Many traffic incidents are due to the driver?s lack of attention, resulting in dangerous lane departures, either sliding off theroad or into the oppose lane. These kinds of incidents often have serious outcomes, which has led to much effort being concentrated on preventing or lessening the damages when the incident is already a fact, for example by installing safety belts and air bags. These measures may be considered to be acts of so-called passive safety. Active safety on the other hand, means that the safety systems intervene before the incidents have occurred.

Essingeleden in Stockholm is the most heavily congested road segment in Scandinavia and it is ofgreat importance for as well traffic within the city as for transit traffic. The capacity of Essingeledenand Norra Länken is not enough to accommodate all traffic. At times it is not moving at all, whichresults in long queues and an augmented risk of accidents. Consequently measures for increasing thecapacity on E4/E20, which will reduce congestion and the risk of accidents, are implemented byTrafikverket. In fall 2012 one lane of three at Pampas will be closed and so will the exit fromEssingeleden to Norra Stationsgatan, called Parkeringsbron.

When protection zones for wells are delineated, it is important to acquire good knowledge about possible travel time from different points in the catchment area to the well. Often, simple analytical methods are used for estimating travel times and the assumption is made that the hydraulic conductivity is relatively homogenous within the aquifer. Nevertheless, many aquifers are strongly heterogeneous which may lead to differences between estimates and actual travel times. As a part of the process to develop improved methods for delineating protection zones for groundwater supply wells, a tracer experiment was performed in a glaciofluvial esker formation in Järlåsa. On the basis of the experiment, a numerical flow model was created for the test site.The purpose of this master?s thesis was to apply the flow model to an aquifer where the hydraulic conductivity shows great variability and should be described by a stochastic distribution.

Åmotfors Bruk AB (ÅBAB) has today an inefficient production of steam for the manufacturing of paper. Unpredictable energy prices and modernisation of the current equipment has been the underlying factors to invest in a thermal power plant, mainly driven by garbage. This facility will not only use the steam for paper production, it will also generate electricity through a steam turbine. Today, when a fault on the supplying line occurs which leads to disconnection of the external grid, all the support of electricity to Åmotfors Bruk (ÅB) will disappear. This will lead to major interruptions in the paper production, which will cause severe economical losses.

This examination work is performed at the institution of industrial economy and production at Jonkoping technical university, for JELD-WEN Door Solutions plant in Forserum.Today the focus in the company is on to reduce their inventories binding of capitals as well as inventory of products and that includes to get a good control of the supply and handling of material which is of great importance.JELD-WEN Door Solutions is one of the worlds leading producers of windows and doors and the head-office is located in Oregon, USA.A great number of wooden doors are manufactured by the company in varying of constructions, classifications and performance.The production of the plant in Forserum has a project- and customer focus manufacturing where only internal doors are produced. The overall market they are concentrated on is to different institution such as schools, hospitals etc.The purpose of this work is to investigate possibilities to improvement of material- and production control at JELD-WEN. The report will handle the master production schedule to and from the production divisions within manufacturing industry. Focus will be on the way for information- and material flows from arrival, transport within the company and further on to customers.Further a map of the flow was performed which gave a clearer picture of the connection between the flow of information- and material for the manufacturing process. On the basis of the mapping of the flow, the group discovered that the flow of material had some improvement potential.

Gunsta is situated about 10 km east of Uppsala. Today there are plans to establish 1000 new households in Gunsta before year 2030. The required energy for heating houses and water would be distributed via a district heating system, which also includes 200 existing residences. The annual required energy, according to this study, would be 16.2 GWh with a maximal peak effect of 6.9 MW. To meet this need, the study suggests a system with heat pumps to upgrade the 31?C water from a 1.8 kilometre deep borehole.

The purpose of the project has been to work out recommendations that reduce the energy-related costs and environmental impact of HPW Fresh & Dry Ltd., a fruit drying factory in Ghana. The factory produces electricity with diesel and biogas but also purchases electricity from the national electricity company. Heat for the drying process is produced from biogas, kerosene and solar panels. In the project the energy system was analyzed by measuring production and consumption of heat and electricity. The project results show that the factory can become self-sufficient on heat if the available energy is used more efficient. The production units for both electricity and heat have low efficiencies.

Today cultivation of cereal in Sweden has high costs for establishment in relation to the rest of the world, and if this cultivation will be able to continue, the farmers have to control their costs. It is important to see all costs, not the maximum harvest achieved, but the net result. All farmers have different conditions with respect to soil, direction of the farm and were the farm is located geographically. With the right knowledge and ambitions, we think most farmers could change to reduced tillage. In this paper we have tried to find out if reduced tillage is an alternative for farmers.

Through previous studies during my education, I have experienced that chemical deicing road salt is a known problem, mainly in southern Sweden. Road salt causes damage to the environment and also damage to vehicles and structures such as bridges, etc. Road salt causes vehicles and steel constructions to rust, leading to increased costs for repairs of damage to structures. Road salt also causes damage to the plants and the economy to suffer, when plant material and soil needs to be replaced. In order to get closer to a solution, I put up three questions.

This study was made as a part of a feasibility study on a polishing wetland at Rimbo wastewater plant (wwp) in Norrtälje municipality. The wwp had to decrease the nitrogen discharge to reach the limit 15 mg tot-N/l. The nitrogen in the outlet was mainly in the form of nitrate, hence the wetland mainly ought to support denitrification. The proposed area for the wetland was situated right next to the wwp and was already in the municipalitys posession. One aim of this study was to examine what spieces of plants needed to achieve highest possible denitrification.

Landfill leachate contains a variety of contaminants and is created when rainwater percolates the landfill. For landfill management the leachate is the main issue that can cause problems to the environment. At the landfill of Fläskebo, Renova AB treats the leachate in a local treatment plant. The treatment consists of a chemical treatment step with chemical precipitation, flocculation, sedimentation and filtration, and a final step with a carbon and peat filter. Renova has to ensure that the condition of the leachate reaches the regulation set for the landfill before it is released to the recipient.

Coastal sediments are important carbon sinks, storing organic matter and thereby helping to reduce the amount of greenhouse gases in the atmosphere. However, they can also act as carbon sources if the deposited organic matter decomposes rapidly, contributing to increased greenhouse gas emissions and global warming. Rapid decomposition partly depends on the degradability of the material itself. In this literature review, I examine which coastal plant species dominate different locations along the Swedish coast, based on coverage data from the ClimScape project (www.climscape.se). For the most dominant species, I investigated the type of organic matter they may contribute to the sediments and based on those results I qualitatively assessed which sites that may function as carbon sinks or sources.

The purpose of this thesis has been to assess whether leaching from one particular Swedishlandfill site, Skörbytippen, is contributing to elevated levels of heavy metals in a ditch runningfrom the landfill site to the lake Mälaren in the communal region of Håbo kommun. Since theditch is stretching approximately five km downstream from the landfill site, in situ observationsand maps with known points of inflow was utilized to determine appropriate test points for thecollection of samples.Soil, water and sediment samples were collected and analyzed for content of organic material, pHand conductivity. Data on plant-available elements and total amounts of heavy metals wasacquired through ICP-analysis.The results show that the Skörby landfill is currently in the methane-forming anaerobedevelopment phase, which indicates that the concentration of free and complex-bound metals inthe leachate water should be low due to chemical binding with other landfill compounds. The pHof the sediment samples was generally one unit higher than the soil samples and some of themeasured data, such as pH and conductivity, show that an environmentally disturbing dischargeof some kind of strongly alkaline chemical(s) has been made from Benders? takpanneindustri inclose proximity to the landfill.

Our purpose in this paper is to examine if there is any profitability for a company with a factory in the timber industry to invest in a combined heat and power, CHP. Based on analysis and the results that the paper generates, we will give Derome AB a suggestion on how it is a profitable investment or not to installing in a CHP.By investing in a CHP plant, you can get a high efficiency, which means that companies can use their resources more effectively. The Swedish wood industry has by-products of production that can be used for combustion in their boiler which is an advantage.The essay is a qualitative study where we have a case company, Derome AB. In this company, we interviewed two employees who have knowledge in the study. They have helped us to provide information and data about their business.We chose to use the pay-off- and the net present value method, NPV, to see if there are profitable advantages for the investment.

There are around 855 000 on-site sewage systems in Sweden and some 1 800 of these are located in the municipality of Sigtuna. The Sigtuna local authority has set the goal that all sewage systems with insufficient function should be improved before the end of year 2010. A malfunctioning on-site sewage system may cause three main problems: spreading of diseases, discharge of eutrophicating compounds and wastage of resources. The municipality strives to reduce these problems already at the stage of granting permits for installation of on site sanitation systems. The municipality has recently adopted new guidelines, which demands certain minimum reductions for different compounds. The guidelines also state that it is preferred that neighboring house-owners cooperate in jointly built and operated sewage systems and that the system should be able to recycle plant nutrients.