as postoperative pain relief?, ?Experiences of music as postoperative pain relief?,?Effects of music as postoperative pain relief? and ?Continued implementation of musicas postoperative pain relief?.

This bachelor thesis has the purpose to visualize and document the air movementsprovided by different ventilation principles in an operating theatre. The visualizationwill be made as simple as possible in a physical model. The model and thedocumentation should be able to use in educational purposes.The study is based on the two most common systems for airflow, currently used inoperating theatres. The first principle is displacement ventilation in which the air issupplied at low velocity along the floor. The second principle is vertical parallel laminarairflow in which the air is compressed like a piston from ceiling to the floor.A review of literature resulted in the choice of size, design, and scale factor for themodel, as well as choices of ventilation principles and airflows.

This bachelor thesis has the purpose to visualize and document the air movementsprovided by different ventilation principles in an operating theatre. The visualizationwill be made as simple as possible in a physical model. The model and thedocumentation should be able to use in educational purposes.The study is based on the two most common systems for airflow, currently used inoperating theatres. The first principle is displacement ventilation in which the air issupplied at low velocity along the floor. The second principle is vertical parallel laminarairflow in which the air is compressed like a piston from ceiling to the floor.A review of literature resulted in the choice of size, design, and scale factor for themodel, as well as choices of ventilation principles and airflows.

Voltage sag indices are a way of quantifying the performance of the power supply, as far as voltage sags are concerned. Indices can be defined for individual events, for individual sites, and for a whole system. A standard method for single-event methods is part of IEC standard 61000-4-30.This thesis emphasizes the importance of voltage sag indices and different methods for calculating three-phase voltage sag characteristics. Three-phase events measured in a medium network voltage over period of one month were analyzed, results examined and statistically evaluated. An algorithm for calculating voltage sag characteristics and indices was created in Matlab.

Voltage sag indices are a way of quantifying the performance of the power supply, as far as voltage sags are concerned. Indices can be defined for individual events, for individual sites, and for a whole system. A standard method for single-event methods is part of IEC standard 61000-4-30.This thesis emphasizes the importance of voltage sag indices and different methods for calculating three-phase voltage sag characteristics. Three-phase events measured in a medium network voltage over period of one month were analyzed, results examined and statistically evaluated. An algorithm for calculating voltage sag characteristics and indices was created in Matlab.

At the moment in central Täby there are small district heating network operated by Fortum Heat. The distribution network has an annual heat demand of about 70 GWh, which is supported by the network's two plants, Galten and Farmen. Täby as a region is rapidly growing and there are grand plans to develop the area. Estimated market potential for a future district heating expansion in Täby is very high and as early as in 2007 Täby decided to invest in a large-scale expansion. In autumn 2009 Täby did a procurement process, known as the ?Täby initiative?, to find a partner that could implement those expansion plans. To secure a cheap basic production the partner also need to build a power plant at Hagby recycling center. Despite high interest during initial state of the process, only one procurement offer were received and Täby suspended the contract in March the following year.

Uppsala County has ambitious environmental aims for the planned residential area inÖstra Sala backe. In this thesis different energy sources have been evaluated todetermine which system that would be most favorable given currently availableinformation about the project. Planned energy usage has been divided into tap waterheating, space heating and power. Three base case scenarios were made with districtheating, small scale bio fuel and heat pump. Solar power and solar heating were thensimulated and the production from the two could individually be deducted from theenergy need in the base cases, constituting 9 different scenarios.

Wind power in Sweden is expanding in response to the government's decision that 49% of Sweden's power should originate from renewable energy sources by the year 2020. Problems with noise and sound emissions related to wind turbines are a constant argument against the wind power expansion and this paper means to examine if vertical axis wind turbines might be a viable alternative to the conventional horizontal design for noise sensitive areas. In order to determine factors like difference in frequency, noise propagation and noise emission level, measurements of both horizontal and vertical axis wind turbines have been completed and the data analyzed with MATLAB. It is shown that there is a difference in how the noise from the two types of turbines propagates due to avariation in the frequency spectra of the emitted sound. It is also shown that vertical axis wind turbines generate a lower sound emission with less intensity inthe lower frequencies..

Demands on businesses are constantly increasing and the competition in the market-place is becoming ever tougher. To gain the long-term confidence of customers, not only the best businesses, but also the best supply chains are required.Volvo Cars is experiencing a changing competitive situation and their retailers are having trouble stocking the right spare parts. Shorter product life cycles and the growth of Volvo?s product program result in an increase in the number of spare parts to be stocked. In order to adapt to market trends and meet customer demands, Volvo has developed the LDC model, establishing a number of regional warehouses in strategic locations in Sweden, de-signed to supply spare parts to the regions? retailers through so-called Vendor-Managed In-ventory (VMI).The purpose of the study is to examine Volvo personbilar Sverige?s (VPS) motivation for a modified customer-service strategy through LDC.