Sök:

Sökresultat:

50 Uppsatser om Oxide - Sida 2 av 4

Elektrolytisk reduktion av zink vid reningsprocess

When cylinders for motor saws are manufactured there are high demands on the cylinders strength and wearing qualities. Aluminum is a material with low density and is used by Husqvarna AB for their motor saw cylinders. The aluminum is strengthening with nickel that is attached to the cylinders through electrolysis. When aluminum is in contact with oxygen a film of Oxide is formed. To eliminate the Oxide and to prevent formation of new Oxide zinc is used.

Grundvattensänkning till följd av järnvägstunnel genom Hallandsås : miljökonsekvenser relaterade till förändrad kväveomsättning i mark

This thesis was carried out to give some background information to a report of SLU (Swedish University of Agricultural Sciences) for the Swedish National Rail Administration (Banverket). The requested information was to provide basic data for an environmental impact assessment of the construction of the tunnel through Hallandsås. The aim with the thesis work was to discuss and quantify the leaching of nitrate and the emission of nitrous Oxide from the soil at the groundwater level established through the tunnel project. The nitrogen related processes that could be affected were described and discussed. The different areas where a decreased groundwater level can cause changes in the nitrogen processes are the wet and moist areas.

Uppgradering av biogas med aska från trädbränslen

The Swedish production of biogas was 1,5 TWh 2011. About half of the production was used as vehicle fuels. The cost for upgrading biogas depends on the size of the biogas plant and its gas production. If the gas flow is low the cost will be high. However, further development of existing upgrading technologies or development of new ones, have good potential to decrease the upgrading cost for small scale biogas plants.

Syntes och egenskapskarakterisering av volframoxid framställd med magnetronsputtring

The system tungsten-oxygen has potential of being suitable for decorative coatings since ceramic coatings are often hard and wear resistant, and since modulations in oxygen content or incorporation of small ions could give bright colours. The aim of this report was to investigate the relationship between process parameters and  the properties of the films, with the wear resistance being of special interest.Samples with tungsten to oxygen ratios in the range of 100:0 to 25:75 at% were made using reactive sputter deposition, either with constant gas flow, or gas flow controlled by optical emission of the plasma. The hysteresis of the system, which means that a certain gas flow will cause different pressure and/or target voltage depending on in what way the flow is reached, makes it interesting to control the process where the system makes the steep change from metallic tungsten to ceramic tungsten Oxide. This is difficult and thus requires precise control equipment.The samples were analysed using X-ray diffraction, X-ray photoelectron spectroscopy and an empirical wear test suitable for small components like cell phone cover for example, in order to characterize the structure, composition and wear resistance of the coatings. The results could be divided into three groups: (I) tungsten-like, with very low oxygen content; (II) mixed phase and (III) tungsten Oxide like, with oxygen content close to 75 at%.

En jämförelse av RDF och avfall som förbränningsbränsle

In the EU the amount of waste increased by 14 percent during the years 2000 to 2010. EU?s target to reduce waste generation runs parallel with the aim of increasing the efficiency and profitability aligned with energy recovery. In Sweden the energy recovery through incineration is increasing steadily, and 46 percent of the municipal solid waste (MSW) is treated by combustion. This report aims to examine the profitability of processing MSW into Refuse Derived Fuel (RDF) from an economic-, energy- and environmental perspective.

Historiska emissioner av bly och arsenik till luft från Åfors Glasbruk och deras konsekvenser för miljön.

Åfors glasswork was a company which started in 1876 and closed in 2012 due to the bad economical situation in the company. After its closure, the glasswork left behind contaminated soil with different concentrations of heavy metals such as, arsenic from arsenic triOxide, a chemical used to remove bubbles during the melting of glass, and lead Oxide, a chemical used in the production of crystal glass. Crystal glass?s production occurred under 1921-1971, but emissions of lead into the air from Åfors glasswork continued until 2011, because of the artist Bertil Valliens? artglas was made in Åfors glasswork from 1970?s and onwards.The aim of this study was to estimate how much lead (Pb) and arsenic (As) that were released by Åfors Glasswork into the atmosphere during the operational period of the glasswork in comparison with how much of lead and arsenic were purchased for the company. Added to the assistance of the data from National Archives the variations in the activities of Åfors glasswork could be shown.

Stubblyftningens initiala effekt på emissioner av växthusgaser från en granmark i Småland :

In order to reduce greenhouse gas emissions from human activities fossil fuels will have to be replaced with renewable energy alternatives, such as bioenergy. Sweden has a great potential to produce bioenergy derived from forest products and there is currently a great interest within Sweden in using stumps for bioenergy production. However, the environmental consequences of the method need to be investigated before stump removal can be performed on a large scale. Swedish forest soils contain large carbon pools and a different land use may change conditions so that soils that presently act as sinks of carbon could potentially turn into sources of carbon release instead. This study investigates the initial effects of stump harvesting on the emissions of three greenhouse gases, carbon diOxide, methane and nitrous Oxide. The emissions were measured from the soil surface in a Norway spruce forest located in the southern part of Sweden.

Optisk karakterisering av tunna SiO2/NiO-filmer syntetiserade med en sol-gelmetod

In an attempt to develop a more cost-efficient material for solar   energy applications, nano-particles of nickel Oxide composite in a silikatmatris manufactured with solar gelmethod and studied structurally by electron microscopy. Furthermore, the thin film optical properties characterized by Variable. Angel Spectroscopic Ellipsometry. Sol gelfilms suitability as a selective absorber surface is also analyzed by optical modeling..

Kalciums och magnesiums inverkan på arsenikavdrivningen i virvelbäddsugnen : The influence of calcium and magnesium on the expellation of arsenic in the fluidized bed furnace

In the fluidized bed furnace at Rönnskärsverken, Skelleftehamn, sulphur-containing ore concentrates are roasted in order to remove about 50% of the sulphur in the incoming ore concentrate. This occurs in order to reach the goal of a matte containing 55% of copper in the following smelting process. At the same time as the ore concentrate is partially roasted pollutions as arsenic, antimony and bismuth are expelled. Earlier made thermodynamic calculations of equilibrium suggested that calcium and magnesium form stable compounds with arsenic and thereby inhibit expellation of arsenic in the fluidized bed furnace, an element that is undesired. The purpose of this thesis work was to gain knowledge of the mechanisms behind the formation of these stable arsenic compounds.

Modellering och reglering av ureainsprutning på kraftvärmeverket FTG

The aim of this thesis is to improve the control of urea injection at the combined power and heating plant Framtidens Gärstad (FTG). Tekniska Verken i Linköping AB is the owner of the plant.The FTG plant consists of a boiler where garbage combustion is done. From the combustion nitrogen Oxides are emitted. These nitrogen Oxides are hazardous to the environment. To reduce the nitrogen Oxides, injection of urea into the boiler is used.

Kväveförluster och energianvändning på mjölkgårdar i västra Sverige :

Protecting the environment has with time grown to take a more central role in the society. Agriculture plays an important role in the society since this sector produces our food. More thorough research on how agriculture affects the environment is therefore motivated. This research can be used to improve the agricultural practice from an environmental point of view. This is something that both the farmers and the consumers can profit from. This study aims to form the basis for creating environmental indicators for use of nitrogen and energy on dairy farms. Twenty-three farmers in western Sweden have been interviewed about their farms, both organic and conventional. They produce milk with different intensity, defined as the amount of milk delivered (sold) per hectare of arable land.

Böklåda med torv på rastgårdsytan i ekologisk slaktsvinsproduktion : effekter på beteende och emission av kväve (NH3 och N2O)

In organic animal production, synthetic amino acids are not allowed. Therefore, a higher level of crude protein is needed in the diet to pigs, which lead to more nitrogen (N) excreted in the faeces and urine. N can be emitted to the air in the form of e.g. ammonia (NH3), which contributes to eutrophication and acidification and as nitrous Oxide (N2O), which is a very potent greenhouse gas. The emission of N can be reduced by e.g.

Kemiskt försvar mot havstulpanskolonisering i marina svampdjur

The purpose of this project is to analyze and study the absorption of the substances ivermectin, spinosad and barettin to hydrophobic and hydrophilic surfaces, and to analyze and study if the barnacle larva are effected when they try to settle on the treated surface.Incubation tests with barnacle larva in Petri dishes were performed as well as absorption tests on hydrophobic and hydrophilic surfaces which were tested with ellipsometry. To determine the surface thickness.The barnacles were placed in hydrophobic as well as hydrophilic Petri dishes that had been incubated with ivermectin, spinosad or barettin. After four to six days the larva was counted to analyze the settling. From the results conclusions could be drawn about the adsorption abilities of the substances to the different surfaces.The barnacles were placed in hydrophobic as well as hydrophilic Petri dishes that had been incubated with ivermectin, spinosad or barettin. After four to six days the larva was counted to analyze the settling.

Magnesium chloride in dry cow silage to prevent hypocalcaemia

Milk fever, or parturient paresis, is the second most common disease in Swedish dairy cows. The disorder is associated with the onset of lactation when some cows are unable to meet the metabolic demands of calcium to support milk production and therefore develop a state of hypocalcaemia. Clinical hypocalcaemia (milk fever) may lead to coma and death in severe cases but subclinical hypocalcaemia has also been shown to have negative effects on e.g. feed intake and production and to increase the susceptibility of the cow to develop secondary diseases. The nutritional strategy applied precalving is of great importance in preventing milk fever and e.g.

Naturlig förekomst av arsenik och avskiljning av arsenik från grundvatten : test av olika filtertekniker avsedda för enskilda brunnar

During the last few years the presence of high arsenic (As) concentrations in ground water has been of major concern both internationally and in Sweden. Much evidence has been reported about toxic effects caused by arsenic. The carcinogenic effects and the possibility to measure the toxic impacts at low concentrations made the World Health Organisation (WHO) to reduce the guideline value from 50 to 10 ?g l-1 in 1993. In Sweden the corresponding reduction was implemented in 2003. Several surveys in Sweden have shown that high arsenic concentrations may occur in ground water.

<- Föregående sida 2 Nästa sida ->