In the Swedish author, poet and critic Hanna Nordenhöks (1977-) novels Promenaderna iDalbyhage (2011) and Det vita huset i Simpang (2013) the literary characters are often portrayed asdiffuse shapes with a subtile closeness to other organic bodies, places and times. While the novelsaddress themes such as colonialism and subjects becoming, they also explore the act of narratingthrough letters, journals, photographs and, in particular, fabrication. What emerge are two aesthetic,literary works that, on different levels, trouble our notion of borders between human and more-thanhumanbodies, an issue that?s essential for our understanding of human - environmentalrelationship.The purpose of this thesis is to show how the prose of Nordenhök can be read in the light of theterm Porosity, where matter is understood as elastic and open for both creating and de-creatinginteractions. I will argue that the novels contribute to a deepened understanding of the relationshipbetween human subjects and more-than-human matter as elastic, and that they incorporate thisdynamic Porosity within the narration itself.

Ever since ABB has begun diecasting their rotors instead of permanent mold casting it,variation in the quality of the cast has arisen. Diecasting is performed in three differentmachines, M1, M2, M3 with 400, 660 respectively 800 tons of die locking pressures.The aim of this thesis is to answer the following questions:What is the ?right? cast quality? How is the right quality achieved?For sizes 160-180 solutions will be proposed that consider eccentricity between thelaminate and the short circuit ring as well as elimination of the thin Al film that appearson the outer periphery of the rotors.Through considering the statistic material the most often diverging rotor type has beenidentified and one of the actual rotors has been sent to a laboratory to be analyzed inorder to establish the current defects. The result of the analysis shows that there areplenty of gas- and oxide-Porosity.It has been proved that every time the dies temperature decreased below 120°C thecontent of gas Porosity increased. It is due to rapid solidification of metal that flowsthrough the ?cold? laminate.It has confirmed that enhanced Porosity in squirrel cage causes high impedance in therotors.

This paper deals with prehistoric charred organic material, interpreted as bread, found in graves and in the underlying settlement at Kalvshälla, Järfälla parish in Uppland. The aim was to categorize the organic material morphologically and with the help of Fourier transformed Infrared spectroscopy (FT-IR) to see whether it was bread or not. Material from 13 graves (dated to Late Roman Iron Age until Viking Age) and 3 finds from the settlement have been analysed. Differences were noted both in shape, Porosity and structure. Some of the material has been interpreted as cereal based foodstuff instead of bread due to morphological discrepancies.

The aim of this study is to provide a comprehensive overview of C?ronis beeswax varnish by Lefranc & Bourgeois; its contents, aging properties, solubility, and possible removal methods, with G?teborgs Konstmuseum?s ?Gothenburg Museum of Art? collection as the stud??s material? The purpose of the study is to provide a basis for decision-making regarding the treatment of works treated with C?ronis wax varnish. The study is based on contemporary conservation theory and interpretation-based decision-making and utilizes FTIR, microscopy, and solubility tests to examine the properties of the varnish. The study shows that C?ronis does not appear to be harmful to the treated works and has retained its solubility properties and transparency over time.

Svenska Aerogel AB has developed the material Quartzene® which is of the typeprecipitated silica and contains calcium - magnesium silicate ((Ca, Mg) SiO3). Thematerial is used for molecular filtration of contaminated air. Qartzene?, which is inpellet form, is porous and has a high internal surface which is a requirement for themolecular filtration. With the use of various impregnations, filtration can affect thedesired outcome.

Svenska Aerogel AB has developed the material Quartzene® which is of the typeprecipitated silica and contains calcium - magnesium silicate ((Ca, Mg) SiO3). Thematerial is used for molecular filtration of contaminated air. Qartzene?, which is inpellet form, is porous and has a high internal surface which is a requirement for themolecular filtration. With the use of various impregnations, filtration can affect thedesired outcome.

Chapter 1 defines the aim of the project and gives a general orientation about ground heat extractors. In chapter 2 physical processes that could be expected to be involved in the heat transport around a ground heat exchanger are discussed. It is shown from a literature study what amount of moisture transport due to thermal gradients there could be expected in a ground heat exchanger. The conclusion is drawn that the moisture gradient (Sr) is of same magnitude as the driving temperature gradient (°C). At the expected amount of increased moisture around the pipes the moisture transport could be considered to have a little effect on the brine temperature.

Soil properties affect the chemical composition of soil water. When studying transport of chemical substances through a basin, it is therefore important to know from which soil layer the main part of the runoff is generated. The aim of this study is to develop an HBV/PULSE model with merged soil moisture and response routines, which generates good approximations of groundwater levels. It should be possible to extend the model to simulate transport of substances and take into account which soil layer the groundwater level is currently in. The hydrological version of HBV/PULSE is used since there is no need to account for pH or alcalinity at this stage.

Forest streams and the associated riparian zones are sensitive to disturbances and changes that occur within these riparian areas. Particularly sensitive are small streams of low order, which will have large impacts down-stream. The disturbances that occur in the riparian zones are reflected quickly in the stream. Driving with forestry machines in the riparian zone will have detrimental effects to the soil and water. Driving the machines will lead to changes in the mineral soil composition, resulting in the reduction of Porosity, less infiltration, compaction, and an increased bulk density.

AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.

AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.

Beef cattle wintering outdoors should be provided a shelter, e.g. a type of barn or corresponding. This type of production requires appropriate soil types and secured animal welfare. For example, a clean and dry resting place needs to be provided to the animals. To receive an exemption for buildings the farmer has to have something equivalent that provides an adequate shelter.