Photodynamic therapy is a relatively new treatment for superficial squamous cell carcinoma in cats. There are no publications indicating that the method is being used in veterinary practice in Sweden at the present time. The method uses the interaction between a photosensitive agent which has been administered to the tumor area, light of a wavelength that can be absorbed by the photosensitiser and the presence of oxygen. In this study photodynamic treatments were performed at the Queen?s Veterinary School Hopital of Cambridge University between 1998 and 2002.

The Island of Öland has one of the best wind climates for land based wind power in Sweden. An objective for the Island is to become self sufficient using electricity from renewable source of energy such as wind. There is currently 55 MW capacity installed on the Island and it is estimated that grid congestion will occasionally occur if more than 135 MW was installed.The aim of this thesis is to investigate he possibilities for load management by smart charging of electric vehicles, EV. The definition of smart charging is that the charging is done to some extent with an ICT-system, (information and communication technology) that correlates wind electricity generation to the charging of electric vehicles. The purpose is to avoid grid congestions on the sub-sea cable that connects Öland to the mainland because that in turn would curtail wind energy production.

This paper examines the power producing dams along the Ume-river as an integral part of and a result from the urbanization process in Sweden during industrial capitalism. The aim of the paper is to contribute to the knowledge of the urbanization process in Sweden in general and of its traces along the Ume river in the county of Västerbotten in particular. The paper applies the theory of concentrated urbanization and extended urbanization put forward by Neil Brenner and Christian Schmid (2015) and argues that the building of power producing dams along the Ume-river is part of an extended urbanization process. This becomes particularly evident when examining the vast physical structures that is the dams, situated in an otherwise remote and sparsely populated area. These vast physical structures are also very well connected to a nation wide electric grid that has connections to bordering countries as well.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

This thesis is a qualitative study of a new law that was applied in December 2010. The law is called Lagen om etableringsinsatser fo?r vissa nyanla?nda invandrare, and is meant to help newly arrived immigrants that come to Sweden to establish themselves in the Swedish society. The aim of the study is to see what discourses the Swedish government produces as a result of this new law. Interesting for the study is to see what happens in the implementation stage at a local level, in this case in the municipality of O?rnsko?ldsvik.Theoretically and methodologically I emanate from critical discourse theory and institutional theory.

The actual project presents the development of a testing rig for a steam engine. A short overviewabout the development of steam engines is presented, until arriving to the development of thepresent engine, which will require to be tested in different ways.The testing rig studied on this project (based on a Lanchester engine) will be used to testdifferent materials and layouts for the group Piston-Cylinder.The engine is a high performance steam power engine, which is going to have a highpower/dimensions ratio, what will lead to require high performance components and materials.An introduction to the testing rig is presented, and the entire design project is done in order toreplace the disappeared documentation of the current testing rig, built on the 1970?s. Also somemodifications done in the original testing rig are presented, as well as some detected problemsand their possible solutions..

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

Wind power is an energy source that is becoming increasingly popular in Sweden and around the world. The establishment of large wind farms supply and contributes to energy production within grid in search of a more sustainable energy production. Wind power is becoming more popular and opens up new areas of implementation. More cities are starting to use small-scale urban wind power, everything from full-scale work for a little less work adapted to the villas. Sweden has high goals regarding the production of green electricity and the work which deals with the conditions Sweden plays in achieving those goals.

The purpose of this thesis is to investigate the possibilities for shore side electricity in the ports of Västerås and Köping. A technical solution to connect the vessels to the local grid is suggested and the investigation is also aiming at an understanding of how the environment is affected by the use of shore side electricity. Furthermore, the costs of shore side electricity are considered.The maximum power demand of a vessel visiting the ports today is relatively small, but the ships visiting the ports in the future might have a larger power demand. The suggested dimension for the system is 5 MW and the result shows that the shore side electricity requires the power distribution to the ports to be expanded. The most useful solution in the ports is to connect the ships with 12 kV from a connection box in a pit at the quay.The investigation of the costs shows that it is cheaper for the ships to use electricity compared to the marine fuel.

The purpose of this thesis has been to determine experimentally how good a peltierelement is to convert waste heat from wood burning. Three different peltier elementswere used in a comparison study. The comparison was mainly done to know howmuch power could be obtained from each element. Even, a circuit with a step-upfunction has been created to give a higher output voltage than the peltier elementitself. The result of the experiments was a low output power, the highest valuereached 2.18W.

AbstractThe future of ethanol is depending on good solutions for the production. ENA energy power plant produces electrical power and district heating by heating biofuel. By building an integrated bioenergy plant surplus steam could be used to produce ethanol as fuel to vehicle.This would mean that ethanol is produced renewable energy and the energy for the process derives from the surplus of power.  ENA energy, MDH (the University of Mälardalen) and the energy authority has initiated a research project were different bioenergy combinations integrate with existing power plant.  As a part of the project which size an integrated factory should be to gain the best efficiency for the plant was investigated. Consideration will be taken to the cost of the production in order to be competitive to the price of imported ethanol.  Etanolens framtid vilar på bra lösningar för framställning.  I ENA energi kraftverk i Enköping produceras el och fjärrvärme genom eldning av biobränsle.  Genom att bygga ett integrerat bioenergikraftverk där skulle man kunna använda överskottsånga till att framställa etanol som fordonsbränsle.

A B S T R A C TTitle: Democracy- Choice of the people or the voice of media? (Demokrati- Folkets styre eller Mediernas Makt?)Number of pages: 36Author: Carolina VallinTutor: Else NygrenCourse: Media and Communication Studies CPeriod: Autumn term 2006University: Division of Media and Communication, Department of Information Science, Uppsala UniversityPurpose/Aim: The purpose with this essay is to discuss which influence media has on the democracy.Material/Method: Qualitative explorative research method is used to see how much space the newspaper Dagens Nyheter gave to the parties represented in the parliament, and compare the results with the numbers the parties received in the general election 2006.Main results: This research showed similar results in the survey made of DN and the numbers the parties received in the general election 2006. Media can?t decide how people should vote in a election, but they can influence what citizens think and talk about by having the power to choose which information that shows on the agenda.Key Words: Dagens Nyheter, Agenda setting, Media, Power and Democracy..